KMC Controls STE-1451 Bedienungsanleitung

STE-1451 1 Installation Guide

Installation Guide

Contents

Mounting 1

Connections and Wiring 1

Speciﬁcations 1

Maintenance 1

Conﬁguration 2

More Information 2

Important Notices 2

Outside Air Temperature Sensor

STE-1451

Mounting

Maintenance

No routine maintenance is required. Each compo-

nent is designed for dependable, long-term reliability

and performance. Careful installation will also

ensure long-term reliability and performance. If dirt

clogs the air holes at the boom, remove it.

Connections and Wiring

1. Remove the two cover screws and cover.

NOTE: Removal of only one screw is required. The

other screw can be loosened, and the cover

can be swung out of the way.

2. Feed wires through the conduit opening.

NOTE: Use 18 to 24 AWG shielded wiring for all

connections. Do not locate the device wires

in the same conduit with wiring used to

supply inductive loads such as motors.

Make all connections in accordance with

national and local codes.

3. Make connections to the two wire leads with

either bu-splices or solder. (Using wire nuts is

not recommended.) The two-wire sensor is not

polarity sensitive.

4. Plug the conduit with sealant to prevent air

inltration.

5. Check that the rubber weather gasket is placed

correctly between the enclosure and cover.

6. Reinstall the cover and tighten the screws to

create a weather-resistant seal.

Designed specically for outside air temperature

measurement, this device comes in an aluminum LB-

style enclosure.

For best results, locate the sensor on the north side

of the structure (when located north of the equator)

high under the eaves or another protected area to

prevent incorrect readings from direct sunlight and

damage due to the elements. Also, avoid proximity

to other heat sources, vents, power wires, or a large

thermal mass.

1. Run 1/2" conduit through the wall.

2. Aach the conduit to the sensor enclosure’s CW

1/2" NPT ing with a suitable coupler (such as a

Chase closed nipple).

NOTE: The sensor air holes must face down to

prevent the accumulation of dirt or water.

Down

North

1/2"

Conduit

OAT Sensor

Speciﬁcations

Sensor Type III thermistor, 10K ohm

@ 77° F (25° C)

Temperature Limits –40 to 122° F (–40 to 50° C);

5 to 95 % RH non-condensing

Wiring 22 AWG wire leads

Case Aluminum LB-style, IP65

(NEMA 4X)

STE-1451 2 Installation Guide

KMC Controls, Inc.

19476 Industrial Drive

New Paris, IN 46553

574.831.5250

www.kmccontrols.com

[email protected]

Important Notices

The KMC logo and KMC Controls are registered

trademarks of KMC Controls, Inc.

be reproduced, transmied, transcribed, stored in a

retrieval system, or translated into any language in

any form by any means without the wrien permis-

sion of KMC Controls, Inc.

The material in this document is for information

purposes only. The contents and the product it

describes are subject to change without notice.

KMC Controls, Inc. makes no representations or

warranties with respect to this document. In no event

shall KMC Controls, Inc. be liable for any damages,

direct or incidental, arising out of or related to the

use of this document.

Conﬁguration

For controller conguration, see the Type III Sensors

Applications Guide on the KMC web site.

More Information

For troubleshooting, con-

troller conguration, and

other information, see the

Type III Sensors Applica-

tions Guide on the KMC

web site. For additional

information, see the STE-

1400 Series Data Sheet on

the KMC web site.

Andere KMC Controls Temperaturregler Handbücher

KMC Controls

KMC Controls STE-1400 Series Benutzerhandbuch

KMC Controls

KMC Controls STE-6012 Benutzerhandbuch

KMC Controls

KMC Controls STE-9000 Series NetSensor Bedienungsanleitung

KMC Controls

KMC Controls STE-6010 Bedienungsanleitung

KMC Controls

KMC Controls STE-6010 Benutzerhandbuch

KMC Controls

KMC Controls STE-1415 Bedienungsanleitung

KMC Controls

KMC Controls STE-5000 Series Bedienungsanleitung

KMC Controls

KMC Controls STE-9000 Series Bedienungsanleitung

KMC Controls

KMC Controls STW-6014 Bedienungsanleitung

Beliebte Temperaturregler Handbücher anderer Marken

Swegon

Swegon LUNAd MB Bedienungsanleitung

Lucky Reptile

Lucky Reptile Thermo Control II Bedienungsanleitung

SENSORMETRIX

SENSORMETRIX Argon 100 Bedienungsanleitung

Fuji Electric

Fuji Electric PXE4 Bedienungsanleitung

Yuyao gongyi

Yuyao gongyi XMT-808 series Bedienungsanleitung

Selec

Selec TC544C Bedienungsanleitung

P.W. KEY

P.W. KEY rt-208gt Bedienungsanleitung

BH Thermal

BH Thermal BriskONE Bedienungsanleitung

West Control Solutions

West Control Solutions KS 45 Kurzanleitung

MCS

MCS RITC-15B Bedienungsanleitung

SMC Networks

SMC Networks Thermo-con INR-244-639 Bedienungsanleitung

eltherm

eltherm Ex-TC It Series Bedienungsanleitung

Omron

Omron C200H-TV Series Bedienungsanleitung

industrie technik

industrie technik CA1 Bedienungsanleitung

KRAL

KRAL EET 32 Bedienungsanleitung

dixell

dixell XR420C Verdrahtungsschema

Opt Lasers

Opt Lasers TEC-8A-24V-PID-HC Bedienungsanleitung

Vaillant

Vaillant VR 92/3 Bedienungsanleitung