Kidde 900-0122 Bedienungsanleitung

Assembly Number 900-0122-UK

ALARM

OPERATE

KIDDE

SMOKEAND CARBON

MONOXIDE ALARM

PUSH &

HOLD

TO TEST

WEEKLY

Manual P/N 810-1808-Rev. A

For questions concerning your

Smoke and Carbon Monoxide

Alarm, please call

0800 917 0722

(Mon-Frid 9am-5pm)

Installation instructions

MUST be adhered to.

For your convenience, write down the following

information. If you call our consumer hotline,

these are the first questions you will be asked:

Alarm Model Number (located on back of alarm):

Date of Manufacture (located on the back of the alarm):

Date of Purchase:

Where Purchased:

Alarm Assembly Number (located on the back of the alarm)

With 2-LED Display and Peak Level Memory

Kidde Safety Europe Limited

Battery Operated

COMBINATION SMOKE &

CARBON MONOXIDE ALARM

User’s Guide

TESTED BY THE LOSS

PREVENTION COUNCIL/B.R.E.

BOARD FOR ALARM POINTS TO

BS7860-1996-Carbon Monxide

BS5446-2000-Smoke Alarm

Introduction ..............................................................................Page 1

Product View ........................................................................Pages 2-3

Features ..................................................................................Pages 4-7

Operating/Installation Instructions

Step 1 Installing Batteries ............................................................Page 8

Step 2 Installation Instructions:

A. Recommended Installation Locations ........................Pages 9-10

B. Where Not to Install ..................................................Page 11-12

C. How to Install..................................................................Page 12

D. Tamper Resist Feature ....................................................Page 13

Step 3 Testing the Alarm ..........................................................Page 14

Step 4 Peak Level Memory ........................................................Page 15

What to do if the Alarm Sounds

Smoke Alarm........................................................................Pages 15-16

Carbon Monoxide Alarm ....................................................Pages 17-18

Battery Replacement ......................................................Pages 18-19

General Alarm Maintenance ........................................Pages 19-20

Carbon Monoxide Safety Information

General CO Information............................................................Page 21

Possible Sources ..........................................................................Page 21

CO Safety Tips............................................................................Page 22

Symptoms of CO Poisoning ................................................Page 22-23

Fire Safety Information

Escape Plan..................................................................................Page 23

Fire Prevention ............................................................................Page 24

Warranty and Service Information ............................Pages 25-27

Product Registration ................................................................Page 28

Details on CO alarm installation as stated in Annex B of

BS7860-1996 ................................................................................Page 29

Table of Contents

Thank you for purchasing the Kidde Combination Smoke and

Carbon Monoxide Alarm model 900-0122-UK. This alarm

has a five-year limited warranty. Please take a few minutes to

thoroughly read this user’s guide, and save for future reference.

Teach children how to respond to the alarms, and that they

should never play with the unit. Your Kidde Smoke/CO

Alarm was designed to detect both smoke and carbon

monoxide from any source of combustion in a residential

environment. It is not designed for use in a

caravan or boat. If you have any questions about the

operation or installation of your alarm, please call 0800 917

0722 (Monday to Friday 9am - 5pm). The guide on page 24

will help you determine the correct location of safety products

that will help keep your home a safer place.

Introduction

Product View

ALARM

OPERATE

KIDDE

SMOKE AND CARBON

MONOXIDE ALARM

PUSH &

HOLD

TO TEST

WEEKLY

FRONT

Red LED Light

Green LED Light

Test/Reset

Button

Alarm

Sounder

Product View

WARNING:

BATTERIES 

MISSING



INSTALL

LAST

INSTALL

SECOND

INSTALL

FIRST

BACK

INSTALL

THIRD

INSTALL

SECOND

INSTALL

FIRST

WARNING:

BATTERIES

HAVE BEEN

REMOVED

AA Battery

Battery

Chamber

Battery Placement

• Permanent independent smoke and carbon monoxide

sensors.

• Smoke alarm takes precedence when both fire and

carbon monoxide are present.

• Alarm/Voice message warning system that alerts you of the

following conditions in the manner described below, thus

eliminating any confusion over which alarm is sounding:

FIRE: The alarm/voice pattern is three long alarm beeps

followed by the verbal warning message “FIRE! FIRE!”.

This pattern is repeated until the smoke is eliminated. The

red LED light will flash while in alarm/voice mode.

CARBON MONOXIDE: The alarm/voice pattern is four

short alarm beeps followed by the verbal warning message

“WARNING! CARBON MONOXIDE!” After four

minutes the alarm/voice pattern will sound once every

minute until the unit is reset, or the CO eliminated. The

red Light Emitting Diode (LED) light will flash while in

alarm/voice mode.

LOW BATTERY: When the batteries are low and need

replacing the red LED light will flash and the unit will

“chirp” one time, followed by the warning message “LOW

BATTERY.” This cycle will occur once every minute for

the first hour. After the first hour the red LED light will

continue to flash every minute accompanied by the

“chirp” only sound. The voice message “LOW

BATTERY” will sound once every fifteen minutes during

the “chirp” only cycle. This will continue for at least seven

days.

Features

• One “chirp” every 30 seconds is an indication that the alarm

is malfunctioning. If this occurs call the Consumer Hotline

at 0800 917 0722 (Monday to Friday 9am - 5pm).

• Loud 85 decibel alarm.

• Oversized test button for easy activation.

• Test button performs the following functions:

Tests the units electronics and verifies

proper unit operation

Resets the unit during CO alarm

Peak Level Memory (See page 15).

• Mounting bracket designed for easy orientation of unit.

• Green and red LED lights that indicate normal operation

and alarm status.

Green Light: The green Light Emitting Diode(LED)

flashes every 30 seconds to indicate the unit is operating

properly. The green light also flashes before a CO reading is

taken and when any button is pressed.

Red Light: When a dangerous level of smoke or carbon

monoxide is detected the red Light Emitting Diode (LED)

will flash and the corresponding alarm pattern (depending

on the source) will sound. If the unit malfunctions, the red

LED light will flash and the unit will chirp every 30 seconds

indicating a system problem.

• Powered by three (3) AA batteries.

• Battery lockout system that prohibits installation

without using three batteries.

• Tamper Resist Feature that deters children and others from

removing the alarm.

Features

Smoke Alarm

The smoke alarm monitors the air for products of combustion

that are produced when something is burning or smouldering.

When smoke particles in the smoke sensor reach a specified

concentration, the alarm/voice message warning system will

sound, and be accompanied by the flashing red LED light.

The smoke alarm takes precedence when both

smoke and carbon monoxide are present.

This unit has a smoke sensor that uses the

ionisation technology. Ionisation units are the fastest at

responding to fast flaming fires that give off little smoke.

Photoelectric smoke alarms are the fastest at responding to

slow smouldering, smoky fires. Kidde Safety recommends

for maximum protection that both ionisation and

photoelectric smoke alarms should be installed.

Home fires can develop in different ways and are often

unpredictable. Neither type of alarm is always best, and a

given alarm may not always provide warning of a fire.

CAUTION: Smoke must reach the sensor to be detected.

Smoke alarms may not sense fires starting in chimneys, walls,

on roofs, on the other side of a closed door, or on a different

floor. The alarm may be unable to wake a sound sleeper, or

someone impaired by alcohol or drugs.

Smoke Alarm Features

Carbon Monoxide (CO) Alarm

The carbon monoxide (CO) alarm monitors the air for the

presence of CO. It will alarm when there are high levels of CO

present, and when there are low levels of CO present over a

longer period of time. When a CO condition matches either of

these situations, the alarm/voice message warning system will

sound, and be accompanied by the flashing red LED light. The

carbon monoxide sensor uses an electrochemical technology.

CAUTION: This alarm will only indicate the

presence of carbon monoxide gas at the sensor.

Carbon monoxide gas may be present in other

areas.

Individuals with medical problems may consider using warning

devices which provide audible and visual signals for carbon

monoxide concentrations under 30 ppm.

Carbon Monoxide Alarm Features

Step 1

Installing Batteries:

Batteries were not installed at the factory and must be

installed for the unit to operate! Install the three (3) AA

batteries in the back of the Smoke/CO Alarm.

• The mounting plate must be removed from the back of the

unit to install batteries. To remove, hold the mounting plate

and twist counterclockwise (left).

• The battery polarity markings on the bottom of the battery

compartment must be adhered to.

• Batteries must be installed in the sequence shown. If batteries

seem difficult to install, they’re not being installed in the

proper sequence.

• Smoke/CO Alarm will not engage to bracket unless all three

batteries are installed. Removal of any or all batteries will

render the Smoke/CO Alarm inoperative!

• After the batteries are correctly installed the unit will beep

once and the red LED light will flash.

After 20-30 seconds the green LED light will flash indicating

the unit is now operational.

CAUTION: Your Smoke/CO Alarm is sealed and the

cover is NOT removable!

WARNING:

BATTERIES 

MISSING



INSTALL

LAST

INSTALL

SECOND

INSTALL

FIRST

Operating/Installation Instructions

Batteries Must Be Installed in Order Shown Below:

Install

First

Install

Second

Install

Last

INSTALL

THIRD

INSTALL

SECOND

INSTALL

FIRST

WARNING:

BATTERIES

HAVE BEEN

REMOVED

AA Battery

Inhaltsverzeichnis

Andere Kidde Rauchmelder Handbücher

Kidde

Kidde I9040RV Bedienungsanleitung

Kidde

Kidde 19HI Bedienungsanleitung

Kidde

Kidde 2030-DSR Bedienungsanleitung

Kidde

Kidde WFPL Bedienungsanleitung

Kidde

Kidde P9050 Bedienungsanleitung

Kidde

Kidde 1275H Bedienungsanleitung

Kidde

Kidde 915 Bedienungsanleitung

Kidde

Kidde PE9 Bedienungsanleitung

Kidde

Kidde P4010ACS Bedienungsanleitung

Kidde

Kidde P4010ACSCO Bedienungsanleitung

Kidde

Kidde P3010K-CA Bedienungsanleitung

Kidde

Kidde PE910UK Bedienungsanleitung

Kidde

Kidde FP301 Bedienungsanleitung

Kidde

Kidde I9070 Bedienungsanleitung

Kidde

Kidde KI-PCD Montageanleitung

Kidde

Kidde KN-SMFM-i Bedienungsanleitung

Kidde

Kidde KN-COSM-B Bedienungsanleitung

Kidde

Kidde P4010ACSCO-W Bedienungsanleitung

Kidde

Kidde FIREX KF3 Bedienungsanleitung

Kidde

Kidde WFPCO Bedienungsanleitung

Kidde

Kidde 3050-VDSC10 Bedienungsanleitung

Kidde

Kidde PI 2000 Bedienungsanleitung

Kidde

Kidde 0945CA Bedienungsanleitung

Kidde

Kidde i9010 Bedienungsanleitung

Beliebte Rauchmelder Handbücher anderer Marken

x-sense

x-sense SD19-W Bedienungsanleitung

BRK electronic

BRK electronic First Alert P1010 Bedienungsanleitung

FireAngel

FireAngel Thermoptek ST-622 Bedienungsanleitung

teko

teko Astra-42A Bedienungsanleitung

Safetec

Safetec SDS-2/6 Betriebsanleitung

Siemens

Siemens PE-11C Bedienungsanleitung

System Sensor

System Sensor DH500ACDC Bedienungsanleitung

Resolution Products

Resolution Products RE612 CryptiX Bedienungsanleitung

First Alert

First Alert PC900V Bedienungsanleitung

Eminent

Eminent EM6590 E-Domotica Bedienungsanleitung

Ei Electronics

Ei Electronics Ei Ei168RC Bedienungsanleitung

Carrier

Carrier Kidde Quell Q301 Bedienungsanleitung

VESDA

VESDA VLF-500 Bedienungsanleitung

ELRO

ELRO FS8110 Bedienungsanleitung

Heiman

Heiman SMOKI NS-626PHS Bedienungsanleitung

Regin

Regin SDD-S65 Bedienungsanleitung

Family Gard

Family Gard FG225 Bedienungsanleitung

Greystone

Greystone DSD120 Bedienungsanleitung