AUDIO IN
Unbalanced
Connectors
Connect to an unbalanced audio source for audio takeover of the HDMI 1 and HDMI 2
embedded audio.
Connect to the unbalanced audio of the computer graphics source (from 1 to 2).
Connect to the unbalanced audio source for analog audio takeover of the DisplayPort
embedded audio.
Connect to the unbalanced stereo audio of the composite video source (from 1 to 2)
Connect to the digital audio source of the component video (Y, Pb, Pr)
Select between a condenser and a dynamic type microphone
Connect to a digital audio acceptor
LINE OUT (L, R) Terminal Block
Connector
Connect to the L and R unbalanced stereo audio acceptor
REMOTE IR 3.5mm Mini Jack
(opening)
Covered by a cap. The 3.5mm
connector at the end of the
internal IR connection cable fits
through this opening
Connects to an external IR receiver unit for controlling the machine via an IR remote
controller (instead of using the front panel IR receiver)
Optional. Can be used instead of the front panel (built-in) IR receiver to remotely
control the machine (only if the internal IR connection cable has been installed)
Press while turning power off and then on, to reset the Ethernet settings to their factory
default state
SPKR Terminal Block Connector
Connect to a balanced stereo audio acceptor (speakers)
Connect to the HDMI source (from 1 to 2)
Connect to the computer graphics source (from 1 to 2)
Connect all three connectors to the component video source
Connect to the composite video source (from 1 to 2)
Connect to the DisplayPort source
Connect to a computer graphics acceptor
Connect to an HDMI acceptor
Connect to a DGKat receiver (for example, Kramer PT-572+)
Connect to the PC or other serial controller
Connects to the PC or other Controller through computer networking
REMOTE Terminal Block
Connectors
For remotely switching the inputs and PIP input via contact closure switches
Power Connector with Fuse
AC connector, enabling power supply to the unit
Switch for turning the unit ON or OFF
To rack mount the machine, attach both rack ears
(by removing the screws from each side of the
machine and replacing those screws through the
rack ears) or place the machine on a table.
•Ensure that the environment (e.g., maximum ambient temperature &
air flow) is compatible for the device.
•Avoid uneven mechanical loading.
•Appropriate consideration of equipment nameplate ratings should be
used for avoiding overloading of the circuits.
•Reliable earthing of rack-mounted equipment should be maintained.
