Jenn-Air UXT5230AD Series Bedienungsanleitung

RANGE HOOD

INSTALLATION

GUIDE

TABLE OF CONTENTS

Safety Instructions....................................................1

Mounting Heights....................................................2

Ducting..............................................................3-7-9

Specifications...........................................................4

Installation............................................................5-6

Model Number: UXT5230AD* UXT5430AD*

UXT5236AD* UXT5436AD*

Manufacturer Number: MK5500 MK5800

Size: 30” & 36” 30” & 36”

INSTALLATION GUIDE

Read all Instructions before Installing and operating this appliance

MODELS: UXT5230AD* UXT5236AD* UXT5430AD* UXT5436AD*

Installation

The installation in this manual is intended for qualified installers,service technicians or persons

with similar qualified background.DO NOT attempt to install this appliance yourself.Injury could

result from installing the unit due to lack of appropriate electrical and technical background.

All electrical wiring must be properly installed, insulated and grounded. Overly accumulated

grease in old duct work should be cleaned out or duct work should be replaced if necessary to

avoid the possibility of a grease fire. Check all joints on duct work to insure proper connection

and all joints should be properly taped.

* Please check for latest specification revisions before any custom work or cutouts.

IMPORTANT SAFETY NOTICE

WARNING

INSTALLATION 2

MOUNTING HEIGHTS

DUCTING

36"

96"

Min 24"-Max 32"

Minimum mounting height between range top

to hood bottom should be no less than 24".

Maximum mounting height should be no high-

er than 32".

It is important to install the hood at the

proper mounting height. Hoods mounted too

low could result in heat damage and fire

hazard; while hoods mounted too high will be

hard to reach and will lose performance and

efficiency.

If available, also refer to range manufacturer's

height clearance requirements and recom-

mended hood mounting height above range.

A minimum of 6” round or 3-1/4”x10” rectangular

duct must be used to maintain maximum air flow

efficiency.

Always use rigid-type metal ducts only.

Flexible ducts could restrict air flow by up to 50%.

Also use calculation (on right) to compute total

available duct run when using elbows, transitions

and caps.

ALWAYS, when possible, reduce the number of

transitions and turns. If long duct run is required,

increase duct size from 6” to 7 or 8”. If a reducer

is used, install a long reducer instead of a pancake

reducer. Reduce duct size as far away from open-

ing as possible.

If turns or transitions are required:

Install as far away from opening and as far

apart, between 2, as possible.

*Minimum clearance of 24”hood above range

height.

** Maximum clearance 32" hood above range

height.

Minimum Duct Size:

Round:

6” minimum

Rectangular:

3-1/4”x10”

Duct Run Calculation:

Maximum run

6” or 3-1/4” x 10” duct

Deduct:

each 90 Elbow used

each 45 elbow used

each 6” to 3/14 x 10”

transition used

each 3/14 x 10” to 6”

transition used

Side Wall Cap w/ damper

Roof Cap

100 FT

15 FT

9 FT

1 FT

5 FT

30 FT

e.g.- 1 roof cap, 2x90 elbows,1 45 elbow used:

=30' + 30' + 9' =69' used, 31' available for straight duct runs.

INSTALLATION 3

DUCTING

NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or

garages.All exhaust must be ducted to the outside.

Use Metal ductwork only.

Fasten all connections with sheet metal screws and tape all joints w/ certified Silver Tape or DuctTape.

Some Ducting Options:

side wall cap

w/ gravity damper

side wall cap

w/ gravity damper

Soffit or crawl space

Roof Pitch w/

Flashing & Cap

WARNING FIRE HAZARD

INSTALLATION 4

SPECIFICATIONS

3 1/4"

10"

30" or 36"

73/4"

30" or 36"

155/8"

101/4"

1 3/4" 1"

22 1/4"

4 1/4" C/L

C/L

1/2" Elec. K.O.

INSTALLATION 5

MOUNTING THE RANGEHOOD

ELECTRICAL

All Electrical work must by performed by qualified electrician or person with similar technical

know how and background.

For personal safety, remove house fuse or open circuit breaker before beginning installation.

Do not use extension cord or adapter plug with this appliance.

Follow National electrical codes or prevailing local codes and ordinances.

Electrical Supply:

This appliance requires a 120V 60Hz electrical supply, connected to an individual, properly grounded

branch circuit, protected by a 15 or 20 ampere circuit breaker or time delay fuse.Wiring must be 2

wire w/ ground. Please also refer Electrical Diagram labeled on product.

Cable Lock:

A cable locking connector (not supplied) might also required by local codes. Check with local

requirements and codes, purchase and install appropriate connector if necessary.

Cable Lock

WARNING

INSTALLATION 6

MOUNTING THE RANGEHOOD

1. This range hood is mounted under a

kitchen cabinet unit.

2. Select preferred duct location on rear or

top of unit. For ductless conversion, no

ducting is required.

3. Begin installation by temporarily removing

the diffuser and filter panels.

4. Temporarily position the range hood in

the desired mounting location.

Measure and mark the mounting holes,

duct and electrical access locations with

a pencil.

5. Drill/cut out the required openings for

duct and electrical access; make sure the

duct opening is large enough to apply

duct tape.

6. Fasten mounting screws onto

cabinet as marked, do not tighten,

leaving half length of screws exposed.

7. Install electrical.

8. Hang hood onto screws through key

holes, and tighten.

9. Install duct work and duct-tape.

10. Reinstall the difuser panels.

11. Power up hood and check for leaks

around duct-tape.

duct/silver

tape

INSTALLATION 7

CONVERTIBLE OPTIONS

This range hood is equipped with the option of a 6” vertical discharge, 3 1/4”x10”vertical discharge,

or 3 1/4”x10” rear discharge.Additional accessories are provided to convert to either of the above

discharge methods.

Convertible Options

Vertical discharge 6” round

Vertical discharge 3 1/4”x10”

Horizontal rear discharge 3 1/4”x10”

Convertible Accesories

Round to rectangular transition adaptor

Rectangular to round transition adaptor

Gasket (pre-mounted)

Rectangular rear cap (pre-mounted)

3 1/4”x10” starting collar

3 1/4”x10” Vertical Discharge

1. Remove pre-mounted 6” transition adaptor or duct

opening. Leave attached gasket in its original place.

3. Mount the 3-1/4”x10” starting collar on top of

transition piece with remaining screws.

2. Place rectangular transition adaptor as shown over

gasket and by first installing 4 screws on half round

section.

(pre-mounted)

INSTALLATION 8

CONVERTIBLE OPTIONS

3 1/4”x10” Rear Discharge

1.At rear of range hood, remove all screws on pre-

mounted rear rectangular cap and remove cap.

5. Mount starting collar (provided) at rear discharge

opening with gasket.

4. Mount rectangular cap (previously removed) on top

of transition adaptor.

3. Mount rectangular transition piece at opening with

gasket as shown.

2. Remove top pre-mounted transition piece. Leave

attached gasket in its original place.

INSTALLATION 9

DUCTLESS CONVERSION

Ductless conversion is intended for applications where an exhaust duct work is not possible to be

installed.When converted, the hood functions as a "purifying" hood rather than an exhaust hood.

Fumes and exhaust from cooking are drawn and filtered by a set of optional Carbon Filters.The air

is then purified and re-circulated back within the home.

We recommend toALWAYS exhaust air outside of the home by employing existing or installing

new duct work, if possible.The hood is most effective and efficient as an Exhaust unit. Only when

the exhaust option is not possible should you recourse to converting the hood into a "purifying"unit.

When converted to be a "purifying" unit, a Carbon Filters Kit is required. Order according to its Part

number below.The standard Metal Filters are intended to capture residue from cooking and the

optional Carbon Filters help to purify fumes exhausted from cooking for re-circulation.

Carbon Filters (Required)

1. Purchase ductless Carbon Filters Kit as follow:

2.The ductless conversion housing must be

installed prior to installation of the range

hood.

3. Remove the diffuser panels on the hood.

4. Clip carbon filter onto bracket of

diffuser panels.

5. Re-install diffuser panels.

6. Carbon Filters must be replaced after

every 120 hours of use (or approximately

every 2 to 3 months based on the average

of 1-2hrs. of daily cooking time).

7. Refer installation manual provided with

ductless carbon filters kit.

Hood Model: Part No. Filters in pkg.

UXT5230AD* HCFLTUXT30 2

UXT5236AD* HCFLTUXT36 3

UXT5430AD* HCFLTUXT30 2

UXT5436AD* HCFLTUXT36 3

Andere Handbücher für UXT5230AD Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Jenn-Air Dunstabzugshaube Handbücher

Jenn-Air

Jenn-Air JXT5830 Bedienungsanleitung

Jenn-Air

Jenn-Air JXI8936DS Produktinformationsblatt

Jenn-Air

Jenn-Air JXT8042ADS Bedienungsanleitung

Jenn-Air

Jenn-Air JXT5830 Bedienungsanleitung

Jenn-Air

Jenn-Air JXT9030CDP Bedienungsanleitung

Jenn-Air

Jenn-Air JXT8136ADS Bedienungsanleitung

Jenn-Air

Jenn-Air JXT5830ADB Montageanleitung

Jenn-Air

Jenn-Air JXW5036WS Produktinformationsblatt

Jenn-Air

Jenn-Air JVR0430HS Produktinformationsblatt

Jenn-Air

Jenn-Air JXT5836 Bedienungsanleitung

Jenn-Air

Jenn-Air 30" WALL-MOUNT CANOPY RANGE HOOD Produktinformationsblatt

Jenn-Air

Jenn-Air JXT7036ADS Bedienungsanleitung

Jenn-Air

Jenn-Air JXT9030BDP Installationsanleitung

Jenn-Air

Jenn-Air JXT9136CDP Bedienungsanleitung

Jenn-Air

Jenn-Air JXI8036WS Produktinformationsblatt

Jenn-Air

Jenn-Air JXW8230WS Produktinformationsblatt

Jenn-Air

Jenn-Air LI3UNC/W10274316C Produktinformationsblatt

Jenn-Air

Jenn-Air 36" Montageanleitung

Jenn-Air

Jenn-Air 30" RETRACTABLE DOWNDRAFT VENT SYSTEM Produktinformationsblatt

Jenn-Air

Jenn-Air JXT8836ADS Bedienungsanleitung

Jenn-Air

Jenn-Air JXDR7301VS0 Produktinformationsblatt

Jenn-Air

Jenn-Air JXT9036CDP Bedienungsanleitung

Jenn-Air

Jenn-Air UXT5230AD Series Bedienungsanleitung

Jenn-Air

Jenn-Air JXT9030CDP Bedienungsanleitung

Beliebte Dunstabzugshaube Handbücher anderer Marken

emmeti

emmeti RECUPA MED A-140 Leitfaden

Nibe

Nibe F135 Bedienungsanleitung

Zephyr

Zephyr Spruce AK9834BS Installationsanleitung

Kuppersberg

Kuppersberg INTRO 60 Montage- und Wartungsanleitung

Hisense

Hisense MH6INBG Bedienungsanleitung

Miele

Miele DA 1255 Bedienungsanleitung

Broan

Broan 46000 Bedienungsanleitung

GE Profile PV977 Originalbetriebsanleitung

FALMEC

FALMEC FFRIA24W5FS Bedienungsanleitung

Whirlpool

Whirlpool RH2600XL-1 SERIES Bedienungsanleitung

ETNA

ETNA AV360RVS Bedienungsanleitung

JUNO

JUNO JDF603E6 Bedienungsanleitung

Miele

Miele DA 6708 D Bedienungsanleitung

Tricity Bendix

Tricity Bendix LE 150 Handbuch

AEG

AEG X68163BV1 Bedienungsanleitung

AEG

AEG 125 D Bedienungsanleitung

Smeg

Smeg KSEV97X Bedienungsanleitung

Nibe

Nibe S Series Benutzerhandbuch