KTM 1090 RR kit Bedienungsanleitung

KTM 1090 / 1190/ 1050 RR kit installation manual

Thank you for purchasing the KTM 1090 RR kit from RADE/GARAGE. The installation is quite simple,

but may take up to 3 hours because the 1090 has many plastics planes that must be removed before

you can take out the headlight.

0/ See your bike before and after the RR kit is installed

1/ Remove the OEM screen and its holder

a/ Remove the four bots holding the OEM screen and the screen itself

b/ Lift up the OEM screen holders and remove the plastic holder bolts as in the picture. Remove also

the metal plates and keep the OEM screws for later.

2/ Remove the bolts that hold the fairing panels and the OEM headlight

a/ Remove the four bots holding the OEM plastic panels.

b/ Hold the turn signal and CAREULLY lift up the white panel –there is a plastic hook on the back side.

You must remove the white panel in order to access the bolt holding the OEM headlight. If you are not

sure –see the install video on our website.

c/ Next remove the upper two bolts holding the headlight.

d/ To access the bottom bolt, you have to carefully bent the side panel and remove the OEM bolt

3/ Replace the OEM headlight with our LED unit

a/ Now pull out the OEM headlight and mask. Next disconnect the OEM connector. Then remove the

four nut inserts and install them on the R/G headlights bracket.

b/ Assemble the LED headlights. The high beam with shorter tube goes to the upper position and the

low beam with longer tube goes below. Use the M5x16 black bolts (enclosed in the headlights box).

c/ Bolt on the orange resistors with M4 bolts and nuts.

d/ Use the rubber nuts (top right picture) for the upper carbon mask holders and supplied M5 nut

inserts for the bottom mask holders .

c/ Tip for you! Before you connect the LED unit, you have good opportunity to connect your GPS cable,

heat grips cable and other accessories, because the OEM spare power source is now easily accessible.

After you connect the headlights secure the cables with zip tie to avoid bouncing.

d/ insert the LED unit into the same mounting points as the OEM headlight. The bottom bracket will

be secured again using the OEM bolts and the upper bracket with supplied distancers.

4/ Mount the carbon mask

a/ Now install the mesh that will seal the headlights cover. Make sure you place it in the area that will

be under the orange sticker. Than bolt on the headlights cover with M4 rubber nuts and bolts.

b/ When inserting the carbon mask make sure it is placed under the OEM black plastic rim as in the

picture.

c/ Bolt on the mask to the upper bracket with M5x16 bolts and use the plastic washers. Also mount the

top windscreen holders with the OEM screws.

5/ Put the windscreen on!

a/ Before you start the windscreen installation, apply the transparent rim to the edge of the

windscreen. Than start mounting the top two bolts and the two bolts on the sides - via the distancers.

Use the M5x16 bolts and plastic washers.

b/ When mounting the lower bolts use the rubber distance washers in between the carbon mask and

the windscreen. Before you insert the bolts align (using a guide e.g. small screw-driver) the nut insert

with the hole in the carbon mask.

Congratulation! The installation is finished and you can start enjoying your upgraded bike ☺

If you have any questions or feedback, please post it in the following threat on AdvRider forum, we will

be notified, will respond and it might also help others with their questions:

https://advrider.com/f/threads/rade-garage-kits-and-accesorries-for-ktm-1090-1190-

adventure.1351790/

Thanks again.

RADE/GARAGE team

Dieses Handbuch passt für folgende Modelle

Andere KTM Motorradzubehör Handbücher

KTM

KTM 60112927044 Kurzanleitung zur Einrichtung

KTM

KTM 600.12.025.000 Bedienungs- und Montageanleitung

KTM

KTM 60112092020 Betriebsanleitung

KTM

KTM 79602979044 Betriebsanleitung

KTM

KTM 600.07.213.050 Bedienungsanleitung

KTM

KTM 45412955044S Bedienungsanleitung

KTM

KTM 79011955044 Betriebsanleitung

KTM

KTM 90112927044 Betriebsanleitung

KTM

KTM 60712932000 Betriebsanleitung

KTM

KTM 60112092010 Betriebsanleitung

KTM

KTM 55103190000 Betriebsanleitung

KTM

KTM 76012935144 Betriebsanleitung

KTM

KTM 79610917000EB Bedienungsanleitung

KTM

KTM A46001999021FAA Bedienungsanleitung

KTM

KTM TOURATECH 22112929044 Bedienungsanleitung

KTM

KTM 79607913044 Betriebsanleitung

KTM

KTM 60435940044 Bedienungsanleitung

KTM

KTM 76112912044C1 Bedienungsanleitung

KTM

KTM 61313931244 Betriebsanleitung

KTM

KTM 61313931044 Betriebsanleitung

KTM

KTM 00029920000EB Betriebsanleitung

KTM

KTM PowerParts 55011599000 Bedienungsanleitung

KTM

KTM TOP-CASE 37 Bedienungsanleitung

KTM

KTM 600.12.068.000 Bedienungsanleitung

Beliebte Motorradzubehör Handbücher anderer Marken

SRC

SRC B-TRK502-01-01-SL Bedienungsanleitung

3M Speedglas 9100 MP Bedienungsanleitung

hepco & becker

hepco & becker 6307520 00 01 Bedienungsanleitung

HOMCOM

HOMCOM AA0-077 Bedienungsanleitung

hepco & becker

hepco & becker 6307558 00 01 Bedienungsanleitung

Wunderkind Custom

Wunderkind Custom 106503-F15 Benutzerhandbuch

Dräger

Dräger HPS 3500 Bedienungsanleitung

M-WAVE

M-WAVE SKI Bedienungsanleitung

Kuryakyn

Kuryakyn 6212 Bedienungsanleitung

hepco & becker

hepco & becker 6507504 00 01 Bedienungsanleitung

Tool it

Tool it PROMAX LCD 9.13G Bedienungsanleitung

Custom Dynamics

Custom Dynamics TruWrapz Bedienungsanleitung

Roof

Roof RO200 CARBON Bedienungsanleitung

Kabuto

Kabuto Japan IBUKI Bedienungsanleitung

PUIG

PUIG 5051 Bedienungsanleitung

rizoma

rizoma ZTH050 Bedienungsanleitung

Joubert

Joubert 10001711 Bedienungsanleitung

Sperian

Sperian Optrel p420 Bedienungsanleitung