Kleenmaid LW8014 Leitfaden

laundry collection

Instructions for installation

Front-load Washing Machine

Model No.: LW8014

INSTALLATION INSTRUCTIONS

Check list for installation of Kleenmaid Washing Machine

1. Contact customer by phone to book a suitable time and date to carry out the installation of

the Kleenmaid washing machine. This installation is to occur as soon as possible.

a. Advise customer the old machine needs to me removed and the area clear ready

for installation.

b. The customer may wish to pay you extra to do this and take the old machine away.

This is to be quoted by the service agent.

2. On arrival at the customers house check;

a. Area cleared for installation of new washing machine

b. Sufficient space to fit new washing machine

c. Take photos of the laundry area to before installation to record any previous

damage to area and condition of install area.

d. Check customer has suitable power and water connections.

3. Complete installation as per Installation instructions

4. Test washing machine by running a 12 min cycle as per the user manual.

a. Check for leaks and vibrations

b. Ensure the washing machine is leveled correctly.

5. Carry out customer familiarisation on the Kleenmaid washing machine as per Getting to

know the New Kleenmaid washing machine instructions.

6. Remove all packaging and rubbish and clean the installation area. Do not leave any

packaging or rubbish at the customers home.

7. Take a set of final photos to show your finished installation and keep both sets of photo

for later use.

Page | 4

Fig 1

INSTALLATION INSTRUCTIONS

Selecting an area for your new Kleenmaid washing machine

To ensure silent and vibration free operation of the machine it should beinstalled ona non-

sliding and firm base. Do not install the machine on carpet or a surface which would prevent

airflow to its base.

Make sure the area isadequately ventilated and there is sufficient room to open the door

completely.

Unpacking your new machine

The machine has been packaged to protect it from any damage that might occur during

transportation. The packaging materials are environmentallyfriendly and should be

recycled. Plastics wrappings should be disposed of safely and kept out of the reach of

children. Keep the small parts found inthedocument package away from thereach of

children and babies. Some water may be left in your machine after testing conducted during

factory quality Control procedures.

Removing the transportation safety screws

Before operating the washing machine remove the 4 transportation screws and rubber

spacers from the back of the machine (see figure 1). Failure to remove the screws can

cause heavy vibration, noise and product malfunction which may void the warranty.

The safety screws should be removed by rotating anti-clockwise with an appropriate sized

spanner (see figure 2). Fully remove the screws (figure 3) and then fit the plastic screw

caps supplied in the accessories bag into the holes from which the screws have been

removed (figure 4).

The transportation safety screws should be stored in case the machine has to be moved in

the future.

The transportation screws must be removed

before operating the machine. Any faults

occurring in machines which are operated with

the transportation screws fitted will not be

covered by the warranty.

Page | 5

Fig 5 Fig 6

Leveling the machine

The machine must be level and stable at all times in order to operate correctly. It has four

adjustable feet (see figure 5) to ensure this isthecase.

Fig 2 Fig 3 Fig 4

To adjust the height of the feet loosen the plastic locking wheel and rotate the hexagonal foot in

either direction to adjust up ordown (figure 6). Once thefeet are at the required level tighten the

plastic locking wheel upwards again. Check themachine islevel using a spirit level.

Do not put wood or other materials under your machine to compensate foran uneven floor. Be

careful not to change the set level of the feet when cleaning under the machine or if it needs to

be moved.

Page | 6

Electrical connection

The washing machine requires a220-240V and 50 Hz power supply.

The mains cord of your washing machine is fitted with an Australian regulation earthed plug.

This plug should be connected to an earthed 10 amp socket. The maximum current value

of the fuse should be 10 amps.

If you don’t have a socket and fuse complying with this specification, please have one

installed by aqualified electrician. Kleenmaid does not take responsibility for any damages

which occur due to ungrounded usage or incorrect electrical installation.

Water inlet hose connection

To connect the water inlet hose follow the instructions below.

The machine requires awater supply with pressure of 0.1-1.0 Mpa. Note, 0.1 Mpa pressure

is equivalent to water flow of 8 litres of water per minute.

Check there are no leaks by opening the water supply tap completely after making the

connections.

Ensure that once connected the new water inlet hose is not bent, broken, crushed or

stretched.

Frozen hoses can tear and explode. In regions where the ambient temperature isbelow

zero, this might endanger the safe operation ofyour machine.

Operating the machine using a lower than specified voltage supply will

cause the lifetime and performance of your machine to be reduced.

Page | 7

The machine has a single cold water inlet.

The white-capped hose should be connected

to a cold water tap and to the inlet only.

To eliminate water leakages a nut is provided

in the hose package. Fit this nut to the end of

the supplied inlet hose and connect to a ¾˝,

threaded water supply tap.

Connect the white elbow end of the water inlet

hose to the white inlet valve on the rear side of

the machine. Tighten all connections by hand.

3/4”3/4”

Use only the new water inlet hose supplied with your machine. Never

use old, used or damaged water inlet hoses.

Page | 8

Fig 7

Water drain connection

The end of the water drain hose can be fitted directly into a dirty water drain hole or

clamped to an outlet joint of the basin drain elbow (figure 7).

Never attempt to extend the water drain hose by jointing or put the drain hose of your

machine in a vessel or bucket.

Make sure that the water drain hose is not bent, buckled,

crushed or stretched.

Please note: The water drain hose should be mounted at a

minimum 60cm and maximum 100cm above the floor.

Page | 9

GETTING TO KNOW THE NEW

KLEENMAID WASHING MACHINE

Overview

Electronic display

Washing compartment

(“drum”)

Pump filter cover

Programme knob

Detergent drawer

Front View

Page | 10

Technical specifications

Operating voltage / frequency

(220-240) V~/50Hz

Total current

10 A (amps)

Water pressure

Maximum: 1 Mpa

Minimum : 0.1 Mpa

Total power

2200 W

Maximum dry laundry capacity

8 kg

Spinning revolution

1400 revolutions per minute (RPM)

Number of programmes

Dimensions (H x W x D)

845mm x 597mm x 582mm

The detergent drawer

The detergent drawer comprises

three compartments; the pre-wash

detergent compartment (I), the main

wash detergent compartment (II) and

the fabric conditioner or starch

compartment (Blue).

When using a liquid laundry

detergent insert the separation plate

into the slots in compartment II, and

do not fill over the MAX level.

The pre-wash detergent compartment

should only be used in conjunction

with a programme that includes a

pre-wash.

Pre-wash detergent compartment (I)

Fabric conditioner / starch compartment (Blue)

Main wash detergent compartment (II)

The programme knob

Use the programme knob to select the programme you want to use.

The knob may be rotated in either direction.

Ensure that the programme knob indicator mark is exactly on the programme you want to

select.

For a detailed description of each programme see the table on page 20.

The digital display

When aprogramme is selected the digital display will show the default options for that

programme and the estimated completion time.

Depending on the programme some of these options such as water temperature, spin

speed and stain level may be varied manually by pressing the corresponding button. See

theprogramme table on page 20 to understand what the default options are for each

programme and which ones may be varied.

Auxillary functions may be selected from the digital display. See page 16 for a detailed

description of the auxillary functions and their operation.

Also shown on the digital display are a number of warning and information symbols. These

are described further on page 18.

] in the digital display shows the status ofThe progress bar [

your programme whilst in operation.

Andere Handbücher für LW8014

Inhaltsverzeichnis

Andere Kleenmaid Waschmaschine Handbücher

Kleenmaid

Kleenmaid LWT1210 Bedienungsanleitung

Kleenmaid

Kleenmaid KFL1506 Bedienungsanleitung

Kleenmaid

Kleenmaid KFL850 Bedienungsanleitung

Kleenmaid

Kleenmaid KAW351 Bedienungsanleitung

Kleenmaid

Kleenmaid KFL2000 Einrichtungshandbuch

Kleenmaid

Kleenmaid KAW693 Bedienungsanleitung

Kleenmaid

Kleenmaid KFL806 Betriebsanleitung

Kleenmaid

Kleenmaid LTK95AN3050 Bedienungsanleitung

Kleenmaid

Kleenmaid KFL1500 Bedienungsanleitung

Kleenmaid

Kleenmaid LTK95AN3050 Bedienungsanleitung

Kleenmaid

Kleenmaid 38903R5 Bedienungsanleitung

Kleenmaid

Kleenmaid KFL2000 Bedienungsanleitung

Kleenmaid

Kleenmaid LWK73AW-3050 Bedienungsanleitung

Kleenmaid

Kleenmaid KAW793 Bedienungsanleitung

Kleenmaid

Kleenmaid LTK95AN3050 Bedienungsanleitung

Kleenmaid

Kleenmaid KFL800 Bedienungsanleitung

Kleenmaid

Kleenmaid TX768A Bedienungsanleitung

Kleenmaid

Kleenmaid TX728A Bedienungsanleitung

Kleenmaid

Kleenmaid KFL1000 Bedienungsanleitung

Kleenmaid

Kleenmaid lwg74 Bedienungsanleitung

Kleenmaid

Kleenmaid LW8014 Bedienungsanleitung

Kleenmaid

Kleenmaid KFL1600 Bedienungsanleitung

Kleenmaid

Kleenmaid KAW793 Bedienungsanleitung

Kleenmaid

Kleenmaid KFL1600 Bedienungsanleitung

Beliebte Waschmaschine Handbücher anderer Marken

Tricity Bendix

Tricity Bendix AW 1000 W Produkthandbuch

Panasonic

Panasonic NA-F60L5WRB Bedienungsanleitung

GE WSLP1500 Handbuch

Electrolux

Electrolux EWF1284EDW Bedienungsanleitung

Bosch

Bosch WAN2829BSN Bedienungsanleitung

LG TV2516DV3B Bedienungsanleitung

LG TH2517DSAV Bedienungsanleitung

VESTEL

VESTEL CMH-XL 7510 TE Bedienungsanleitung

AEG

AEG 74335 Bedienungsanleitung

Johnson

Johnson JWF721A Bedienungsanleitung

Beko

Beko WTE7604XLW0 Bedienungsanleitung

Danby

Danby DTT100A1WDB Montageanleitung

Amica

Amica WA 14 Ex Bedienungsanleitung

Daewoo

Daewoo DWD-F1222 Bedienungsanleitung

Bosch

Bosch WAS28461AU Bedienungsanleitung

Miele

Miele PW 6080 Vario Bedienungsanleitung

Finlux

Finlux FLX108CF220 Bedienungsanleitung

Whirlpool

Whirlpool 3LBR5132AN0 Bedienungsanleitung