Laird Sentrius RG1 Series Bedienungsanleitung

Quick Start Guide

Sentrius RG1xx

Version 2.1

Sentrius RG1xx

Quick Start Guide

Embedded Wireless Solutions Support Center:

http://ews-support.lairdtech.com

www.lairdtech.com/ramp

Americas: +1-800-492-2320

Europe: +44-1628-858-940

Hong Kong: +852 2923 0610

REVISION HISTORY

Version

Date

Notes

Approver

1.0

20 July 2017

Initial Release

Jonathan Kaye

1.1

28 July 2017

Minor fixes

Dave Drogowski

1.2

3 Aug 2017

Clarified web interface URL in

section 4: Log into the

Gateway. Identified separate

mDNS address.

Shewan Yitayew

2.0

29 Nov 2017

Update info for compatibility

with GA2 (93.7.2.x) firmware.

Ryan Erickson

2.1

19 April 2018

Minor typo correction

Shewan Yitayew

Sentrius RG1xx

Quick Start Guide

Embedded Wireless Solutions Support Center:

http://ews-support.lairdtech.com

www.lairdtech.com/ramp

Americas: +1-800-492-2320

Europe: +44-1628-858-940

Hong Kong: +852 2923 0610

CONTENTS

1Overview............................................................................................................................................................ 4

2About the Gateway............................................................................................................................................ 4

2.1 Product Overview ...................................................................................................................................... 4

3Connect the Hardware ...................................................................................................................................... 5

3.1 Connect the Gateway ................................................................................................................................ 5

3.1.1 Antenna Configuration ...................................................................................................................... 6

3.1.2 WiFi Quick Config............................................................................................................................... 6

4Log into the Gateway ........................................................................................................................................ 7

5Connecting the Gateway to the Internet .......................................................................................................... 8

5.1 Setting Up Ethernet ................................................................................................................................... 8

5.2 Setting Up Wi-Fi......................................................................................................................................... 8

6LoRa Packet Forwarding Set Up ...................................................................................................................... 10

7Configuration with The Things Network ......................................................................................................... 11

7.1 Set up your account with The Things Network ....................................................................................... 11

7.2 Create an Application with TTN............................................................................................................... 16

7.3 Register your RG1xx Gateway with TTN.................................................................................................. 17

8Sending Data to the Cloud –Setup.................................................................................................................. 20

9View DVK-RM1xx Data in the Cloud ................................................................................................................ 26

Sentrius RG1xx

Quick Start Guide

Embedded Wireless Solutions Support Center:

http://ews-support.lairdtech.com

www.lairdtech.com/ramp

Americas: +1-800-492-2320

Europe: +44-1628-858-940

Hong Kong: +852 2923 0610

1OVERVIEW

This quick start guide describes how to configure the Sentrius gateway to forward LoRaWAN data to a cloud

platform. The steps listed in this guide use the RG191 (US version) gateway and an RM191 (US version) module.

The steps for using an RG186 and RM186 are similar.

Note: This guide uses the The Things Network (TTN) to show how to register your Gateway and visualize

the incoming data on a Network server. If you are working with Stream IOT-X or LORIOT.io server, a

similar guide will be available through their page to help you configure your gateway.

For more detailed information on how to use all the features of the Sentrius gateway, please see the Sentrius

RG1xx User Manual, available from documentation tab at: www.lairdtech.com/products/rg1xx-lora-gateway.

2ABOUT THE GATEWAY

2.1 Product Overview

The Sentrius™ RG1xx LoRa-Enabled Gateway from Laird is the ultimate in

secure, scalable, robust LoRa solutions for end-to-end control of your private

LoRaWAN network. Leveraging Laird’s field-proven and reliable 50 Series

“Wireless Bridge” certified module, it also offers enterprise dual-band Wi-Fi,

BT v4.0 (BLE and Classic) and wired Ethernet for complete design freedom.

Based on the Semtech SX1301/SX1257 chipset designs, it offers a LoRa range

up to 10 miles and pre-loaded LoRa Packet Forwarder software, perfect for

highly scalable, flexible IoT networks. The Sentrius RG1xx Gateway works

with Laird’s Sentrius RM1xx Series LoRa+BLE certified modules for simple

out-of-the-box integration and is compatible with 3rd party Cloud and LoRa

partners, as well as any LoRaWAN certified client devices.

Sentrius RG1xx

Quick Start Guide

Embedded Wireless Solutions Support Center:

http://ews-support.lairdtech.com

www.lairdtech.com/ramp

Americas: +1-800-492-2320

Europe: +44-1628-858-940

Hong Kong: +852 2923 0610

Figure 1: Top of the Sentrius™ RG1xx gateway

1. LoRa and Wi-Fi antennas

2. LEDs

3. Fixing holes

4. User button

Figure 2: Back panel of the Sentrius™ RG1xx gateway

1. DC power input

2. User button

3. Reset button

4. SD card slot

5. Ethernet connector

3CONNECT THE HARDWARE

3.1 Connect the Gateway

To use the gateway, you must power up the gateway and access the web interface via the Ethernet port. To do

this, complete the following steps:

1. Follow the label on the box and connect the three antennas. Refer to Antenna Configuration for additional

information.

2. Connect the power supply (see #2 in Figure 3).

3. Connect the gateway to your router (#3 in Figure 3) using the Ethernet cable (#1 in Figure 3).

Figure 3: Connecting the gateway

Sentrius RG1xx

Quick Start Guide

Embedded Wireless Solutions Support Center:

http://ews-support.lairdtech.com

www.lairdtech.com/ramp

Americas: +1-800-492-2320

Europe: +44-1628-858-940

Hong Kong: +852 2923 0610

3.1.1 Antenna Configuration

To configure the antenna properly, complete the following steps:

1. Attach the two shorter antennas to the 2.4/5.5 GHz (Wi-Fi) ports.

2. Attach the third and longer antenna to the 868 MHz/900 MHz (LoRa) port.

3.1.2 WiFi Quick Config

The gateway includes a mode to allow you to configure without ethernet access, in the case that you wish to

join a wireless network.

Apply power to the gateway and allow to start, then perform the following:

1. Depress and hold the user button (see #2 in Figure 2) for 7 seconds.

2. From a wirelessly enabled device perform a scan.

3. Connect to the access point rg1xx29378B, where “29378B” are the last 6 digits of the Ethernet MAC

address found on the label on the bottom of the gateway (Figure 4).

The network is secured with WPA2 with a password that is the same as the SSID. It is recommended

that the default password is changed for security reasons. The password can be changed on the Wi-Fi ->

Advanced web page.

Upon logout or client disassociation, WiFi Quick Config will shut down and normal operation will resume.

Sentrius RG1xx

Quick Start Guide

Embedded Wireless Solutions Support Center:

http://ews-support.lairdtech.com

www.lairdtech.com/ramp

Americas: +1-800-492-2320

Europe: +44-1628-858-940

Hong Kong: +852 2923 0610

4LOG INTO THE GATEWAY

To log into the gateway web interface, follow these steps:

1. Determine the last three bytes of your gateway’s Ethernet MAC address. This can be found on the label on

the bottom of the gateway; the last three bytes are highlighted (Figure 4).

Figure 4: Bottom label –last three bytes of the Ethernet MAC address highlighted

2. Enter the URL into the web browser to access the web interface. For example, for the gateway used in this

guide, the URL is https://rg1xx29378B.local., where “29378B” are the last 6 digits of the Ethernet MAC

address. In Wi-Fi quick config mode, the gateway can also be accessed via the IP address at

https://192.168.1.1

3. Accept the self-signed security certificate in the browser.

4. Click Advanced (Figure 5).

Figure 5: Web interface –first screen

5. Click Proceed (Figure 6).

Sentrius RG1xx

Quick Start Guide

Embedded Wireless Solutions Support Center:

http://ews-support.lairdtech.com

www.lairdtech.com/ramp

Americas: +1-800-492-2320

Europe: +44-1628-858-940

Hong Kong: +852 2923 0610

Figure 6: Web interface –second screen

6. Log on using the following default credentials (Figure 7):

Username: sentrius

Password: RG1xx

Figure 7: Gateway interface login screen

5CONNECTING THE GATEWAY TO THE INTERNET

5.1 Setting Up Ethernet

By default, the Ethernet port is set up for DHCP addressing. Connect the Ethernet cable to a network with

internet access. If more advanced Ethernet configuration is needed, please see the Sentrius RG1xx User Manual

in the documentation tab of the RG1xx product page at lairdtech.com:

www.lairdtech.com/products/rg1xx-lora-gateway .

5.2 Setting Up Wi-Fi

By default, the Wi-Fi in the gateway is not configured to connect to a Wi-Fi network. You must access the web

interface on the gateway via the Ethernet interface to setup the Wi-Fi connection.

To set up the Wi-Fi, follow these steps:

1. Once logged into the web interface, navigate to the Wi-Fi page (Figure 8).

Sentrius RG1xx

Quick Start Guide

Embedded Wireless Solutions Support Center:

http://ews-support.lairdtech.com

www.lairdtech.com/ramp

Americas: +1-800-492-2320

Europe: +44-1628-858-940

Hong Kong: +852 2923 0610

Figure 8: Wi-Fi page

2. To connect to a Wi-Fi network, click Scan to scan for nearby Wi-Fi networks (Figure 9). Scanning continues

until you click Stop or select one of the scan results in the list.

Figure 9: Wi-Fi scan results

3. Click on the applicable scan result.

4. Enter the information for the Wi-Fi network (Figure 10).

Figure 10: Wi-Fi profile dialog

5. Click Connect.

Sentrius RG1xx

Quick Start Guide

Embedded Wireless Solutions Support Center:

http://ews-support.lairdtech.com

www.lairdtech.com/ramp

Americas: +1-800-492-2320

Europe: +44-1628-858-940

Hong Kong: +852 2923 0610

6LORA PACKET FORWARDING SET UP

To set up LoRa packet forwarding on the gateway, follow these steps:

1. Click the LoRa tab in the main menu (Figure 11).

2. In the dropdown labeled Select Preset, select the preset for The Things Network Legacy (TTN).

3. Click Apply.

Figure 11: LoRa page –TTN preset

Note: In addition to the TTN, Laird currently supports presets for other LoRa network servers.

Figure 12: LoRa presets

Note: If operating with a network server that is not available as a preset, you may also manually

configure the forwarder in the Forwarder page, available in the left menu. More information on

this is available in the RG1xx User Guide, available in the documentation tab of the RG1xx product

page at lairdtech.com: www.lairdtech.com/products/rg1xx-lora-gateway

Andere Handbücher für Sentrius RG1 Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Laird Tor Handbücher

Laird

Laird Sentrius RG1 Series Bedienungsanleitung

Laird

Laird Sentrius RG1 Series Bedienungsanleitung

Laird

Laird Sentrius RG1 Series Bedienungsanleitung

Laird

Laird Sentrius RG1xx Bedienungsanleitung

Laird

Laird Sentrius RG1 Series Bedienungsanleitung

Laird

Laird Sentrius MG100 Bedienungsanleitung

Laird

Laird Sentrius MG100 Betriebsanleitung

Laird

Laird Sentrius RG191+LTE Bedienungsanleitung

Laird

Laird Sentrius RG191+LTE Bedienungsanleitung

Beliebte Tor Handbücher anderer Marken

LST

LST M500RFE-AS Bedienungsanleitung

Kinnex

Kinnex Media Gateway Bedienungsanleitung

2N Telekomunikace

2N Telekomunikace 2N StarGate Bedienungsanleitung

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Bedienungsanleitung

Telsey

Telsey CPVA 500 - SIP Bedienungsanleitung

RTA

RTA 460A-NNA4 Technisches Datenblatt

Shaw

Shaw Gateway HDPVR Bedienungsanleitung

ABB

ABB VSN900 Kurzanleitung

Commander

Commander Pulse Bedienungsanleitung

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Bedienungsanleitung

NETGEAR

NETGEAR C6300BD Bedienungsanleitung

Amit

Amit CDW531AM Bedienungsanleitung

HMS

HMS Netbiter EasyConnect EC150 Bedienungsanleitung

Huawei

Huawei EchoLife HG620 Bedienungsanleitung

AT&T

AT&T U-verse 3801 Gebrauchs- und Pflegehandbuch

Logic IO

Logic IO RTCU MX2 turbo Bedienungsanleitung

Suttle

Suttle MediaMAX MXM-521 Bedienungsanleitung