Kodak pixpro s-1 Bedienungsanleitung
User Manual
ii 1
ii 1
Declaration of Conformity
Responsible Party: JK Imaging Ltd.
Address: 1411 W. 190th Street, Suite 550, Gardena, CA 90248, USA
Company Website: www.kodakcamera.jkiltd.com
INDUSTRY CANADA
This device complies with Canadian RSS-210.
This device complies with Industry Canada license-exempt RSS standard (s).
Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils
radio exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes:
(1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter
tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement
indésirable.
Before You Start
1
23
Radiation Exposure Statement:
The product comply with the Canada portable RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual. The further RF
exposure reduction can be achieved if the product can be kept as far as possible from the user
body or set the device to lower output power if such function is available.
Déclaration d'exposition aux radiations:
Le produit est conforme aux limites d'exposition pour les appareils portables RF pour les
Etats-Unis et le Canada établies pour un environnement non contrôlé.
Le produit est sûr pour un fonctionnement tel que décrit dans ce manuel. La réduction aux
expositions RF peut être augmentée si l'appareil peut être conservé aussi loin que possible
du corps de l'utilisateur ou que le dispositif est réglé sur la puissance de sortie la plus faible si
une telle fonction est disponible.
For Customers in Europe
This symbol [crossed-out wheel bin WEEE Annex IV] indicates separate collection
of electrical waste and electronic equipment in the European countries. Please do
not throw the equipment into domestic refuse. Please use the return and collection
systems available in your country for proper, safe disposal of this product.
"CE" mark indicates that this product complies with the European requirements for
safety, health, environment and customer protection. "CE" marked cameras are
intended for sales in Europe.
Hereby, [AOF Imaging Technology Co., Ltd.], declares that this [Wireless DSC] is in
compliance with the essential requirements and other relevant provisions of Directive
1999/5/EC.
23
Europe – EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE Directive 1999/5/
EC. The following test methods have been applied in order to prove presumption of
conformity with the essential requirements of the R&TTE Directive 1999/5/EC:
- EN 60950-1: 2006+A11:2009 +A1:2010 +A12:2011
Safety of Information Technology Equipment
- EN 62311: 2008/ Article 3(1) (a) and Article 2 2006/95/EC)
Assessment of electronic and electrical equipment related to human exposure
restrictions for electromagnetic elds (0 Hz-300 GHz) (IEC 62311:2007 (Modied))
- EN 300 328 V1.7.1: 2006
Electromagnetic compatibility and Radio spectrum Matters (ERM); Wideband
Transmission systems; Data transmission equipment operating in the 2.4 GHz ISM
band and using spread spectrum modulation techniques; Harmonized EN covering
essential requirements under article 3.2 of the R&TTE Directive.
- EN 301 489-1 V1.9.2: 2008
Electromagnetic compatibility and Radio Spectrum Matters (ERM); Electro Magnetic
Compatibility (EMC) standard for radio equipment and services; Part 1: Common
technical requirements.
- EN 301 489-17 V2.2.1: 2012
Electromagnetic compatibility and Radio spectrum Matters (ERM); Electro Magnetic
Compatibility (EMC) standard for radio equipment and services; Part 17: Specic
conditions for 2.4 GHz wideband transmission systems and 5 GHz high performance
RLAN equipment.
For Customers in the U.S.A.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
45
This equipment has been tested and found to comply with the limits for a Class Bdigital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Radiation Exposure Statement:
The product comply with the FCC portable RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual. The further RF
exposure reduction can be achieved if the product can be kept as far as possible from the user
body or set the device to lower output power if such function is available.
45
About this Manual
Thank you for purchasing the KODAK PIXPRO digital interchangeable-lens camera. Please
carefully read this manual and keep it well for future reference.
JK Imaging Ltd. reserves all rights of this document. No part of this published manual may
be reproduced, transmitted, transcribed, stored in a retrieval system or translated into
any language or computer language, in any form, by any means, without the prior written
permission of JK Imaging Ltd..
All trademarks mentioned in this manual are used for identication purposes only and are
properties of their respective owners.
This manual is to introduce you how to operate this KODAK PIXPRO digital
interchangeable-lens camera. JK Imaging Ltd. has tried its utmost to ensure the
correctness of all contents here, but reserves the right to modify. All of these contents are
subject to change without prior notice.
Throughout this manual, the following symbols are used to help you locate information
quickly and easily:
Indicates useful information.
Indicates precautions are to be taken while operating the camera.
In introducing you how to operate this camera, the following symbols may appear to
facilitate your understanding:
[Button name]: When one button on the camera cannot be indicated by an icon, the
symbol [ ] is used to indicate it.
「Item properties」: The optional properties in the camera interface are indicated by the
symbol「 」.
67
67
Safety Notes
Safety notes for this camera
Do not drop the camera or allow it to hit
solid objects.
Do not disassemble or repair this camera
by yourself.
To prevent the camera from being
damaged by moisture, do not use or store
the camera in very humid environments,
such as in rain or near bodies of water.
Do not use or store the camera in dusty
places or on a beach to prevent dust or
sand from entering the camera, causing
possible damage to it.
Do not use or store the camera in a hot
environment or under direct sunlight.
Do not use or store the camera near a
powerful magnetic eld, for example near
a magnet or transformer.
Turn the camera off, remove the battery
and the memory card, and dry it within
24 hours if water accidentally comes in
contact with the camera.
When you take the camera from a
cold place to a warmer environment,
condensation may occur. Please wait for
a reasonable period of time before you
turn it on.
Before you remove the battery and
memory card, the camera should be
turned off.
In demounting the lens, the image sensor
will be exposed. To avoid scufng, please
don't touch the image sensor.
Do not place ngers in the bayonet of
camera. As the components of image
sensor are precise, failures or damages
may be caused.
In cleaning the camera body, please don't
use corrosive cleaning agents or those
with alcohol or organic solvent.
Advise to use soft lens cloth to regularly
clean the camera's body and lens mount.
If this camera is not in use for a long time,
please keep it in a dry and clean condition.
Our company will not pay compensation
for any failure of playback of pictures or
videos caused by improper operation.
2
67
67
Safety notes for battery
Please use the battery with the same
type as the attached.
Please use the attached charger to
charge the battery.
If the liquid leaking from the battery
contacts with your skin, please
immediately ush with water and seek
medical treatment. If the liquid leaks into
the camera, please contact the retailer.
Please dispose the wasted battery
in accordance with local (national or
regional) regulations.
To prevent the battery from being
damaged, do not drop the battery or allow
it to hit solid objects or to be scratched by
the objects.
Do not let the battery come in contact
with metal objects (including coins) to
avoid short circuiting, discharging,
excessive heat, or possible leakage.
Do not attempt to disassemble the
battery.
Do not expose the battery to water.
Always keep the battery contacts dry.
Do not heat the battery or throw it into a
re to avoid a possible explosion.
Do not store the battery in a hot
environment or in direct sunlight.
If an overheating happens during
charging or use, please immediately stop
charging or using and then take out the
battery with care in shutdown mode to
wait it for cooling.
If it is not used for a long time, please
remove the battery for proper keeping.
In a colder environment, the performance
of the battery could be noticeably
reduced.
When you install the battery, install it
according to the positive and negative
markings on the battery compartment.
Never force it into the battery
compartment.
89
Do not modify the name of the les or
folders of the memory card using your
PC. Modifying the le names may cause
the les to not be recognized on the
camera or a possible error may occur.
A photo taken with the camera will be
stored in the folder that is automatically
generated on the memory card. Do not
store photos that are not taken using
this camera in these folders as the
pictures cannot be recognized during the
playback.
When you insert a memory card, make
sure the notch of the card matches the
markings on the top of the card slot.
Safety notes for memory card
We suggest buying only well-known,
name brand memory cards to ensure
peak performance.
Format the memory card using the
camera before you use it or insert a new
one.
Do not make the memory card fall off
from high places or hit by heavy objects
to prevent damaging it.
Do not attempt to disassemble or repair
the memory card.
Do not expose the memory card to water.
Always keep it dry.
Do not remove the memory card when
the camera is turned on. Otherwise, the
memory card could be damaged.
Do not directly edit the data on the
memory card. Copy the data to your PC
before you edit them.
When the camera is stored for a long
period of time, be sure to download your
photos and remove the memory card.
Store it in a dry environment.
89
Attentions for Use of Lens
Remove dirt and dust on the front and
rear lens caps before and after use.
Wipe your lens using professional lens
cleaning paper.
Do not mount your lens at an angle to
your camera body to avoid scratching the
mount.
To protect the lens surface, use the lens
cap when you are not using the lens.
Mount or remove your lens in a place
with little dust.
After the lens is removed from the
camera, install the front and rear lens
caps and place it with the bottom facing
upwards to avoid scratches to the surface
and contact.
Be careful not to stain or damage the
contact.
Do not expose the camera lens to direct
sunlight for long periods of time to avoid
damage.
Do not place the product where it can be
reached by the infants and children to
avoid injury.
When you do not use your lens for a long
period of time, store it in a dry and clean
place.
Other Safety Notes
Do not disconnect the power or turn the
camera off during the update process.
Doing so may cause incorrect data to be
written and the camera may not power on
later.
Do not hang the neck strap of the camera
around the neck of a child.
When using your camera on an airplane,
observe the relevant rules specied by
the airline.
Due to the limitations of manufacturing
technology, the LCD screen may have a
few dead or bright pixels. These pixels do
no effect the quality or performance of the
camera, photos or video.
Do not expose the LCD screen to water.
In a humid environment, only wipe it with
a soft and dry cleaning cloth.
If the LCD screen is damaged and the
liquid crystal comes into contact with
your skin, wipe your skin with a dry cloth
immediately and rinse it with clean water. If
liquid crystal comes into contact with your
eyes, wash them with clean water at least
for 15 minutes and seek immediate medical
attention. If you accidentally swallow liquid
crystal, rinse your mouth immediately and
seek medical attention.
Andere Handbücher für pixpro s-1
1
Inhaltsverzeichnis
Andere Kodak Digitalkamera Handbücher
Kodak
Kodak KC50/55 Bedienungsanleitung
Kodak
Kodak EasyShare M1073 IS Service-Handbuch
Kodak
Kodak CD14 - EXTENDED GUIDE Service-Handbuch
Kodak
Kodak KE85 Zoom Bedienungsanleitung
Kodak
Kodak CD90 - Easyshare Digital Camera Bedienungsanleitung
Kodak
Kodak 1500 Bedienungsanleitung
Kodak
Kodak Z981 - Easyshare Digital Camera Bedienungsanleitung
Kodak
Kodak DX4330 - Easyshare Zoom Digital Camera Bedienungsanleitung
Kodak
Kodak EASYSHARE C183 Bedienungsanleitung
Kodak
Kodak P712 - Easyshare 7.1MP Digital Camera Bedienungsanleitung
Kodak
Kodak Astro Zoom PIXPRO AZ652 Bedienungsanleitung
Kodak
Kodak M1093 - EASYSHARE IS Digital Camera Bedienungsanleitung
Kodak
Kodak C633 - Easyshare Printer Dock Series 3 Bedienungsanleitung
Kodak
Kodak PIXPRO AZ528-BK Bedienungsanleitung
Kodak
Kodak EasyShare C340 Bedienungsanleitung
Kodak
Kodak DCS 315 Bedienungsanleitung
Kodak
Kodak EasyShare C703 Bedienungsanleitung
Kodak
Kodak Pixpro 4KVR360 Bedienungsanleitung
Kodak
Kodak M1063 - EASYSHARE Digital Camera Service-Handbuch
Kodak
Kodak V1073 - EASYSHARE Digital Camera Service-Handbuch
