Before charging
Make sure the outlet and plugs are in good condition.
1. Take out the charging cable and plug it into the electrical outlet securely.
2. Before plugging in your vehicle, first check the maximum current of the power outlet. Change the
output current if needed, following the process outlined in the next section below.
How to change the output current
With the unit plugged in to the wall outlet but not plugged in to the car - The output current setting can
be changed within 60 seconds after plugging it in to the wall outlet, by shaking the unit rapidly side-to-
side 3 or 4 times. You may wish to practice this a few times to get the hang of it. Each time, the current
setting will cycle through one of the four modes (12, 16, 24, or 32A . The current mode is displayed at
the bottom-left corner of the digital display (see illustration below .
Charging process
1. Pull off the protective cover and insert the plug into the vehicle's charging port completely.
2. When the vehicle is charging, the green status indicator light will gradually go on and off
(“pulsing” . The actual charging current, charging time, and voltage are also shown on the screen.
How to stop charging
1. First press the button on the vehicle connector to unlock it, and pull the plug from the vehicle.
2. Then pull the plug from the electrical outlet. It is best to always unplug from the vehicle first, before
unplugging from the electrical outlet.
3. Close the vehicle's charging port door and cover the charging plug.
Description of digital display
Description of control box indicator status
