Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - SNMP AGENT GUIDE REV... Bedienungsanleitung

Juniper Networks, Inc.

1194 North Mathilda Avenue

Sunnyvale, CA 94089

USA

408-745-2000

www.juniper.net

Part Number: 530-025621-01, Revision 1

Security Threat Response Manager

SNMP Agent Guide

Release 2008.2

2

Networks Inc. in the United States and other countries. All other trademarks, service marks, registered trademarks, or registered service marks in this

document are the property of Juniper Networks or their respective owners. All specifications are subject to change without notice. Juniper Networks

assumes no responsibility for any inaccuracies in this document or for any obligation to update information in this document. Juniper Networks reserves

the right to change, modify, transfer, or otherwise revise this publication without notice.

FCC Statement

The following information is for FCC compliance of Class A devices: This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the

equipment is operated in a commercial environment. The equipment generates, uses, and can radiate radio-frequency energy and, if not installed and

used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential

area is likely to cause harmful interference, in which case users will be required to correct the interference at their own expense. The following

information is for FCC compliance of Class B devices: The equipment described in this manual generates and may radiate radio-frequency energy. If it

is not installed in accordance with NetScreen’s installation instructions, it may cause interferencewith radio and television reception. This equipment has

been tested and found to comply with the limits for a Class B digital device in accordance with the specifications in part 15 of the FCC rules. These

specifications are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Consult the dealer or an experienced radio/TV

technician for help. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Caution: Changes or modifications to this product could void the user's warranty and authority to operate this device.

Disclaimer

THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET

THAT SHIPPED WITH THE PRODUCT AND ARE INCORPORATED HEREIN BY THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE

SOFTWARE LICENSE OR LIMITED WARRANTY, CONTACT YOUR JUNIPER NETWORKS REPRESENTATIVE FOR A COPY.

STRM SNMP Agent Guide

Release 2008.2

Revision History

June 2008—Revision 1

The information in this document is current as of the date listed in the revision history.

CONTENTS

ABOUT THIS GUIDE

Conventions 3

Technical Documentation 3

Documentation Feedback 3

Requesting Support 4

1ABOUT THE EMBEDDED SNMP AGENT

About the SNMP Agent 5

Accessing the SNMP Agent 6

2USING THE SNMP-LINUX-MIB

Processor Details 7

Disk Space Details 8

Mount Details 8

System Performance Details 9

Processes Table Details 10

Processor Performance Details 10

Page Details 11

Service Details 11

Boot Log Details 12

Cron Log Details 13

Secure Log Details 13

IDE Details 14

Module Details 14

PCI Details 15

SCSI Details 16

Slab Details 16

3USING THE RFC1213-MIB

System Details 19

Interfaces 21

Address Translation 23

IP Details 23

System Details 26

IP Address Table Details 27

IP Route Table Details 28

IP Net to Media Table Details 30

ICMP Table Details 31

TCP Details 33

TCP Connection Details 35

UDP Details 36

UDP Table Details 36

SNMP Details 37

4USING THE HOST-RESOURCES-MIB

System Details 41

Storage Details 42

Device Details 43

Processor Table Details 45

Network Table Details 45

Printer Table Details 45

Disk Storage Details 46

Partition Details 47

File System Details 48

Software Run Details 49

Software Run Performance Details 50

HR Software Installed Table Details 51

ASNMP OVERVIEW

About SNMP 53

What Is an Agent? 53

Who Is a Manager? 54

Manager and Agent Relationship 54

What is a MIB (Management Information Base)? 55

What Are MIB Groups? 56

MIB Data types Available 57

MIB Constructs Available 60

Supported Textual Conventions 61

Nodes 62

Object Identifiers 62

Relative and Absolute Object Identifiers 62

Specifying Object Identifiers Symbolically 62

Object Identifier with Instance Indexes 63

Scalar and Tabular Objects 63

How an Agent Works 64

Traps 64

Specifying SNMP Variables in GET Requests 65

STRM SNMP Agent Guide

ABOUT THIS GUIDE

The STRM SNMP Agent Guide provides you with information on using the

embedded SNMP Agent and viewing MIB information.

Conventions Table 1 lists conventions that are used throughout this guide.

Technical

Documentation You can access technical documentation, technical notes, and release notes

directly from the Juniper networks Support Web site at

http://www.juniper.net/support/.

Documentation

Feedback We encourage you to provide feedback, comments, and suggestions so that we

can improve the documentation. Send your comments to

techpubs-comments@juniper.net, or fill out the documentation feedback form at

http://www.juniper.net/techpubs/docbug/docbugreport.html. If you are using e-mail, be

sure to include the following information with your comments:

•Document name

•Document part number

•Page number

•Software release version

Table 1 Icons

Icon Type Description

Information note Information that describes important features or

instructions.

Caution Information that alerts you to potential loss of

data or potential damage to an application,

system, device, or network.

Warning Information that alerts you to potential personal

injury.

STRM SNMP Agent Guide

4ABOUT THIS GUIDE

Requesting

Support • Open a support case using the Case Management link at

http://www.juniper.net/support/ or call 1-888-314-JTAC (from the United States,

Canada, or Mexico) or 1-408-745-9500 (from elsewhere).

STRM SNMP Agent

1ABOUT THE EMBEDDED SNMP

AGENT

The STRM Embedded SNMP Agent is a service that runs on STRM appliances to

monitor system performance and usage metrics such as CPU utilization, memory

usage, disk space usage, and network interface statistics. The SNMP Agent

allows STRM to monitor system health and enables integration with other existing

network management products, such as, HP Openview or IBM Tivoli for system

health monitoring. This chapter provides information regarding the Embedded

SNMP Agent including:

•About the SNMP Agent

•Accessing the SNMP Agent

About the SNMP

Agent The SNMP Agent provides real-time information on the following Management

Information Bases (MIBs):

•SNMP-LINUX-MIB. For more information, see Chapter 2 Using the

SNMP-Linux-MIB.

•RFC1213-MIB. For more information, see Chapter 3 Using the RFC1213-MIB.

•HOST-RESOURCES-MIB. For more information, see Chapter 4 Using the

Host-Resources-MIB.

These MIBs enable SNMP manageability for your Linux systems. The figure below

the architecture for the SNMP Agent.

STRM SNMP Agent

6ABOUT THE EMBEDDED SNMP AGENT

The SNMP Agent gathers all the information from your Linux system pertaining to

SNMP-LINUX-MIB, HOST-RESOURCES-MIB, and RFC-1213-MIB and exposes

that information using the STRM interface and SNMP managers.

Note: For information on configuring SNMP Agent ports, see the Managing STRM

chapter in the STRM Administration Guide.

Accessing the

SNMP Agent To access the embedded SNMP Agent:

Step 1 In the Administration Console, click the System Configuration tab.

The System Configuration panel appears.

Step 2 Click the System Management icon.

The System Management window appears.

Step 3 In the View Agent column, click View Agent for the SNMP agent you wish to

access.

Web

Console

SNMP

Manager

SNMP Agent for Linux

System Details

Process Details

Details relating to

HOST-RESOURCES-MIB,

RFC-1213-MIB,

and SNMP-LINUX-MIB

Linux

STRM SNMP Agent

2USING THE SNMP-LINUX-MIB

The SNMP-Linux-MIB is a pre-defined MIB that retrieves information from your

system. This MIB retrieves the following information:

•Processor Details

•Disk Space Details

•Mount Details

•System Performance Details

•Service Details

•Boot Log Details

•Cron Log Details

•Secure Log Details

•IDE Details

•Module Details

•PCI Details

•SCSI Details

•Slab Details

Processor Details The process details includes:

For example, sample output may include:

Table 2-1 Processor Details

S.No Processor Details

1. Processor Vendor Name

2. Processor Model Name

3. Processor Speed in Mega Hertz

4. Processor Cache Size in KB

STRM SNMP Agent

8USING THE SNMP-LINUX-MIB

Disk Space Details The disk space details includes:

For example, sample output may include:

Mount Details The mount details includes:

Table 2-2 Disk Space Details

S.No Disk Space Details

1. File System Type

2. Total Disk Space in MegaBytes

3. Used Space in MegeBytes

4. Percentage of Free Space

5. Percentage of Used Space

6. The Mount Point of the Device

Table 2-3 Mount Details

S.No Mount Details

1. Device Name

2. Mount Point of the Device

3. File System Type

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Juniper Software Handbücher

Juniper

Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M... Installationshandbuch

Juniper

Juniper JUNOSE FOR E SERIES BROADBAND SERVICES ROUTERS - S... Bedienungsanleitung

Juniper

Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE... Bedienungsanleitung

Juniper

Juniper NETWORK AND SECURITY MANAGER 2010.4 - NSMXPRESS SERIES II REV... Bedienungsanleitung

Juniper

Juniper NETWORKS STRM - TECHNICAL NOTE REV 6-2008 Bedienungsanleitung

Juniper

Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE... Bedienungsanleitung

Juniper

Juniper SERVICE AVAILABILITY - CONFIGURATION GUIDE V... Bedienungsanleitung

Juniper

Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - CATEGORY OFFENSE INVESTIGATION GUIDE REV... Bedienungsanleitung

Juniper

Juniper RESIDENT CONSULTANT Bedienungsanleitung

Juniper

Juniper PHYSICAL LAYER - CONFIGURATION GUIDE V11.1.X Bedienungsanleitung

Juniper

Juniper JUNOSE 11.0.X MULTICAST ROUTING Bedienungsanleitung

Juniper

Juniper STRM LOG MANAGEMENT 2008.2 - S 6-2008 Bedienungsanleitung

Juniper

Juniper JUNOSE SOFTWARE 11.0.1 - S 7-14-2010 Bedienungsanleitung

Juniper

Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Bedienungsanleitung

Juniper

Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE... Bedienungsanleitung

Juniper

Juniper SPACE VIRTUAL CONTROL Bedienungsanleitung

Juniper

Juniper JUNOS OS 10.4 RELEASE NOTES Bedienungsanleitung

Juniper

Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE... Bedienungsanleitung

Juniper

Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - CATEGORY OFFENSE INVESTIGATION GUIDE REV... Bedienungsanleitung

Juniper

Juniper STRM Bedienungsanleitung

Juniper

Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z... Installationshandbuch

Juniper

Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV... Bedienungsanleitung

Juniper

Juniper MEDIA FLOW CONTROLLER 2.0.5 - S REV... Bedienungsanleitung

Juniper

Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV... Bedienungsanleitung

Beliebte Software Handbücher anderer Marken

COMPRO

COMPRO COMPROFM Bedienungsanleitung

Muratec

Muratec OFFICEBRIDGE ONLINE Bedienungsanleitung

Oracle

Oracle Contact Center Anywhere 8.1 Bedienungsanleitung

Adobe

Adobe 65007312 - Photoshop Lightroom Handbuch

Avaya

Avaya NULL One-X for RIM Blackberry Bedienungsanleitung

HP ProLiant BL420c Bedienungsanleitung

PS Audio

PS Audio PowerPlay Betriebsanleitung

Brady

Brady LOCKOUT PRO 3.0 Service-Handbuch

Avaya

Avaya Interaction Center Bedienungsanleitung

Texas Instruments

Texas Instruments TI-83 Plus Silver Edition Handbuch

Novell

Novell GROUPWISE 8 - INTERNET AGENT Bedienungsanleitung

Oracle

Oracle Application 9i Bedienungsanleitung

Acer

Acer RDM Bedienungsanleitung

Canon

Canon Vixia HF21 Bedienungsanleitung

Canon

Canon ZR950 Bedienungsanleitung

Samsung

Samsung Auto Backup Bedienungsanleitung

Polycom

Polycom Vortex EF2201 Montage- und Bedienungsanleitung

Brocade Communications Systems

Brocade Communications Systems Brocade 8/12c Bedienungsanleitung