Keston K260 Bedienungsanleitung

KESTON CONDENSING BOILER

Users Instructions

The Gas Safety (Installation And Use) Regulations: 1996 (as amended) impose certain statutory

obligations on gas users. Further information regarding these regulations can be obtained from your Gas

Supplier.

All gas appliances must be installed by competent persons by law in accordance with these

regulations. Membership of CORGI is indication of such a competent person with regard to gas

installation.

It is in your interests, and that of safety, to ensure that the appliance is installed correctly and that the

law is complied with. Failure to do so could lead to prosecution.

Introduction

These instructions should be carefully read to ensure safe and economical use

of your boiler.

The KestonCondensing Boiler series are high efficiency central heating

condensing boilers designed to provide central heating and indirect sanitary hot

water supply. They are designed for use with fully pumped systems only. These

boilers are supplied for natural gas use only.

Servicing

To ensure continual safe and efficient operation of the boiler it is recommended

that the appliance be checked and serviced as necessary at regular intervals.

Generally once per year will be sufficient. It is the law that any servicing must be

carried out by a competent person.

Clearances

If fixtures are to positioned close to the boiler the following minimum clearances

must be observed: Top : 127 mm, Bottom : 127 mm, Left : 1 mm, Right : 1 mm &

Front : 540 mm. Extended clearance is required to the front to allow for access

for servicing.

Cleaning

Normal casing cleaning only requires dusting with a dry cloth. To remove more

stubborn marks wipe with a damp cloth and finish with a dry cloth.

Boiler Setup

1) Check that the gas supply from the gas meter is turned ON

2) Switch on the electric supply to the boiler and controls and set the heating

controls to call for heat.

3) Check the pressure gauge, to the right on the control panel on the front of the

boiler. This should show around 1 to 2 bar pressurefor pressurised systems.

Warning: If there is no pressure indicated and the system is not of the open vented

type do not attempt to light the boiler. Send for your Installer or Service

Engineer to re-pressurise the system.

To Light The Boiler

Switch the main On/Off switch, to the top of the control panel on the front of the boiler, to

the ON position. Turn both module On/Off switches, below the main On/Off switch, to the

ON position. The following sequence will occur:

1) In the On position the Main On/Off switch will be lit with an amber light If the

switch does not illuminate check that the electricity supply to the heating

system is on and that the controls are calling for the boiler to fire.

2) The boiler will automatically select one of the two modules to fire and the fan in

one module will start.

3) After about 15 seconds the module will ignite and the green (run) lamp, the upper

lamp adjacent to the flame symbol, will also illuminate.

4) If the boiler detects a second module is required it will initiate firing of the other

module automatically following the same sequence as above.

Pressure

Gauge

On/Off

Switch

Fig 1: Boiler Control Panel

GREEN

LAMP GREEN

LAMP

RED

LAMP RED

LAMP

Main

Module

On/Off

Switches

Module

Indicator

Lamps

The boiler is now running correctly and will proceed to switch itself on and off as the

heating reaches its operating temperature.

If the module green (run) lamp, the upper lamp adjacent to the flame symbol, goes out

and the red light illuminates for more than ten seconds, due to a failure to ignite or an

interruption to the gas supply, turn the boiler off, wait for 10 seconds and turn the boiler

on again as described above in To Light The Boiler. If the boiler still fails to ignite

after three successive attempts contact your Installer or Service Engineer.

NB: The Keston260 and Keston340 displays on the LED display the actual flow

temperature of the boiler. To adjust the required flow temperature hold in the push

button on the sequence controller and rotate the knob until the required temperature is

displayed. When the push button is released the display will revert to showing the actual

flow temperature.

Precautions

Care must be taken at all times to ensure that no blockage or obstruction is

present in thecondensate drainage line. In addition the air intake and flue

exhaust terminals of the appliance must be free of obstruction at all times.

Gas Leak or Fault

If you suspect a gas leak turn off the appliance immediately, turn off the gas tap

to the appliance and contact your local gas region without delay.

If you suspect a fault with the appliance it must not be used until the fault has

been corrected by a competent person.

In the unlikely event of a breakdown consult your Installer or Service Engineer

END OF DOCUMENT

Andere Handbücher für K260

Inhaltsverzeichnis

Andere Keston Kessel Handbücher

Keston

Keston K170 Benutzerhandbuch

Keston

Keston HEAT 45 Benutzerhandbuch

Keston

Keston C40 Benutzerhandbuch

Keston

Keston System 30 Benutzerhandbuch

Keston

Keston Combi C30 Benutzerhandbuch

Keston

Keston 50 - GC Benutzerhandbuch

Keston

Keston Heat2 45 Bedienungsanleitung

Keston

Keston Qudos 28s Handbuch

Keston

Keston Spa 120 litre Bedienungsanleitung

Keston

Keston 30C Bedienungsanleitung

Keston

Keston Combi C35 Bedienungsanleitung

Keston

Keston Celsius 25 Benutzerhandbuch

Keston

Keston Combi 30 Benutzerhandbuch

Keston

Keston C40 Bedienungsanleitung

Keston

Keston K260 Benutzerhandbuch

Keston

Keston Qudos 28h Handbuch

Keston

Keston 30C Benutzerhandbuch

Keston

Keston 170 Bedienungsanleitung

Keston

Keston C90 Benutzerhandbuch

Keston

Keston SYSTEM2 S30 Benutzerhandbuch

Keston

Keston HEAT 45 Bedienungsanleitung

Keston

Keston Celsius 25 Bedienungsanleitung

Keston

Keston System 30 Bedienungsanleitung

Keston

Keston HEAT 2 45 Benutzerhandbuch

Beliebte Kessel Handbücher anderer Marken

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Bedienungsanleitung

Radijator

Radijator BIO max 23.1 Bedienungsanleitung

Brunner

Brunner BSV 20 Bedienungsanleitung

Buderus

Buderus Logamax GB062-24 KDE H V2 Bedienungsanleitung

Potterton

Potterton 50e Datenblatt

UTICA BOILERS

UTICA BOILERS TriFire Bedienungsanleitung

Joannes

Joannes LADY Series Handbuch

ECR International

ECR International UB90-125 Gebrauchsanweisung

Froling

Froling FHG Turbo 3000 Bedienungsanleitung

Froling

Froling P4 Pellet 8 - 105 Bedienungsanleitung

U.S. Boiler Company

U.S. Boiler Company K2 Bedienungsanleitung

Henrad

Henrad C95 FF Bedienungsanleitung

NeOvo

NeOvo EcoNox EF 36 Bedienungsanleitung

Potterton

Potterton PROMAX SL 12 Bedienungsanleitung

Eco Hometec

Eco Hometec EC 25 COMPACT Bedienungsanleitung

Viessmann

Viessmann VITODENS 200 Leitfaden

Baxi

Baxi Prime 1.24 Bedienungsanleitung

REXNOVA

REXNOVA ISA 20 BITHERMAL Bedienungsanleitung