Jensen VM9414 Bedienungsanleitung

VM9414

VM9414 Head Unit

Single DIN Sleeve

Wiring Harness

Parking Brake Sensor Extension Wire

Mounting Hardware

Cosmetic Trim Ring

Remote Control with Battery

3.5mm to 3.5mm Media Adaptor Cable

Owners Manual

Installation Guide

What’s in the Box

You will need these tools and supplies to install your VM9414:

• Torx type, ﬂat-head and Philips screwdrivers

• Wire cutters and strippers

• Tools to remove existing radio (screwdriver, socket wrench set or other tools)

• Electrical tape

• Crimping tool

• Volt meter/test light

• Crimp connections

• 18 gauge wire for power connections

• 16 – 18 gauge speaker wire

Tools and Supplies

Installation Guide

WARNING! Never install this unit where operation and viewing could interfere with safe driving

conditions.

TAB

DASHBOARD

TAB

Optional Equipment

• BTM10: Allows you to connect to a Bluetooth enabled cell phone or other device.

• Rear Camera

Disconnecting the Battery

To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to in-

stallation.

NOTE: If the VM9414 is to be installed in a car equipped with an on-board drive or navigation computer, do

not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these

conditions, use extra caution during installation to avoid causing a short circuit.

Pre-installation

Remove the four screws that attach the mounting sleeve to the

radio and remove the sleeve.

Install the mounting sleeve.

a. Install mounting sleeve into the dashboard or optional

adapter. Do not force the sleeve into the opening or cause

it to bend or bow.

b. Locate the series of bend-tabs along the top, bottom and

sides of the mounting sleeve. With the sleeve fully insert-

ed into the dashboard opening, bend as many of the tabs

outward as necessary so that the sleeve is ﬁrmly secured

to the dashboard.

c. Install support strap to make the unit more stable.

Place the radio in front of the dashboard opening so the wiring

can be brought through the mounting sleeve.

CAUTION! Be careful not to damage the car wiring.

PressAudio

VM9414

Enter

MUTE NAV

SEL

VOL

AVIN

REP

LOC LOUD

Enter

SEL

AV IN

Wiring

WARNING! Only connect the unit to a 12-volt power supply with proper grounding.

Complete wiring as illustrated in the wiring diagram on page 4. Once the wiring is complete, reconnect the bat-

tery negative terminal. If there is no ACC available, connect the ACC lead to the power supply with a switch.

NOTE: When replacing a fuse, be sure to use correct type and amperage to avoid damaging the radio. The

VM9414 uses one 15 amp fuse, located in the black ﬁlter box in-line with the main wire harness.

Final Installation

After completing the wiring connections, turn the unit on to conﬁrm operation (ignition switch must be on). If

unit does not operate, recheck all wiring until problem is corrected. Once proper operation is achieved, turn off

the ignition switch and proceed with ﬁnal mounting of the chassis.

Connect wiring adapter to existing wiring harness.

Connect antenna lead.

Carefully slide the radio into the mounting sleeve, making

sure it is right-side-up, and secure with the original 4 screws.

Attach one end of the perforated support strap (supplied) to

the screw stud, which is screwed into the threaded insert on

the back of the unit, using the hex nut provided. Fasten the

other end of the perforated strap to a secure part of the

dashboard either above or below the radio using the screw

and hex nut provided. Bend the strap to position it as

necessary.

Replace any items you removed from the dashboard.

ISO-DIN Installation

Remove mounting sleeve brackets.

Remove trim ring.

Mount factory brackets on new radio using existing screws

from old radio.

Slide radio chassis into dash opening and secure.

Re-install dash panel.

CAUTION! The rear of the radio must be

supported with the strap to prevent dam-

age to the dashboard from the weight of

the radio or improper operation due to

vibration.

NOTE: For proper operation of the CD/

DVD player, the chassis must be mounted

within 20° of horizontal. Make sure the unit

is mounted within this limitation.

Remove Mounting

Sleeve Brackets

PressAudio

VM9414

Enter

MUTE NAV

SEL

VOL

AV IN

Harness Cord

Auto antenna control (connect to antenna

control lead & power supply of antenna

amplifier)

External power amplifier control

BLUE

WHITE/BLACK -

GREEN/BLACK -

WHITE +

GREEN +

PURPLE +

PURPLE/BLACK -

GREY/BLACK -

GREY +

Mute (leave open if not connected) BROWN

ORANGE

FRONT L

FRONT R

REAR R

REAR L

MUTE

ILLUM

P. ANT

Antenna

CAMERA

AUX IN/L

AUX IN/R

NOTE: Steering Wheel Control (SWC)

Requires PAC SWI-PS Interface

Adapter, Sold Separately

Bluetooth Connector

(Connect to optional BTM10)

Car

External

Power Amplifier

Car

Phone

BLUE/WHITE

P.CONT

ACC

GREEN/WHITE

BLACK

YELLOW

RED

PINK

FUSE (15A) Battery

Ignition Switch

Ground

Gearbox

Switch

BATTERY

BATTERY +

Ground

GND

BATT

REVERSE +

ACC

REAR

MONITOR 1

AUX IN

VIDEO

SWC

REAR

MONITOR 2

MULTIZONE

RCH

MULTIZONE

LCH

MONITOR 1

MONITOR 2

PARKING

XM L

XM R

PARKING BRAKE

LINE OUT

FRONT R

LINE OUT

REAR R

LINE OUT

FRONT L

LINE OUT

REAR L

LINE OUT

SUBWOOFER

MediaLink

USB (included)

XM RADIO

USB BUS

Connect to optional XM

Satellite Radio Receiver

with Antenna

jLink USB iPod Interface Cable

(Sold Separately) - Required for iPod

Video Viewing through Head Unit

Additional Monitors

Sold Separately

Backup Camera

Sold Separately

GPS

Antenna

Wiring Diagram

IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, or

have the installation handled by an experienced technician.

For basic iPod connectivity, you can use the white 30-pin to USB iPod cable that came with your Apple device.

For iPod video playback, you must purchase the jLink-USB cable. Connect the iPod cable to the MediaLink

USB and route the MediaLink USB to an accessible part of the dash area for easy connectivity. For occasional

iPod use, keep an iPod cable in your glove box and use it to connect the iPod to the front USB connector.

Need Help?

For technical assis-

tance, call the Jensen

customer support line

at 1-800-323-4815.

Andere Handbücher für VM9414

Inhaltsverzeichnis

Andere Jensen Autoempfänger Handbücher

Jensen

Jensen CD3610XM Bedienungsanleitung

Jensen

Jensen VX7010 Bedienungsanleitung

Jensen

Jensen VM9214 Bedienungsanleitung

Jensen

Jensen MPX6411 - Radio / CD Bedienungsanleitung

Jensen

Jensen VM9125 Bedienungsanleitung

Jensen

Jensen VX3010 Bedienungsanleitung

Jensen

Jensen MS2A Bedienungsanleitung

Jensen

Jensen JWM452 Montageanleitung

Jensen

Jensen AM/FM RADIO WITH AUDIO CASSETTE PLAYER Bedienungsanleitung

Jensen

Jensen Phase Linear CD1213 Bedienungsanleitung

Jensen

Jensen VM9423 - Double DIN 6.5 Touchscreen Multimedia... Bedienungsanleitung

Jensen

Jensen MPX6411 - Radio / CD Bedienungsanleitung

Jensen

Jensen VM9213 - Touch Screen MultiMedia Receiver Bedienungsanleitung

Jensen

Jensen MP6212 - CD/MP3/WMA/Receiver Bedienungsanleitung

Jensen

Jensen VX3024 Datenblatt

Jensen

Jensen HR9000PKG Bedienungsanleitung

Jensen

Jensen CD6112 - CD Receiver Bedienungsanleitung

Jensen

Jensen VX3022 Datenblatt

Jensen

Jensen VM9126 Bedienungsanleitung

Jensen

Jensen VR209TPB Bedienungsanleitung

Jensen

Jensen CR1610 Bedienungsanleitung

Jensen

Jensen CD450K Montageanleitung

Jensen

Jensen VM9214R Bedienungsanleitung

Jensen

Jensen VM9213 - Touch Screen MultiMedia Receiver Bedienungsanleitung

Beliebte Autoempfänger Handbücher anderer Marken

Motorola

Motorola VWA63 Bedienungsanleitung

Nextar

Nextar D3201 Bedienungsanleitung

Alpine

Alpine CDE-163BT Bedienungsanleitung

Pioneer

Pioneer DEH-P645R Bedienungsanleitung

Axxera

Axxera XDMA7600 Betriebsanleitung

XM OnyX Bedienungsanleitung

Sound Storm

Sound Storm STM93R Bedienungsanleitung

Soundstream

Soundstream VIR-5000 Bedienungsanleitung

Avson

Avson MKT Platform Bedienungsanleitung

Sony

Sony MEX-1HD - Audio Library System Bedienungsanleitung

Pioneer

Pioneer DVH-P500UB Bedienungsanleitung

JVC

JVC KD-AHD69 Bedienungsanleitung

Blaupunkt

Blaupunkt SANTIAGO CR 87 Bedienungsanleitung

Sony

Sony CDX-4160 - Cd Receiver Bedienungsanleitung

XFIRE AUDIO

XFIRE AUDIO BMW42S Bedienungsanleitung

VDO

VDO CD 2253 Bedienungsanleitung

Volvo

Volvo 13 84 580 Bedienungsanleitung

ZENEC

ZENEC ZE-160DVD Bedienungsanleitung