JVC LVT2011-006A Bedienungsanleitung

COMPACT COMPONENT SYSTEM

NX-PN10

INSTRUCTIONS

LVT2011-006A

[UJ]

cover_NX-PN10[UJ].fm Page 1 Thursday, May 14, 2009 9:38 PM

G-1

Warnings, Cautions and Others

CAUTION

The button in any position does not

disconnect the mains line.

Disconnect the mains plug to shut the power off

completely (the STANDBY lamp goes off).

The MAINS plug or an appliance coupler is used

as the disconnect device, the disconnect device

shall remain readily operable.

• When the system is on standby, the STANDBY

lamp lights red.

• When the system is turned on, the STANDBY

lamp goes off.

The power can be remote controlled.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1. Do not remove screws, covers or cabinet.

2. Do not expose this appliance to rain or

moisture.

CAUTION

Battery shall not be exposed to excessive heat

such as sunshine, fire or the like.

CAUTION

• Do not block the ventilation openings or

holes.

(If the ventilation openings or holes are

blocked by a newspaper or cloth, etc., the

heat may not be able to get out.)

• Do not place any naked flame sources, such

as lighted candles, on the apparatus.

• When discarding batteries, environmental

problems must be considered and local rules

or laws governing the disposal of these

batteries must be followed strictly.

• Do not expose this apparatus to rain,

moisture, dripping or splashing and that no

objects filled with liquids, such as vases, shall

be placed on the apparatus.

Caution: Proper Ventilation

To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:

1. Front: No obstructions and open spacing.

2. Sides/Top/Back: No obstructions should be placed in the areas shown by the dimensions below.

3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a

stand with a height of 10 cm or more.

Side viewFront view

safety_NX-PN10[UJ].fm Page 1 Monday, May 18, 2009 4:02 PM

Contents

Introduction.................................................2

Precautions ................................................................ 2

Getting Started............................................3

Connections................................................................ 4

Canceling the Display Demonstration (Demo) ..........6

Turning on the Power Automatically

(Motion Sensor) .................................................. 6

Basic Operations .........................................7

Main Unit ................................................................... 7

Remote Control .......................................................... 9

Playing Back from iPod Devices..............12

Connecting iPod .......................................................13

Operations ................................................................14

Listening to FM Broadcasts .....................17

Basic Operations ......................................................17

Playing Back from Other Equipment .....19

Connecting Other Equipment...................................19

Operations ................................................................19

Setting the Clock and Timer....................20

Setting the Clock ......................................................20

Using Timer .............................................................20

Troubleshooting ........................................23

Specifications.............................................24

NX-PN10[UJ].BOOK Page 1 Thursday, May 28, 2009 9:24 AM

Introduction

Thank you for purchasing a JVC product.

Please read all instructions carefully before operation, to ensure your complete understanding and

to obtain the best possible performance from the unit.

Precautions

Installation

• Install in a place which is level, dry and neither too hot nor too cold—between 5°C and 35°C.

• Install the unit in a location with adequate ventilation to prevent internal heat buildup inside the

unit.

• Leave sufficient distance between the unit and the TV.

• Keep the unit away from the TV to avoid interference with TV.

Power Sources

• When unplugging the unit from the wall outlet, always pull on the plug, not the AC power cord.

Internal Heat

Others

• Should any metallic object or liquid fall into the unit, unplug the AC power cord and consult your

dealer before operating any further.

• If you are not going to operate the unit for an extended period of time, unplug the AC power cord

from the wall outlet.

If anything goes wrong, unplug the AC power cord and consult your dealer.

DO NOT install the unit in a location near heat sources, or in a place subject to direct

sunlight, excessive dust or vibration.

DO NOT handle the AC power cord with wet hands.

For safety, observe the following carefully:

• Make sure there is good ventilation around the unit. Poor ventilation could overheat

and damage the unit.

• DO NOT block the ventilation openings or holes. If they are blocked by a newspaper

or cloth, etc., the heat may not be able to get out.

DO NOT disassemble the unit since there are no user serviceable parts inside.

NX-PN10[UJ].BOOK Page 2 Thursday, May 28, 2009 9:24 AM

Getting Started

Supplied Accessories

After unpacking, check to be sure that you have

all the following items. The number in

parentheses indicates the quantity of each piece

supplied.

• Remote control (1)

• Lithium coin battery CR2025 (1) (The battery

has been installed when shipped from the

factory.)

• FM antenna (1)

• AC power cord (1)

• AC adaptor (1)

• AC plug adaptor (1)

If anything is missing, consult your dealer

immediately.

CAUTION:

To avoid risk of fire and to prevent damage.

• Do not use AC adaptors except the supplied

AC adaptor.

• Do not use the supplied AC adaptor for other

equipment.

Prepare the Remote Control

When you use the remote control for the first

time, pull out the insulation sheet.

Replacing the battery in the remote control

Insert the battery into the remote control by

matching the polarity (+ and –) correctly.

• If the range or effectiveness of the remote

control decreases, replace the battery.

WARNINGS:

• Store the battery in a place where children

cannot reach. If a child accidentally swallows

the battery, consult a doctor immediately.

• Do not recharge, short, disassemble or heat

the battery or dispose of it in a fire. Doing any

of these things may cause the battery to give

off heat, crack, or start a fire.

• Do not leave the battery with other metallic

materials. Doing this may cause the battery to

give off heat, crack, or start a fire.

• When throwing away or saving the battery,

wrap it in tape and insulate; otherwise, the

battery may start to give off heat, crack, or

start a fire.

• Do not poke the battery with tweezers or

similar tools. Doing this may cause the battery

to give off heat, crack, or start a fire.

• Dispose of battery in the proper manner,

according to federal, state, and local

regulations.

• In this manual, operations using the remote

control are mainly explained; however, you

can use the buttons and controls on the unit

if they have the same (or similar) name and

marks.

• In this manual, “iPod” means both iPod and

iPhone devices. When iPhone device is

especially mentioned, “iPhone” is used in

this case.

Insulation sheet

Front side

CAUTION:

Danger of explosion if battery is incorrectly

replaced.

Replace only with the same or equivalent

type.

Rear side

Lithium coin battery

(product number:

CR2025)

NX-PN10[UJ].BOOK Page 3 Thursday, May 28, 2009 9:24 AM

Connections

Connecting the Antenna

NOTES:

• Make sure the FM antenna does not touch any other terminals, connecting cords or the AC power

cord. Also, keep the antenna away from metallic parts of the unit, connecting cords and the AC

power cord. This could cause poor reception.

Do not connect the AC power cord until all other connections have been made.

For better FM reception

Disconnect the supplied FM antenna and

connect to an outdoor FM antenna using a 75 Ω

wire with coaxial type connector.

AM band is not received with this unit.

Rear side

FM antenna (supplied):

Extend it so that you can

obtain the best reception.

Outdoor FM antenna

(not supplied)

FM 75Ω COAXIAL

terminal

(on the rear panel)

NX-PN10[UJ].BOOK Page 4 Thursday, May 28, 2009 9:24 AM

Connecting the Video Cord to View a Video/Picture from iPod

When viewing a video/picture from iPod on your TV, use a composite video cord (not supplied) to

connect the VIDEO OUT jack on the unit and the composite video input on your TV.

• After you have connected the unit, change the video input mode on your TV. For details, also refer

to the instruction manual for your TV.

Connecting the Power Cord

• If the wall outlet does not match the AC plug, use the supplied AC plug adaptor.

Video cord (not supplied)

Rear side

To video input

Rear side

AC adaptor

(supplied)

AC power cord

(supplied)

To a wall outlet

Plug in the AC power cord

only after all connections

are complete.

NX-PN10[UJ].BOOK Page 5 Thursday, May 28, 2009 9:24 AM

Canceling the Display Demonstration (Demo)

When you connect the AC power cord for the first time, the display demonstration starts

automatically.

• When you operate the unit, the display demonstration stops temporarily. If no operation is done

for about 2 minutes, the unit starts the display demonstration again.

• To activate again, hold down DEMO until “DEMO ON” appears on the display.

• When ECO mode is activated (P.10), the display demonstration does not function.

Turning on the Power Automatically (Motion Sensor)

When you move your hand or an object closer to Motion sensor (P.7), the unit turns on

automatically.

• iPod starts playback or an FM broadcast is received if you selected either of them last time.

• Motion Sensor works even if ECO mode is activated.

• To deactivate, press MOTION SENSOR. “M.S OFF” appears on the display.

NOTE:

• If the AC power cord is unplugged, Motion Sensor does not work.

• Deactivate Motion Sensor in the following cases to prevent the unit from turning on automatically:

– when you do not use the unit for a long time

– when you use Timer

Button

Operation

On the unit

Hold down until “DEMO OFF” appears on the display.

Button

Operation

On the unit

Press to activate Motion Sensor. “ M.S ON” appears on the display.

• When you select Clock as the display information or the unit is on standby,

“ ” is shown on the display (see page 10).

NX-PN10[UJ].BOOK Page 6 Thursday, May 28, 2009 9:24 AM

Main Unit

Operating on the Main Unit

Buttons Operations

Turns on or off (standby) the power.

Activates or deactivates Motion Sensor (P.6).

STANDBY

lamp

Remote

control

sensor

Display (P.8)

Illumination panel

(P.10)

Dock A

(P.13)

Dock B

(P.13)

Motion

sensor

(P.6)

Basic Operations

NX-PN10[UJ].BOOK Page 7 Thursday, May 28, 2009 9:24 AM

Display Information

Activates or deactivates the display demonstration (P.6).

Adds the powerfulness to the sound (P.11).

Stops the timer sound and restarts it 5 minutes later (P.22).

• iPod (P.14):

Press: Reverse skip/forward skip.

Hold down: Reverse search/forward search.

• FM (P.17): Tunes in to a station.

• Changes the source to iPod /iPod (P.14).

• Starts playback and pauses for iPod (P.14).

Changes the source to FM (P.17) or

AUDIO IN (P.19).

Adjusts the volume level (VOL MIN/VOL 0 to VOL MAX/VOL 30).

Symbols Description

Lights up when iPod is connected to dock A.

Lights up when iPod is connected to dock B.

SHUFFLE Lights up when Shuffle Play applies to both iPod and iPod (P.15).

S.TURBO Lights up when Sound Turbo is activated (P.11).

MHz Lights up when FM frequency is indicated.

Buttons Operations

AUDIO IN

iPod

iPod B

NX-PN10[UJ].BOOK Page 8 Thursday, May 28, 2009 9:24 AM

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere JVC Lautsprechersystem Handbücher

Beliebte Lautsprechersystem Handbücher anderer Marken

LG NB4532B Bedienungsanleitung

5Core

5Core Pro Series Bedienungsanleitung

EAW

EAW MQV1394e Bedienungsanleitung

Lynx

Lynx GXR-LA10A Bedienungsanleitung

iLive

iLive ITB066B Bedienungsanleitung

RDX

RDX QuickStation 4 Bedienungsanleitung

Electro-Voice

Electro-Voice S-122 Bedienungsanleitung

Sven

Sven SPS-619 GOLD Bedienungsanleitung

Pioneer

Pioneer CS-7070 Bedienungsanleitung

EAW

EAW UB82e Bedienungsanleitung

Sondpex

Sondpex Active Speaker System and Digital Music... Bedienungsanleitung

Marshall Amplification

Marshall Amplification AR-DM61-BT Bedienungsanleitung

Yamaha

Yamaha NX-A01 - Speaker Sys Bedienungsanleitung

SE Audiotechnik

SE Audiotechnik I-LINE Bedienungsanleitung

Gemini

Gemini WRX-843 Series Bedienungsanleitung

TCL

TCL 6100 Series Bedienungsanleitung

JBL

JBL gto6506c Bedienungsanleitung

Legacy

Legacy FOCUS SE Bedienungsanleitung