La Crosse Technology RADIO CONTROLLED PROJECTION ALARM CLOCK Bedienungsanleitung

RADIO CONTROLLED PROJECTION

ALARM CLOCK

Instruction manual

INTRODUCTION:

Congratulations on purchasing this Projection clock with DCF-77 radio-controlled time.

The operation of this product is simple and straightforward and by reading this

operating manual, users will receive the optimum benefits of all its features.

Stand

Adapter socket

Battery compartment

Function

keys

LCD

Display

FEATURES

•DCF-77 Radio controlled time with manual setting option

•Time projection (hour and minute)

•LED back-light

•Indoor temperature displayed in degree Celcius

•Calendar display

•Alarm setting with snooze function

•Time zone (± 9 hours)

SETTING UP :

The projection clock can be batteries operated or powered by the provided

AC/DC adapter.

POWER SUPPLY :

The Projection Clock uses 2 x AA, IEC LR6, 1.5V batteries. To install and replace the

batteries, please follow the steps below:

1. Lift up and remove the battery

compartment cover.

2. Insert batteries observing the correct

polarity (see marking).

3. Replace compartment cover.

Note: User shall also refer to Manual Setting for detailed Setting up procedures.

In addition or instead of inserting batteries, the AC adapter can be used:

1. Connect the power adapter to a wall socket

2. Insert the adapter into the jack at the bottom of the clock

3. The Projection clock will now start receiving the DCF time signal. After

approximate 3 to 5 minutes, the DCF time will be displayed

Note: User shall also refer to Manual Setting for detailed Setting up procedures.

Important!

Use only the adapter provided with the projection clock and make sure that your

household voltage is appropriate to the working voltage of the transformer.

Otherwise your projection clock may be damaged.

•Radio controlled time receiver is at the bottom side of the main unit. Don’t place

the adapter wire adjacent to the bottom side of the main unit when AC power is

used, as this may decrease the reception sensitivity.

BATTERIES POWERED WITH THE USE OF AC/DC ADAPTER

If the Projection clock is first powered by batteries and the power adapter is

subsequently used for extended period of time, the main power source of the Projection

clock will switch to AC/DC power. The batteries will then act as a backup power source

in case of power failure.

Notes:

•After the projection clock is powered, there will be a beep sound and the LCD

(Liquid Crystal Display) will activate.

•The indoor temperature and the time as 0 :00 will be displayed.

•The DCF time reception will automatically be initiated, and a tower icon will

appear (no tower icon will appear if the time reception is too weak to be detected,

and the time display will start from 0:00).

•When DCF time has not been received, user may use the MODE/MIN key to

manually enter a time and date initially. The clock will automatically attempt to

receive the DCF time at each full hour. When this is successful, the received time

will override the manually set time. The date is also updated with the received

time. (Please refer also to notes on “DCF-77 radio controlled time” and

“Manual time setting”).

TO RESET THE PROJECTION CLOCK

To reset the Projection clock to the factory default setting or in case of a malfunction,

please remove all batteries from the unit and unplug the AC/DC adapter from any

power source. Wait at least for 3 minutes before powering up the Projection clock

again.

BATTERY CHANGE:

It is recommended to replace the batteries in all units regularly to ensure optimum

accuracy of these units. (Battery life –see Specifications)

Please participate in the preservation of the environment. Return

used batteries to an authorized depot.

RADIO CONTROLLED TIME

The time base for the radio controlled time is a Cesium Atomic Clock operated by the

Physikalisch Technische Bundesanstalt Braunschweig which has a time deviation of

less than one second in one million years. The time is coded and transmitted from

Mainflingen near Frankfurt via frequency signal DCF-77 (77.5 kHz) and has a

transmitting range of approximately 1,500 km. Your radio-controlled Projection clock

receives this signal and converts it to show the precise time in summer or wintertime.

The quality of the reception depends greatly on the geographic location. In normal

cases, there should be no reception problems within a 1500km radius of Frankfurt.

The DCF tower icon in the clock display will start flashing in the upper center. This

indicates that the clock has detected that there is a radio signal present and is trying to

receive it. When the time code is received, the DCF tower becomes permanently lit and

the time will be displayed.

If the tower icon flashes, but does not set the time or the DCF tower does not appear at

all, then please take note of the following:

•Recommended distance to any interfering sources like computer monitors or TV

sets is a minimum of 1.5 - 2 meters.

•Within ferro-concrete rooms (basements, superstructures), the received signal is

naturally weakened. In extreme cases, please place the unit close to a window

and/ or point its front or back towards the Frankfurt transmitter.

During nighttime, the atmospheric disturbances are usually less severe and reception is

possible in most cases. A single daily reception is adequate to keep the accuracy

deviation below 1 second.

FUNCTION KEYS

The radio-controlled Projection clock uses the following keys :

SNOOZE button

AL / HOUR

button

Projection Direction

button

MODE/ MIN

button

SNOOZE :

•Activate or deactivate snooze function

•Alarm snooze function

•Activate the projection of time

•Exit the setting modes

•Back light on

Inhaltsverzeichnis

Andere La Crosse Technology Wecker Handbücher

La Crosse Technology

La Crosse Technology WT-5350 Bedienungsanleitung

La Crosse Technology

La Crosse Technology C79141-UK Abmessungen

La Crosse Technology

La Crosse Technology 616-1412V2 Abmessungen

La Crosse Technology

La Crosse Technology WT-5442 Bedienungsanleitung

La Crosse Technology

La Crosse Technology 616-1950 Bedienungsanleitung

La Crosse Technology

La Crosse Technology 616-146A Abmessungen

La Crosse Technology

La Crosse Technology WS-8117U-IT Bedienungsanleitung

La Crosse Technology

La Crosse Technology WT-5442U Bedienungsanleitung

La Crosse Technology

La Crosse Technology 616-146v3 Abmessungen

La Crosse Technology

La Crosse Technology W85923 Abmessungen

La Crosse Technology

La Crosse Technology WT-5220U-IT Bedienungsanleitung

La Crosse Technology

La Crosse Technology WT-2171 Bedienungsanleitung

La Crosse Technology

La Crosse Technology K85236 Abmessungen

La Crosse Technology

La Crosse Technology WT-5720TWC Bedienungsanleitung

La Crosse Technology

La Crosse Technology WT-2100 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WT-2171U Bedienungsanleitung

La Crosse Technology

La Crosse Technology WT221 Bedienungsanleitung

La Crosse Technology

La Crosse Technology K86326 Bedienungsanleitung

La Crosse Technology

La Crosse Technology Soluna C79141 Abmessungen

La Crosse Technology

La Crosse Technology WS-8249U-CH Bedienungsanleitung

La Crosse Technology

La Crosse Technology 617-148 Bedienungsanleitung

La Crosse Technology

La Crosse Technology 616A-1908 Abmessungen

La Crosse Technology

La Crosse Technology WT-2171 Bedienungsanleitung

La Crosse Technology

La Crosse Technology SOLUNA Bedienungsanleitung

Beliebte Wecker Handbücher anderer Marken

Steren

Steren CLK-210 Bedienungsanleitung

COP-USA

COP-USA ALCDVR32-SL Bedienungsanleitung

Philips

Philips HF3505/70 Technisches Handbuch

Casio

Casio PQ-70 Bedienungsanleitung

iHome

iHome IA63 Bedienungsanleitung

Coopers

Coopers 9765 Bedienungsanleitung

ANJANK

ANJANK AC-190 Leitfaden

TFA

TFA 98.1075 Bedienungsanleitung

Sharper Image

Sharper Image 204050 Bedienungsanleitung

Lumie

Lumie Zest Bedienungsanleitung

Dexford

Dexford RCT200 Bedienungsanleitung

Philips

Philips AJL303/37B Bedienungsanleitung

RST

RST Q754 Bedienungsanleitung

iHome

iHome iKT50 Bedienungsanleitung

Sony

Sony dash HID-B7 Bedienungsanleitung

SVINZ

SVINZ SCC009 Bedienungsanleitung

Clas Ohlson

Clas Ohlson 918863 Bedienungsanleitung

IKEA

IKEA FNURRA Bedienungsanleitung