Keebox IPC1000W Bedienungsanleitung

Quick Installation Guide

KView Wireless N Internet Camera

1. Before You Start

2. Hardware Installation and Configuration 2

3. Wi-Fi Protected Setup (WPS) Push Button Setup 10

1

Version 05.13.2009

ŸCD-ROM Drive

ŸVGA Resolution: 800 x 600 or above

ŸWeb Browser: Internet Explorer (6.0 or higher)

ŸWireless router (e.g. W150NR) or access point

ŸAn available DHCP Server – routers usually have a built-in DHCP server.

ŸIPC1000W

ŸCD-ROM (Utility and User's Guide)

ŸMulti-Language Quick Installation Guide

ŸNetwork Cable (1.5m/5ft.)

ŸMounting Kit

Hardware Installation and Configuration

Wi-Fi Protected Setup (WPS) allows you to quickly connect to your wireless

router or access point. If you would like to use WPS push button setup, please

go directly to section 4. Wi-Fi Protected Setup (WPS) Push Button Setup. If your

2. Click Run autorun.exe (Windows 7/Vista only)

3. Click Install Camera.

1. Insert the Utility CD-ROM into your CD-ROM drive.

4. Write down the MAC ID of the camera and then click Next.

5. Connect the Power Adapter to the IP Camera and then to a power outlet. Then

The Mac ID shown in the Setup Wizard is an example. This is not the actual

MAC ID of your IP camera. The Mac ID can be found on the back of the

6. Click wired mode.

7. Connect a RJ-45 network cable from a router to the network port on the IP

Setting a password prevents other users from accessing the IPC1000W's

configuration.

It is recommended that you enter a new password. If you decide to change this

setting, please write down the new password.

Password is limited to up to 8 characters.

8. Select your IP camera and then click Next. Verify that the MAC ID matches the

10. Click Enable Wireless.

11. Click on the dropdown list for Available AP.

12. Select your SSID from the Available AP dropdown list. The SSID is the wireless

13. If Encryption is enabled on your wireless network (e.g. access point or wireless

14. Disconnect the RJ-45 cable. Verify that the LINK (RED) LED is lit.