3
PROGRAMMING A MESSAGE
INSTRUCTIONS
1. Make sure the controller is o and connect the USB cord to the
controller and your PC.
2. Hold the“Power”button until the LCD Screen on the
controller comes on. (You should see this screen)
3. If the software does not open automatically, open
“my computer”click on“K&K SIGN”, and open the sign software.
4. Open the software and click“Run”.
5. You should see this screen
6. Pull down the“File”menu and click “New”
7. A window with previously saved messages
should appear for you to save your new
message. ** If the correct window does not
appear: Click on “my computer”and click
on“K&K SIGN”
8. Name your new message the next available
double digit number.
(Example: if the last number listed is 09.led,
your new message will be saved as 10.led.)
Make sure not to duplicate numbers - this will cause neither message to display.
Also be sure to name your message two digits: (ex. 01.led, 05.led, 10.led, 19.led, etc.)
9. Click“Save”
10. A screen will appear that says“File save ok”. Click“Okay”.
11. Type your message in the text box labeled“Input TXT”. (Delete the text“Input TXT” rst)
12. Select what font, size, eect, speed you would like your message to display.
13. Press Preview and click in the display area.
**NOTE: Your message will not preview until you click in the display area where you message is shown.
14. Once your message is complete, pull down the“File”menu and click“Save”.
15. Disconnect the controller from the PC, and nd the new message using the arrow keys
on the controller.
16. Click“ENT”
