Johnson Controls Tyco Kantech KT-400 Kurzanleitung

Application Note

Connecting an OSDP HID reader to a KT-400 controller

Use this application note to wire a HID reader using OSDP protocol to a KT-400 controller

and to configure the setup in EntraPass.

Requirements

•KT-400 Controller firmware 3.00.07 or higher

•EntraPass Special, Corporate, or Global Edition 8.40 or later

•HID Reader with OSDP communication

•HID Reader Manager mobile application

•Mobile device with Bluetooth

Note: Kantech have implemented Open Supervised Device Protocol (OSDP) 2.2. OSDP is

an access control communications standard developed by the Security Industry Association

(SIA). For more information about the protocol, refer to

https://www.securityindustry.org/industry-standards/open-supervised-device-protocol/.

Wiring the HID reader to the KT-400 controller

Use the RS-485 COM (COM2) port for OSDP communication.

1. Disconnect the power to the KT-400 controller.

2. Connect the reader’s red wire to the +12VDC.

3. Connect the reader’s black wire to the earth ground GND.

4. Connect the reader’s white wire to the COM 485 +.

5. Connect the reader’s green wire to the COM 485 -.

For more information about installing and wiring the KT-400 controller, refer to the KT-400

Four-Door Controller Installation Guide.

Configuring the card reader using the HID mobile app

Use the HID Reader Manager mobile application to set up the HID card reader.

1. Install the HID Reader Manager app on a device that has Bluetooth.

2. Open the app and tap Scan For Readers.

3. Tap the reader that you want to configure.

4. Tap Software and tap Configure.

5. Tap Inspect. Follow the instructions on the screen.

6. Tap Detailed Configuration and tap Communication Protocol.

7. Tap Host Protocol and enable OSDP.

8. In the ADDRESS field, enter an address. Addresses start at 0 in EntraPass. Refer to

your EntraPass system for the next available address.

9. Tap ADD TO TEMPLATE.

10. In the OSDP BAUD RATE field, enter the baud rate that you configured in

EntraPass.

Application Note D29011149R001

11. Click Apply Selected Items.

For more information about installing and using the mobile app, refer to the HID© Signo™

Reader Installation Guide and the HID© Reader Manager™ Solution User Guide.

Configuring the HID reader in EntraPass

1. On the EntraPass workstation, click the Devices tab, and click Controller.

2. From the Controller list, select the controller you have connected the HID reader to.

3. In the Controller window, click the KT-400 tab.

4. From the COM2 Protocol list, select OSDP. The RS-485 baud rate changes to 9600

and the Reader template changes to Default OSDP reader template. You can

update these items.

5. Complete one of the following options:

•To manually add readers, complete the following steps:

a. Click the OSDP tab.

b. Click Add and, in the Address column, select or type the OSDP reader

address. Accepted values range from 0 to 126.

c. In the Door column, select the door to associate with the reader.

d. Click Save.

Note: This is the recommended option.

•To add unassigned readers automatically, complete the following steps:

a. On the Controller window toolbar, click the Request unassigned modules

icon.

b. In the Request unassigned modules window, right-click the appropriate

reader and select Assign module.

c. Click Save.

Note: This feature works only for addresses 0 to 10 at the default baud rate of

9600.

For more information about setting up controllers and readers in EntraPass, refer to the

EntraPass Administration Guide.

trademarks of Johnson Controls.

Technical support contact telephone numbers: 1 450 444 2030. Toll free: 1 888 222 1560.

www.kantech.com

Andere Handbücher für Tyco Kantech KT-400

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Johnson Controls Controller Handbücher

Johnson Controls

Johnson Controls M9310 Series Bedienungsanleitung

Johnson Controls

Johnson Controls tyco iSTAR Edge G2 Bedienerhandbuch

Johnson Controls

Johnson Controls VA-7700 Series Bedienungsanleitung

Johnson Controls

Johnson Controls VA-9070 Series Service-Handbuch

Johnson Controls

Johnson Controls TEC3000 Series Bedienungsanleitung

Johnson Controls

Johnson Controls PENN ACT2 Service-Handbuch

Johnson Controls

Johnson Controls LN-IO -1 Series Bedienungsanleitung

Johnson Controls

Johnson Controls TEC3010 Bedienungsanleitung

Johnson Controls

Johnson Controls FX30E Service-Handbuch

Johnson Controls

Johnson Controls Penn A421 Series Bedienungsanleitung

Johnson Controls

Johnson Controls FX-PCA3611 Bedienungsanleitung

Johnson Controls

Johnson Controls NAE Bedienungsanleitung

Johnson Controls

Johnson Controls M9216 Series Bedienungsanleitung

Johnson Controls

Johnson Controls VMA1615 Bedienungsanleitung

Johnson Controls

Johnson Controls PEAK OEM 18 Bedienungsanleitung

Johnson Controls

Johnson Controls Metasys DX-9100 Service-Handbuch

Johnson Controls

Johnson Controls TRUE RH HC-67x3 Bedienungsanleitung

Johnson Controls

Johnson Controls York YKN2Open board Handbuch

Johnson Controls

Johnson Controls TEC3620 Series Bedienungsanleitung

Johnson Controls

Johnson Controls A350E Handbuch

Johnson Controls

Johnson Controls FX70 Bedienungsanleitung

Johnson Controls

Johnson Controls FEC16 Series Bedienungsanleitung

Johnson Controls

Johnson Controls FX-PCV1615 Bedienungsanleitung

Johnson Controls

Johnson Controls Facility Explorer FX20 Bedienungsanleitung

Beliebte Controller Handbücher anderer Marken

Digiplex

Digiplex DGP-848 Betriebsanleitung

YASKAWA

YASKAWA SGM series Bedienungsanleitung

Sinope

Sinope Calypso RM3500ZB Bedienungsanleitung

Isimet

Isimet DLA Series Style 2 Installationshandbuch

LSIS

LSIS sv-ip5a Bedienungsanleitung

Rockwell Automation

Rockwell Automation 1769-L31 Bedienungsanleitung

Airflow

Airflow Uno hab Bedienungsanleitung

ABB

ABB ACS580-01 drives Bedienungsanleitung

Panasonic

Panasonic GM1 Series Bedienungsanleitung

Emerson

Emerson SW93 Bedienungsanleitung

AutoAqua

AutoAqua Smart ATO micro SATO-120P Bedienungsanleitung

Panasonic

Panasonic FP? Positioning Unit RTEX Bedienungsanleitung

Samson

Samson Type 5824 Service-Handbuch

Alpha IP

Alpha IP MIOB 21001 Bedienungsanleitung

Siemens

Siemens OpenAir GMA 1 Series Bedienungsanleitung

Surecom

Surecom SR-629 Bedienungsanleitung

Fishman

Fishman TriplePlay Bedienungsanleitung

Regulus

Regulus SRS1 T Bedienungsanleitung