3
SAFETY NOTES
Before Installation
The Gas Convector Box shall be installed only by authorised personnel in
accordance with the manufacturer’s installation instructions, local gas fitting
regulations, municipal building codes, electrical wiring regulations, and any other
statutory regulations.
Contact local building authorities about restrictions and installation inspections
that may be required. If in doubt contact your local dealer or Jetmaster’s head
office.
Important Safety Notes
• When installing the International Gas Convector Box for Zero Clearance
Installations and the Gas Burner, particular attention should be paid to fire
protection. If this Gas Convector Box is not properly installed a house fire may
result. To reduce the risk of fire, follow these installation instructions and the
Gas Burner installation instructions carefully.
• RISK OF FIRE! Do not burn materials inside this Gas Convector Box. This
is NOT a wood stove and has not been designed for this purpose. Burning
materials inside the Gas Convector Box can result in damage to the unit,
house fire and/or death.
• Comply with all minimum clearances to combustibles as shown in this manual
and in the Gas Burner installation instructions.
• Do not connect to any air distribution duct or system.
• Do not operate without fully assembling all components. Operating your
Gas Burner and Gas Convector Box without all the components properly
assembled will void your warranty and could present a serious safety hazard.
• An approved gas cowl with a minimum cross-section of 40,000 sq mm must
be fitted to the top of the flue or chimney.
• All open gas fires require fixed fresh air vents in the room. See page 5 for
ventilation requirements.
. . . continued next page
IMPORTANT - PLEASE NOTE
Failure of the gas fitter to install the appliance
as per manufacturer’s specifications and in line
with the Gas Code will void the warranty.
