Antenna gain 0dbi
Antenna type Internal type, coil antenna
Power supply 100-240VAC, 50-60Hz, 0.7Amax
Notice:
1. Don't steep the product and isolate liquid
2.Break the power il cleanning is needed
3.Keep use temperature between 0-34 ℃
Cleaning and maintenance
Always disconnect the charger from the mains before cleaning. Clean product components with a
soft, dry and lint-free cloth. Do not use chemical cleaners, scouring agents or liquids! Never
immerse the device in water.
The product does not contain any parts which the user can repair. In the event of a defect,
replace the entire assembly. Contact the manufacturer.
Disposal
Do not dispose of the charger and its components in the
residential waste.
Follow the national disposal regulations.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions
(1) This device may not cause harrnful interference
(2) This device must accept any interference received，including interference that may cause
undesired operation
2. This equipment has been tested and found to comply with the limits for a Class B digital
device pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
