Kogan KA12SLWJCRA Bedienungsanleitung
COLD PRESS SLOW JUICER
KA12SLWJCRA
•This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
•Children should be supervised to ensure that they do not play with the appliance.
•Cleaning and user maintenance should not be performed by children without
supervision.
•Do not use the appliance if the rotating sieve or the protecting cover is damaged or
has visible cracks.
•This appliance should not be used by children. Keep the appliance and its cord out of
reach of children.
•Carefully read the instructions before operating.
•This appliance is intended for household use only.
•Do not use the appliance other than for its intended or specified purposes.
•Make sure the voltage mark on the appliance corresponds to the voltage in your
home before plugging in the power cord in order to avoid damage to the appliance.
•To protect against electrical shock, do not place cord plug or base unit in water or in
other liquids. Don’t operate machine with wet hands or place on a wet working
surface. Do not let the cord hang over the edge of the table or counter or touch hot
surfaces.
•If the electrical supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid hazard.
•Unplug from outlet when not in use.
•It is prohibited to plug or unplug with wet hands to avoid electric shock.
•To disconnect, remove plug from the electric outlet.
•Check the strainer every time when you want to use the appliance. If you detect any
cracks or damage, do not use the appliance and contact the nearest service centre.
•Always securely clamp in place all the parts before the motor is turned on. Do not
unfasten while appliance is in operation.
•Avoid contacting moving parts. Make sure the motor stops completely before
disassembling.
•Do not place the appliance on or near a hot gas or electric burner or in a heated oven.
•Do not let the appliance continue operating when you are away from it.
•Do not disassemble the base.
•Do not put any foreign materials into the machine.
•Do not continuously operate the juicer for more than 10 minutes. This can damage
the motor from overheating.
•Do not allow the machine to operate in an idle state with no fruit or vegetable being
juiced. Idling time can’t exceed 2 minutes or it will damage the spiral blade.
SAFETY & WARNINGS
•During operation, feed the food material slowly to avoid blocking the rotation. Ta ke
care to avoid inserting large or hard food materials. Cereal grains and legumes
soaked in water to soften. Seeds and cores should be removed.
oIf blockage occurs, stop working immediately. Reverse the motor for a while then
open the lid to take out the food and continue working again in the forward (“On”)
motor setting.
•Use the special pusher stick to feed food material into the feeder opening. Before use,
take out seeds and cores or it will cause blockage.
•When using, if there are any abnormal sounds, smells, overheating, smoke, etc.,
immediately turn off the power and contact Kogan.com.
•Never scrub or wash the machine body on a wet surface or pour water to wash the
inside of the machine to avoid electric shock or damage to machine body, etc.
•When making carrot or beet juice (or using other hard fruits and vegetables), pay
attention to the size of carrots, the size should not be more than 80mm in length, not
more than 75mm in width, not more than 75mm in height. Interval feeding time
should be not less than 5 seconds.
OVERVIEW
To p cover
Juicing bowl
Container
Smart cap
Pusher
Screw
Fine strainer
Cleaning brush
Note:
The illustrations above are for reference only and the product may differ slightly in
appearance.
STEP 1
To p s e t assembly
Align the red dots ●on each part and
assemble in the order shown. Once
assembled, turn the drum lid clockwise to
close.
STEP 2
To p s e t and base assembly
Place the bowl on the base, the 3 holes of
bowl lock into the 3 feet at the base.
ASSEMBLY
For safe operation
•Operating the juicer without ingredients can cause damage to the screws.
•Do not continuously operate the juicer for more than 10 minutes. This can damage
the motor from overheating.
•After continuous use, let the juicer rest for 10 minutes before starting another session.
•If the juicer stops due to the overload protection, let the juicer cool for 30 minutes to 2
hours before juicing again.
•Do not put fingers or other objects into the food chute. Always use provided pusher
when needed. If other objects are inserted into the food chute during operation, such
materials can get stuck and damage the juicer parts and/or cause injury.
•Do not put dried or hard ingredients like whole grains, fruits with hard seeds or ice into
the juicer. These may damage the juicer parts (e.g. juicing bowl, juicing screw and
strainer).
•Beans or grains can be used if soaked overnight or boiled.
•Fruits with pits and hard seeds (e.g. nectarines, peaches, mangoes and cherries) must
be pitted before juicing.
•When using frozen fruits with small seeds such as grapes, completely thaw before
inserting them into the juicer.
•Do not use ingredients containing excessive amounts of vegetable oil or animal fat.
Do not use the juicer to extract vegetable oil from ingredients. If vegetable/animal oil
gets on the juicing screw, it may reduce performance and even damage the part.
•Do not reinsert the extracted pulp into the juicer. This can cause the juicer to stop or
cause the drum lid not to open.
•After juicing ingredients with seeds like grapes, thoroughly clean all the crevices on
the bottom of the juicing screw.
Step 1: Topset assembly
1. Firmly insert the compression silicone into the slot below the pulp spout.
Note:
•Wash the parts before first use.
2. Place the juicing screw into the strainer. Turn and press down on it until it clicks into place.
3. Place the strainer into the juicing bowl ensuring the red dot on the strainer is aligned with
the red dot on the juicing bowl.
Note:
•The juicer may leak if not assembled properly.
•Ensure that the compression silicone and silicone ring are assembled properly.
•The juicing screw needs to be locked in-place in order to close the drum lid.
4. Place the drum lid on to the juicing bowl aligning the red dot on the drum lid with the red
dot on the juicing bowl. Turn clockwise to close, aligning the red on the drum lid with the lock
mark.
Step 2: Top-set and base assembly
Tip:
For easy assembly, hold the drum lid by grabbing the food
chute and turn clockwise as shown in the above illustration.
1. Place the bowl on the base, the 3 holes of bowl lock into the 3 feet at the base.
2. To l o c k the juicer in-place, turn it clockwise. To unlock, turn the juicer counterclockwise.
3. Place the pulp cup under the pulp spout and place the juice cup under the juice spout as
shown in the illustration.
Note:
•Juicer will not operate if parts are not assembled properly, or may leak during
operation.
•Ensure all steps have been followed correctly before operating juicer.
Inhaltsverzeichnis
Andere Kogan Entsafter Handbücher
