JPI FT-826 Gebrauchsanweisung
FT-826 Hydraulic Veterinary Surgery Table
Quick Install Manual
Installation:
Step 1: Open Crate
Using a powered screwdriver, remove the top and three sides of the shipping crate.
Step 2: Remove Table From Crate
The table is heavy. Do not attempt to move it with less than two people.
Do not lift the table by the table top. Lift by the table frame or by the table base.
Step 3: Position the table where it will be used.
Step 4: Level the table using the adjustable feet.
Installation is complete!
Quick Use Guide
1. Raising and Lowering the Table
Pump the foot pedal to raise the table.
Hold the foot pedal down to lower the table back to the starting position.
2. Tilting
Rotate the wheel on the side of the table to tile it forwards or backwards.
3. Raising the leaves
a. Loosen the upper handle on both sides of the leaf.
b. Raise the leaf. The pin it is rotating on will move in the slot, and the pin will end up at the very
end of the slot.
c. The pin may slide slightly out of the slot at high angles.
d. Tighten the upper handle of both sides of the leaf.
Final Position of the leaf
Inhaltsverzeichnis
Andere JPI Prüfgeräte Handbücher
Beliebte Prüfgeräte Handbücher anderer Marken
SMART
SMART KANAAD SBT XTREME 3G Series Bedienungsanleitung
Agilent Technologies
Agilent Technologies BERT Serial Bedienungsanleitung
Agilent Technologies
Agilent Technologies N3280A Bedienungsanleitung
Vernier
Vernier Go Direct Voltage Bedienungsanleitung
Lifeloc
Lifeloc R.A.D.A.R. Bedienungsanleitung
Fluke
Fluke T5-600 Bedienungs- und Montageanleitung
PCB Piezotronics
PCB Piezotronics 8159-0112A Bedienungsanleitung
BW Technologies
BW Technologies MicroDock II Bedienungsanleitung
Sun Nuclear
Sun Nuclear 1027 Bedienungsanleitung
Biomark
Biomark HPR LITE READER Bedienungsanleitung
Hioki
Hioki 3169-20 Bedienungsanleitung
Ashcroft
Ashcroft ATE-100 Bedienungsanleitung