sparks when in use. WARNING: Explosive gases. Prevent flames and
sparks. Provide adequate ventilation during charging.
6. To prevent fire or explosion, only use in a well-ventilated area. When
charging, it is prohibited to start the engine or perform ignition and other
dangerous actions. Do not charge in a garage or other enclosed space.
Provide adequate ventilation during charging.
7. Never touch battery terminals or battery clamps whilst the device is
connected to alternating current.
8. When charging automobile batteries: the battery terminal not connected
to the chassis has to be connected first. The other connection is to be
made to the chassis, remote from the battery and fuel line. The battery
charger is then to be connected to the supply mains; after charging,
disconnect the battery charger from the supply mains. Then remove the
chassis connection and then the battery connection.
9. Remove all device cables from the battery before attempting to drive your
vehicle
10. Use a power source with the voltage specified on the nameplate of the
charger.
11. Check the input voltage (230V ~ 50Hz) and ensure that it corresponds to
the mains voltage, otherwise the charger may be damaged.
12. If an extension cable is used, the cable diameter must be sufficient for the
power required by the charger
13. Do not charge the battery packs in presence of flammable liquids or gases.
14. Never short circuit the device or connect the inlets and outlets of the device
using metal objects. Only use the supplied connecting cables to connect
the device to a battery.
15. Always make sure that the charger is disconnected from the mains when
you connect it and disconnect it to a battery.
16. Never place the device over or close to the battery to be charged. Gases
from the battery make the charger corrode and damage it. Set up the
charger as far away from the battery as the direct current cable allows.
17. Ensure that the device is always stored in a safe place. Do not expose the
device to rain or snow or other wet conditions. Avoid pouring or dripping
water or other liquids over it. If water penetrates electrical devices, the risk
of electric shock increases.
18. To protect against the risk of electrical shock, do not immerse the unit, cord
or plug in water or other liquid.
19. Ensure that all plugs and cables are free of moisture. Never connect the
device to the mains with wet or moist hands.
20. Never carry charger by cord or yank it to disconnect from receptacle.
21. After charging or before attempting any maintenance or cleaning, unplug
the charger from the power source.
22. Always disconnect the charger by pulling out the power plug other than
cord whenever disconnecting charger.
