Labgear LABHG32T Bedienungsanleitung

Features include:

• 13.9dBi Gain

• F type connector for secure and easy connection

• Fast simple assembly

• Encapsulated weather resistant electronic balun

Congratulations on the purchase of your LABHG32T aerial. The aerial is ideal for the reception of all available

signals in strong and medium strength areas. The aerial design has been tuned to minimise reception of signals

above 790MHz from Lte800 4G mobile phone transmitters which can interfere with digital TV channels.

fold braid back

over sheath

8mm

inner

wire

cut or tear

away foil

6.5mm

Fig. 1

screw connector

body onto cable 2mm approx.

end of insulation

should be flush

with this face

Fig. 2

Professional High Gain 32 Element Aerial

LABHG32T

USER GUIDE

Aerial assembly

3. Clip the balun/dipole assembly to the main boom

using the sprung studs to hold it in position as

shown in Fig.3.

4. Using the reﬂector clamps, bolt and wing nut, ﬁx

the reﬂector assemblies to the main aerial boom

as shown in Fig.4 and Fig. 5.

5. Check that the reﬂector clamp tabs locate in the

holes of the reﬂector boom sections and that the

wing nut is tight - see Fig. 5.

6. Ensure that the reﬂector elements are facing the

right way with the rivets facing the back of the aerial.

Fig. 4

Lte

800

READY

engage

tab in hole

reﬂector

assembly

reﬂector

clamps

For optimum results install the aerial using double screened CAI benchmarked digital coax cable and s

creened coax outlets. You will need to t the coax cable with the F type connector supplied to connect

to the downlead (not supplied) to the F socket on the aerial.

1. Prepare the Coax Cable: Firstly fit the rubber weather boot provided, to the aerial end

of the cable. Strip the end of the cable as shown in Fig. 1. Once you have stripped the

cable, twist the braid and pull it back on itself, make sure that no braid is touching the

copper core, this will cause a short on the cable and you will not get any signal.

2. Fitting the F connector: Now, simply twist on the ‘F’ connector supplied and trim the

central conductor.

For best results the aerial should be mounted on an outdoor aerial mast and pointed in the

direction of the nearest transmitter* making sure it is in a position where the transmitter

signal will not be obstructed by nearby trees and buildings. If you are in any doubt about

the direction in which the aerial should be pointing or the orientation of the aerial

(horizontal for main transmitter, vertical for relay transmitter) check your neighbours’aerials.

The aerial requires some assembly. If mounting on an existing mast check that the mast is in

good condition and rmly xed.

Fig. 3

Installation Instructions

Fig. 5

balun/dipole

assembly

sprung studs main boom

10.

Connect the aerial downlead to the ‘F’ socket on the

underside of the balun (be careful not to over tighten

the

F connector) see Fig. 6.

11. Slide the weather boot over the ‘F’ connector

and socket to make a good seal - see Fig. 6.

12. Make sure that the downlead is routed as shown in Fig.6.

Use insulating tape, to secure the the coax downlead to

the mast.

13.

Finally connect the aerial to your TV/set top box

and check the picture. Fine adjust the direction

of the aerial to obtain the optimum signal reception.

No picture:

Check all connections from aerial to TV.

Poor picture:

Check all connections from aerial to TV.

Check aerial is properly aligned to the correct transmitter.

If the aerial has been loft mounted try mounting outside.

Make sure new digital coax cable has been used

throughout the installation.

Check the transmitter signal is not obstructed by nearby trees or build-

ings.

If in a very weak signal area or for long cable runs,

installing a masthead amplifier will improve the signal.

If in a strong signal area the signal strength may need to be reduced by

fitting an attenuator.

When mounting the assembled aerial, always observe safety

precautions and use the correct equipment.

Unless you are competent in the use of ladders and other

access equipment, do not work outdoors at roof height.

If in any doubt, refer to a qualied aerial installer.

Fig. 6

Troubleshooting

Useful Websites for Digital Advice:

*To nd out which DTT channels should be available locally

and to nd out where your nearest transmitter is visit:

http://www.digitaluk.co.uk/coveragechecker/

and enter postcode, house number if you also check the

detailed view box you will see a list of transmitter’s with

distances and compass bearings.

For further information, please contact:

Customer careline: 08457 573479 (Local Rate - UK Only)

Technical Support: www.philex.com/support/

Waste electrical products should not be disposed of with

household waste. Please recycle where facilities exist.

Check with your Local Authority for recycling advice.

Speciﬁcations

Frequency Range MHz 470-790

TV Channels 21-60

Forward Gain dBd 11.7

Forward Gain dBi 13.9

Front/Back Ratio dB >15.0

Beam Width +/-deg. +/-16°

PCB Balun Yes

Connector F-Type

Length 776mm

Width 535mm

Height 595mm

Insulating

Tape

F Connector

Weather

Boot

Caution

Andere Labgear Antenne Handbücher

Labgear

Labgear LABGT07T Bedienungsanleitung

Labgear

Labgear C10W Bedienungsanleitung

Labgear

Labgear LAB32KIT/S Bedienungsanleitung

Labgear

Labgear LAB480W Bedienungsanleitung

Labgear

Labgear 29911LAB Bedienungsanleitung

Labgear

Labgear LABGT12A Bedienungsanleitung

Labgear

Labgear LABGT20K Bedienungsanleitung

Labgear

Labgear LAB350W Bedienungsanleitung

Labgear

Labgear LAB350T Bedienungsanleitung

Labgear

Labgear Wideband High Gain Digital Aerial Bedienungsanleitung

Labgear

Labgear LABHG52T Bedienungsanleitung

Labgear

Labgear LABHG100 Bedienungsanleitung

Labgear

Labgear LABHG420 Bedienungsanleitung

Labgear

Labgear LABGT20T Bedienungsanleitung

Labgear

Labgear LABGT18A Bedienungsanleitung

Labgear

Labgear LABHG48A Bedienungsanleitung

Labgear

Labgear LABHG140 Bedienungsanleitung

Labgear

Labgear 27884LAB Bedienungsanleitung

Beliebte Antenne Handbücher anderer Marken

Alfa Network

Alfa Network APA-L01 Bedienungsanleitung

Naval

Naval PR-422CA Bedienungsanleitung

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Bedienungsanleitung

TERK Technologies

TERK Technologies TV44 Bedienungsanleitung

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Bedienungsanleitung

HP J8999A Bedienungsanleitung

MobilSat

MobilSat MSP-S Bedienungsanleitung

Steren

Steren ANT-UHF 13 Bedienungsanleitung

Novatel

Novatel 600-G Bedienungsanleitung

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Bedienungsanleitung

TRENDnet

TRENDnet TEW-AO12O Bedienungsanleitung

Radio Shack

Radio Shack 15-1837 Bedienungsanleitung

CommScope

CommScope CMAX-OMFX-43M-I53 Bedienungsanleitung

Ramsey Electronics

Ramsey Electronics DAP25 Bedienungsanleitung

COBHAM

COBHAM SAILOR 800 VSAT Gebrauchs- und Pflegehandbuch

Trango Systems

Trango Systems AD900-9 Bedienungsanleitung

Steren

Steren ANT-100 Bedienungsanleitung

IWCS

IWCS iriBelt II Einrichtungshandbuch