1. e programming of the transmitter depends on the type of receiver. When programming, it is necessary
to be guided by the instruction manual of the device which is to be controlled by the transmitter.
2. A pause longer than 5 seconds between successive presses of the button will automatically cause
exit from the programming mode without any introduced changes.
3. Adding a transmitter using this method will cause erasing the memory of the receiver.
4. When the „O” channel is set on the display, it is switched on the group channel enabling simultaneous
control of all roller blinds that are programmed on individual channels. We do not perform any
programming procedures on this channel. e group channel is created automatically.
e function relates to 15-channel remote controls.
Pressing the UP or DOWN button will cause exit from the active channel selection mode. In order to
change the number of active channels again it is necessary to perform the procedure below again.
3. SELECTION OF ACTIVE CHANNELS
4. PROGRAMMING THE FIRST TRANSMITTER FOR THE ER TYPE DRIVES
We simultaneously press and hold
the CHANNEL + and CHANNEL - buttons.
e „C” symbol will appear on the display,
and after about 4 seconds the number 15
and the up and down arrows.
e drive will
emit a sound.
e roller blind
will make short
up / down
movements.
Press the
programming
button (P2)
on the remote
control.
Press the
programming
button (P2)
on the remote
control.
e roller blind
will make short
up / down move-
ments and emit
several sound
signals.
e drive will
emit a sound.
e drive will
emit a sound.
We press the UP
button once.
Using the buttons CHANNEL +
or CHANNEL - we set the number
of displayed channels.
Using the STOP button, we confirm
the setting. e symbol „o” is visible
on the display.
1. e batteries must be replaced when the integrated LED does not light, alternatively when
the receiver stops responding at the moment of pressing the keys.
2. When replacing the battery, it is necessary to pay attention to its correct polarity.
IMPORTANT!
We turn on the
power supply
or press the
programming
button on the
drive head.
LUB
ENVIRONMENTAL PROTECTION
is device has been marked in accordance with the WEEE Directive
(2002/96 / EC) regarding waste electrical and electronic equipment. By
ensuring proper scrapping you contribute to reducing the risk of occurrence
of a negative impact of the product on the environment and human
health, which could exist in the event of improper disposal of the device.
e symbol placed on the product or the documents attached to it
means that this product is not classified as a household waste. e device
must be given to an appropriate waste disposal point for recycling. For
additional information regarding recycling of this product please contact
your local authority representative, a waste disposal service provider or
a store where the product was purchased.
