Li9k Max Product Manual
BASIC Operation
Your battery should arrive in the “OFF” state. If the battery
is not in the ”OFF” state as indicated by the ashing Run
Indicator ( ), you should turn the battery off before
making any connections.
The battery may be turned off by pressing the ON/OFF
Reset Switch ( ) on the front panel and holding for 3
seconds. The LEDs will ash in sequence and then go out
as the battery enters the “OFF” state.
With the battery in the “OFF” state, connect battery
terminals to the load and/or charger, making sure to
observe correct polarity, i.e. connect positive (+) to positive
and negative (-) to negative, and using the appropriate wire
size for the application.
Turn on battery by momentarily pressing the ON/OFF Reset
Switch ( ) . The front panel LEDs will light in sequence
indicating that the battery is on. Your battery is equipped
with a 2 second soft-start feature that prevents a large
current surge when connected to capacitive loads such as
power inverters.
10
6
6
