KRIOS 13995 Bedienungsanleitung
Tel: +44 (0)1274 657 088 Fax: +44 (0)1274 657 087 Web: www.cromptonlamps.com
Images are for information only. Phoebe LED shall not be held liable for improper operation of the luminaire
in circumstances where procedures and specications have not been followed correctly. Crompton Lamps Limited 2020
300mm
294mm
82mm
Environmental Protection
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
THANK YOU for buying this PHOEBE LED product. To help ensure this luminaire gives complete satisfaction please only use it according to the
following instructions, and then pass the instructions to the appropriate person for retention and future reference.
This instruction sheet is relevant to Phoebe LED KRIOS Emergency Twin Spot
product code: 13995
Warning
1. Installation only to be carried out by a qualied electrician
2. Please ensure mounting surface is suitable
3. Do not operate if product is damaged
4. IP65 suitable for wet weather outdoor use
Product
code Description Power
(W) Colour
13995 Krios Twin Spot 2.3 6000K Daylight
1 a. Switch off power at circuit.
b. Remove the front panel from
the body by removing the four
corner xing screws.
c. Take out the xings bag from
the inside of the unit.
BEFORE YOU START
PLEASE READ ALL THE
INSTRUCTIONS CAREFULLY
ONLY ONCE INSTALLATION
IS COMPLETE
Turn power
back on at
the mains
CIRCUIT TESTING
For high voltage circuit insulation
testing disconnect mains input
supply rst
(Do not circuit test using a Megger)
Turn power
off at the
mains
PRIOR TO INSTALLATION
2 a. Drill out the intended cable
Ø20mm entry hole suitable for
your installation.
b. Secure the luminaire to the
mounting surface at the Ø4mm
screw points indicated using the
supplied self tapping screws.
to
mains
240V
4a. Connect to mains power in accordance
with current wiring regulations, the mains
connector is located on the lower right of
the circuitboard (see wiring diagram).
b. Mark installation date on battery and
connect battery cable.
Wiring Diagram
5a. Ret the front panel to the body with the
screws from part 1b.
b. Switch on the power at circuit.
3 a. Fit the waterproof connector to
the entry point and pass the mains
supply into the luminaire.
b. Pass the mains cable through the
cable retention bracket and tighten.
c. Wire the luminaire to mains in
accordance with current wiring
regulations, the mains connector
is located on the lower right of the
circuitboard.
Viewing
Distance
(b)
(a)
(a)
(b) (b)
(b)(b)
(a)
(b)
To 240V Mains
(a)
AC INPUT
(b)
(b)
Tel: +44 (0)1274 657 088 Fax: +44 (0)1274 657 087 Web: www.cromptonlamps.com
Images are for information only. Phoebe LED shall not be held liable for improper operation of the luminaire
in circumstances where procedures and specications have not been followed correctly. Crompton Lamps Limited 2020
TESTING
24hrs Initial charge time required.
The emergency lighting must be inspected and tested regularly in accordance
with local codes of practice:
note: for safety reasons tests should be carried out during daylight hours.
AFTER INSTALLATION
Allow 24 hours to ensure full battery charge and then interrupt the supply; the
maximum duration time is 3 hours check that LEDs are still lighting.
FUNCTIONAL TEST (Short)
Monthly, interrupt mains for a short period and check LED lights.
DURATION TEST
Full duration test should be carried out annually, interrupt mains and check LED
lights. LEDs will light and should last for a minimum 3 hours operation:
batteries must be replaced when they can no longer support 3 hour operation.
LED STATUS COMMENT
Green Standby, system ok Mains operation, battery charging
Off Battery Operation Emergency mode:
Mains disconnected or Mains failure
INDICATOR LED
System status is shown locally by the indicator LED.
INSTALLATION MAINTENANCE RECORD
Month TEST
Year 1 Year 2 Year 3 Year 4
(Out of Warranty)
Signed Date Signed Date Signed Date Signed Date
1Short
2Short
3Short
4Short
5Short
6Short
7Short
8Short
9Short
10 Short
11 Short
12
Short
3 Hr
Installer
Installation Date
Installation Test Date
Inhaltsverzeichnis
Andere KRIOS Beleuchtungsausrüstung Handbücher
Beliebte Beleuchtungsausrüstung Handbücher anderer Marken
Qazqa
Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung
Commercial Electric
Commercial Electric 54568141 Bedienungsanleitung
CREE LIGHTING
CREE LIGHTING 304 Series Bedienungsanleitung
Goobay
Goobay 49867 Bedienungsanleitung
ECOMAN ITALIA
ECOMAN ITALIA LED T8 Bedienungsanleitung
Alkalite
Alkalite Krypton KT-81 Bedienungsanleitung
