DC101
Operation
The system operation should be quite straightforward.
Door Chime
Installation Instructions v1.1
Press the door chime button and the chime is sounded
throughout the system.
Warning: To be installed and/or used in accordance with appropriate
electrical codes and regulations.
When activated by pressing any of the three door buttons, the
DC101 sends a command to the amp or controller to turn on or
“override” all zones to a preset volume then runs the chime
sound at a gain set by the installer.
Description: The DC101 door chime module is specifically designed
for use with the MVP44 and MVP64 controller-amps as well as the
MR640 controller. It features connections for up to three lighted or
non-lighted push button door buttons (front, side and rear door) with
has four sound bank selections of three each (8 distinct chime
sounds).
After the door chime sound ends, all zones revert to their
previous volume and input states.
Occasionally the system may become confused if a door chime
was pressed while something else was going on in the
command system of the controller or amplifier controller. In
this case just change the input or shut the system down as
desired from any keypad. If this does not work turn the power
off then on to the controller or controller amp and the system
will reset.
When activated by pressing any of the three door buttons, the DC101
sends a digital signal to the amp or controller to turn on or “override”
all zones to a preset volume then runs the chime sound at a gain set
by the installer. After the door chime sound ends, all zones revert to
their previous volume and input states.
Key Features:
Warranty • High quality door chime sound in all rooms.
Knoll Systems warrants Illusion Amplifiers sold in the USA and Canada by
authorized Knoll dealers to be free of defects in materials and workmanship.
This warranty extends for three full years from the date of purchase by the
original consumer. Any products returned to Knoll Systems and found to be
defective by Knoll Systems within the warranty period will be repaired or
replaced at Knoll Systems option, at no charge. Knoll Systems will not be
responsible for the actual cost of installation or removal of the product, nor for
any incidental or consequential damages. Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the above
limitation may not apply to you. This warranty gives you specific legal rights.
You may have additional legal rights that vary from state-to-state.
• Chime sound of front, rear and side doors is installer or
end user selectable in four different banks of chimes.
• Small size. Fits almost anywhere.
• Easy to install.
• Supplies power for lighted door buttons.
• Shipped with PS1202 power supply.
DC101 size is 115 x 43x 107 mm (4.5"w x 1.7"h x 4.2"d). Installation
The DC101 requires that door buttons are normally open, momentary
style. Lighted buttons should be 12-24 volts that short out while the
button is pushed. The system should only be installed with the amp-
controller powered off and the mains power is unplugged.
Knoll Systems
145 Tyee Drive Point Roberts, WA 98281
12140 Horseshoe Way, Richmond, BC V7A 4V4
Power for the DC101 is from the PS1202 power supply (included) and
is usually left on.
Tel: (604) 272 4555, fax (604) 272 5595
Made in Canada
