KitchenAid 4151847 WHITE Bedienungsanleitung

Installation Instructions

for your new undercounter

COMPACTOR

BEFORE YOU USE YOUR COMPACTOR. . .

Be sure your compactor is properly installed in an appropriate level area and a place suitable for the size, function

and protection of the compactor.

ELECTRICAL REQUIREMENTS

Observe All Governing Codes and Ordinances

A 120-Volt, 60 Hz, AC only, 15Ampere fused electrical supply is required. (Time delay fuse or circuit breaker is

recommended.) It is recommended that a separate circuit serving only this appliance be provided. DO NOT use

an extension cord.

RECOMMENDED GROUNDING METHOD

DO NOT, UNDER ANY CIRCUMSTANCES,

REMOVE THE POWER SUPPLY CORD

GROUND PRONG.

&PRONG

GAOUNOING TYPE

WALL RECEPTACLE

For your personal safety, this appliance must be grounded.

This appliance is equipped with a power supply cord having

a 3-prong grounding plug. To minimize possible shock

hazard, the cord must be plugged into a mating 3-prong

grounding type wall receptacle, grounded in accordance with

the National Electrical Code and local codes and ordinances.

If a mating wall receptacle is not available, it is the personal

responsibility and obligation of the customer to have a

properly grounded 3-prong wall receptacle installed by a

qualified electrician. See Figure 7.

FIGURE 1

--/MPORTANT-

00 NOT REMOVE THIS INSTRUCTION SHEETUNTll READYFORINSTAUATION.

AFTER COMPLETING THE INSTAllA TIOM SAVE THESE INSTRUCTIONS FOR FUTURE USE.

INSTALLATION INSTRUCTIONS

BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND

CAREFULLY. THEY WILL SIMPLIFY THE INSTALLATION.

After removing the shipping carton, be sure to remove

all protective packaging materials such as tape and

shipping pads. Waxy residue from protective shipping

material may be removed from compactor with a mild

solution of liquid household cleaner and water.

2. Your compactor is designed for recessed installation.

A six (6) inch clearance from the right edge of the

drawer front is desirable for added convenience in bag

removal. Also allow twenty-three (23) inches in front of

the appliance for drawer removal. See Figure 2.

COYPAClOR

\L!Gl

IId

FIGURE 2

3. The compactor’s overall dimensions are: Height 34-

1/16” (min.), Depth 24”, Width 15”. Select a cabinet

opening to fit. See Figure 3.

34-l/16”

I fil I(

-l-,5q24-

FIGURE 3

4. Remove drawer as shown:

a. Grip handle and raise front of drawer until it

clears stops. See Figure 4.

b. Grasp side ridges of the drawer and lift drawer

out. See Figure 5.

FIGURE 4 -FIGURE 5

5. Remove any materials that are shipped in the drawer.

Lay two carton corner posts or other protective

material (such as a throw rug) on the floor, then lay

the unit on either of its sides on the corner posts.

The corner posts will protect the finish of the

compactor and the floor. See Figure 6. NOTE: Do not

truck or handle bv console.

HGURE 6

Remove the cardboard shipping pad located on the

bottom. See Figure 6. Stand compactor upright.

7. A grounded receptacle should be located 18” (min.)

from the floor and in the center of the opening. See

Figure Z -

16” (MN I

[

FIGURE 7

Before moving the compactor into position, measure

the cabinet opening as shown in Figure 8. To

determine if height adjustment is required, see steps

9 and 10 below.

Tr ,I +~CA”‘N~; OPENING

DIlLi

- 1 ’ 1

FlGURE 8

9. The rear wheels of your compactor are preset for a

minimum cabinet opening of 34-l/8” to 34-114”

(position A). To adjust for higher openings, tilt the

compactor to one side and support with a corner post

or a screwdriver handle.

CAUTION: Use care so that the compactor does

not drop on your hand.

10.

To adjust the height, remove screw from position “A”

in Figure 9. Move the rear wheel and screw to

position “B or C”:

34-l/4” to 34-l/2” use position “B”

34-l/2” to 343/4” use position “C”

FIGURE 9

Repeat for other rear wheel.

11.

Loosen the screws in the top retaining brackets.

Rotate the brackets from shippiong position to the in-

stall position. Retighten. See

Figure 70.

FIGURE 70

NOTE: Position “A’‘-Compactor frame will be flush with

cabinets. Remove cabinet mount screws from retaining

brackets. Save for use in step

13.

Position ‘73”-Midpoint between position ‘IA” and “C.”

Position “C”-Drawer front will be flush

with

cabinets.

12. When moving or lifting the compactor, use a glove to

protect and cushion your hand.

Toprevent damage to floor covering, do not allow the

rear frame of the compactor to touch the floor when

lifting or rolling. (See

Figure 77.)

/j ‘I

1-l

,-II

FIGURE 11

Align the rear of the compactor with the cabinet

opening. Plug the power cord into a properly

grounded receptacle. See

Figures 7 and 2

Lift the front of the compactor and roll into the opening

until the retaining backets stop the unit.

13. Fasten the retaining brackets to the underside of

the counter top with the screws provided. Use

auxiliary clip for fastening to cabinet front when

counter top mounting method is not permissible. See

Figure 14.

RETAINER BRACKET RETAINER BRACKET

COUNTER TOPMOUNTING Al TERNATECABINET FRONT

HGURE 72

MOUNTING

Lift the front of the compactor until it is parellel with

the cabinet front. Place a screwdriver or other wedge

under the front edge of the compactor.

14. Loosen the screws to the front levelers (do not remove

screws). Pivot the levelers to the floor and retighten

screws.

See Figure 13.

FIGURE 13

15.

Replace the drawer.

ADJUSTABLE TOE PLATE

In some installations, the toe plate may rub the floor

covering. If this occurs, the toe plate clearance may be

changed as follows:

Determine the amount of interference of the toe plate

with the floor covering.

2. Remove the drawer from the unit. (Refer to Step 3 of

the Installation Instructions.)

3. Lay drawer so the front panel faces upward. Protect the

floor.

4. With a ruler and a pencil or chalk, draw a line where

the toe plate interferes with the floor covering.

5. Use a pair of scissors and cut toe plate along this line.

See Figure 14.

Replace drawer in unit.

FIGURE 14

CHANGING FRONT PANEL COLOR

During installation, or in the future, you may wish to change

the front panel color. Your compactor has an extra panel,

which offers four color options. See detail of assembly in

Figure 75.

2 SPACERS

2 TWO SIDED

COLOR PANELS

DRAWER

TRIM

CAUTION: The panels have cut metal edges. Handle

carefully to avoid cuts to hands and scratches on

panels.

To change the front panel color:

Remove the drawer from the unit. (See Step 4 of the

Installation Instructions.)

Remove handle by removing the screws at the top

inside of the drawer.

Remove spacer and inside panel.

See Figure 15.

Remove spacer and center panel if supplied.

Remove outside front panel. DO NOT SCRATCH.

Select the color you wish to have showing and

carefully push the panel in the drawer trim.

Replace the spacer, then carefully replace the

remaining panels and spacers on the inside.

Replace the handle with the screws removed in Step

2 above.

9. Replace the drawer.

The color of the console may be

changed by using one of the following

console inserts from your dealer:

PART NO. 4151847 WHITE

PART NO. 4151848 ALMOND

CAUTION:

REPLACEHANDLEBEFOREOPERATING

COMPACTORTOAVOIDINJURYFROMMOVINGPARTS.

CUSTOM DECORATING

In place of the panel pack, you may use a VI” thick wood

panel to match your cabinets or other suitable decorative

material.

See Figure 76.

To do so:

Follow Steps 1 through 5 under Changing Panel

Color. Also remove all cardboard.

2. Slide decorative panel between trim pieces.

3. Remount handle with screws previously removed.

4. Slide the drawer into the unit.

5. Paint, wallpaper, fabric, etc., can be applied directly

to one of the panels.

21%”

I-

14%”

FlGURE 16

KITCHENAID

KitchenAid

ST. JOSEPH, MI 49085

PART

NO. 4151913

REV. B

Dieses Handbuch passt für folgende Modelle

Andere KitchenAid Müllentsorgung Handbücher

KitchenAid

KitchenAid KCDS075T0 Bedienungsanleitung

KitchenAid

KitchenAid INTEGRATED COMPACTOR Bedienungsanleitung

KitchenAid

KitchenAid KCDC250 Bedienungsanleitung

KitchenAid

KitchenAid KCDS075T Bedienungsanleitung

KitchenAid

KitchenAid KCDS100T - 1 HP Continuous Feed Waste... Bedienungsanleitung

KitchenAid

KitchenAid KCDB250G2 Bedienungsanleitung

KitchenAid

KitchenAid KCDB150 Bedienungsanleitung

KitchenAid

KitchenAid KCDI075V0 Bedienungsanleitung

KitchenAid

KitchenAid KUCS03FSSS Bedienungsanleitung

KitchenAid

KitchenAid KBDS100T - NA Batch Feed 1 HP MultiGrind Service-Handbuch

KitchenAid

KitchenAid Garbage Disposal Bedienungsanleitung

KitchenAid

KitchenAid Superba KCDS100T Bedienungsanleitung

KitchenAid

KitchenAid INTEGRATED COMPACTOR Bedienungsanleitung

KitchenAid

KitchenAid IMPERIAL KCDI075V Bedienungsanleitung

KitchenAid

KitchenAid KCDB250S1 Bedienungsanleitung

KitchenAid

KitchenAid KCDB250G - Food Waste Disposer Bedienungsanleitung

KitchenAid

KitchenAid KCDS100T - 1 HP Continuous Feed Waste... Handbuch

KitchenAid

KitchenAid KCDB250G1 Bedienungsanleitung

KitchenAid

KitchenAid KCDB250S0 Bedienungsanleitung

KitchenAid

KitchenAid KBDS100T0 Bedienungsanleitung

KitchenAid

KitchenAid KBDS100T - NA Batch Feed 1 HP MultiGrind Bedienungsanleitung

KitchenAid

KitchenAid TC707S1 Bedienungsanleitung

KitchenAid

KitchenAid SUPERBA KCDS075T Bedienungsanleitung

KitchenAid

KitchenAid KBDS250X - 1 HP Superba Batch Feed Disposer Installationshandbuch

Beliebte Müllentsorgung Handbücher anderer Marken

Insinger

Insinger I-6 Bedienungsanleitung

Franke

Franke CE-50 Betriebsanleitung

Leafield Environmental

Leafield Environmental Envirobank 140 Merkblatt

Meiko

Meiko TopCut B Bedienungsanleitung

Gladiator

Gladiator Garage Compactor Bedienungsanleitung

Maytag

Maytag DFC1500 Installationshandbuch

Weber mt

Weber mt CR 7 Betriebsanleitung

THERMEx

THERMEx WASTEMINATOR II Bedienungsanleitung

Weber mt

Weber mt CR 7-II Hd Betriebsanleitung

ROBINHOOD

ROBINHOOD SE390 Bedienungsanleitung

Whirlpool

Whirlpool GC2000PE2 Bedienungsanleitung

Scheppach

Scheppach HP3000S Montageanleitung

Haigh

Haigh Quattro Vanguard Original Bedienungsanleitung

Maxmatic

Maxmatic 5000 Technisches Datenblatt

InSinkErator

InSinkErator Model SS-100 Bedienungsanleitung

Toro

Toro FP-2200 Bedienungsanleitung

Elephants Foot

Elephants Foot eDiverter Bedienungsanleitung

Zanussi

Zanussi DU 4400 Bedienungsanleitung