6
1.4 Remote control ON/OFF
Remote control (on): The ballast units are supplied with an active remote control
mode. The function is as follows: If the operating fixture becomes switched off due
to an interruption of the mains supply, it will turn on again, as soon as the mains
supply begins to function.
Remote control (off): If the fixture should not be switched on automatically when
the current comes back, this function can be activated on the ballast unit by re-
plugging the contact bridge into another socket. The contact bridge is situated on a
printed circuit board in the inside of the unit, and may only be moved by a
specialist.
2. Operation of the lamp
2.1 Mounting and dismounting the reflectors and Softbox adapter
Before mounting the reflector or Softbox adapter, the knurled screw of the locking
mechanism (8) must be loosened by turning it counter-clockwise. A reflector or
Softbox adapter is now inserted with the marking towards the top by introducing
the 3 pins into the corresponding slots (11) and turning the reflector clockwise until
the pin (9) snaps into the locking position.
By tightening the knurled screw (8) the reflector or Softbox adapter are securely
locked. For safety reasons the knurled screw must always be well tightened.
Before taking off the reflector or Softbox adapter, the knurled screw of the locking
mechanism must be loosened by turning it counter-clockwise. By pulling the
mechanism backwards, away from the reflector, the locking mechanism is
loosened and the reflector or Softbox adapter can be turned counter-clockwise to
be removed.
2.2 Mounting and dismounting the accessories to the Open Face reflector
4-leaf barn door: Before mounting the barn door, completely loosen the knurled
knob on the locking (20) mechanism. Place the movable roller (21) on the reflector
edge (15), push down to compress the spring in the mechanism and slide the
remaining two rollers over the reflector edge. To ensure that the three rollers have
a secure hold on the reflector edge, rotate the 4-leaf barn door. Now that all 3
rollers are secured, tighten the knurled knob (20). For safety reasons, the knurled
screw must be tight during operation of this light at all times.
Conversion filter/ diffusion filter: The filter slot is part of the 4-leaf barn door.
Turn the 4-leaf barn door until the flap of the filter slot (18) is at the top. Open the
flap of the filter by the handle, insert it completely into the filter slot (18) moving it
45° sideways until the filter handle corresponds with the safety hole of the grip at
the corner of the barn door. For safety reasons check that the slot flap is
completely closed.
