Larson Electronics EPL-PM-1X30LED-100 Handbuch

EPL-PM-1X30LED-100

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 2

EPL-PM-1X30LED-100 Instruction Guide

25W Explosion Proof LED Light

Thank you for your purchase of the Larson Electronics EPL-PM-1X30LED-100 Portable Explosion Proof LED

Light. Please follow the steps below in order to operate and maintain this product.

IMPORTANT

READ CAREFULLY BEFORE OPERATING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE

REFERENCE. THE EPL-PM-1X30LED-100 MUST BE OPERATED IN ACCORDANCE WITH NATIONAL ELECTRICAL

CODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.

FOR PERSONAL SAFETY, ALWAYS CONFIRM THE RATING OF ANY KNOWN HAZARDOUS OR POTENTIALLY

HAZARDOUS LOCATION WHERE THE LIGHT IS TO BE USED.

WARNING: ALL WIRING SHOULD BE DONE BY A LICENSED ELECTRICIAN IN ACCORDANCE WITH STATE

CODES, LOCAL CODES AND NATIONAL ELECTRIC CODE (NEC) STANDARDS.

WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, THE SUPPLY CIRCUIT SHOULD BE

DISCONNECTED WHEN INSTALLING OR PERFORMING ANY MAINTENANCE ON THIS UNIT.

WARNING: DO NOT SCRATCH OR CHIP THE FRONT LENS. TURN THE POWER OFF AND LET UNIT COOL

BEFORE STARTING INSTALLATION OR REPAIR.

WARNING: OPERATE THIS FIXTURE ONLY AT THE VOLTAGE OF YOUR SPECIFIC SUPPLY CIRCUIT. FAILURE

TO DO SO WILL RESULT IN DAMAGE TO THE FIXTURE.

WARNING: SUBSTITUTE COMPONENTS MAY IMPAIR EXPLOSION PROOF SAFETY.

•IMPROPER INSTALLATION MAY RESULT IN SERIOUS INJURY AND VOID WARRANTY.

•CONTAINS PARTS AND ASSEMBLIES SUSCEPTIBLE TO DAMAGE BY ELECTROSTATIC DISCHARGE (ESD).

•GROUND FAULT CIRCUIT INTERRUPTER (GFCI) PROTECTION IS TO BE PROVIDED ON THE CIRCUIT(S) OR

OUTLET(S) TO BE USED FOR THE WET LOCATION PORTABLE LUMINAIRE.

•RECEPTACLES ARE AVAILABLE HAVING BUILT-IN GFCI PROTECTION AND ARE ABLE TO BE USED FOR

THIS MEASURE OF SAFETY.

•THESE INSTRUCTIONS INCLUDE INFORMATION FOR INSTALLATIONS IN BOTH HAZARDOUS LOCATIONS

AND MARINE LOCATIONS. MANY SECTIONS APPLY TO BOTH APPLICATIONS. THE APPROPRIATE WARNING

AND SPECIAL INSTRUCTIONS SHOULD BE FOLLOWED, DEPENDING ON THE APPLICATION.

OPERATING

This unit comes preconfigured with the selected Voltage, Cord Cap, and Beam Config from factory. The unit is

factory sealed and ready for use out of the box.

1. Position light in desired location near power source.

2. Plug the light into compatible outlet providing VOLTAGE LISTED ON NAMEPLATE.

3. This lamp is “instant-on” and will illuminate once power is supplied. DO NOT look directly at LED’s

when powering on.

AIMING

1. Loosen tightening knob on side of fixture.

2. Pivot light up or down to desired angle.

3. Tighten knob to secure position.

4. (If Applicable) Adjust the rotation of light with tightening bolt near the base.

Use the top handle for maneuvering the unit.

COVER REMOVAL

Rotate lens counter-clockwise to remove. Use a rectangular steel bar as needed. Excessive force must not be

used as bar may slip and cause injury. Be sure lens cover is secure before use in hazardous areas!

EPL-PM-1X30LED-100

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

2of 2

MAINTENANCE

It is recommended that you implement a standard monthly or more frequent preventive maintenance schedule.

Safety requires a thorough visual examination of the unit for physical damage that might cause a spark or

result in the ignition of hazardous atmospheres.

Maintenance includes a careful examination to ensure at least:

A. The Light Body is not cracked, broken or breeched.

B. The Lens is not cracked or chipped.

C. The Cable is not frayed and is gripping tightly in all points of cable contact.

D. The Cable Jacket is completely intact and that no internal conductors or conductor insulation

is exposed.

E. The Connection Box is not cracked, broken or breeched.

F. The Cord Plug is not cracked or damaged and the Ground Post is intact.

For your safety and to maximize the life of the light, avoid rough usage such as:

G. Pulling the Light by the Cable, which could weaken or damage the cable.

H. Impacting the lens with hard, sharp or heavy objects, which could cause the lens to scratch,

chip, crack, or shatter.

I. Disconnecting the Cord Plug from the receptacle by pulling on the Cable.

Keeping the light clean and free of material splatter, overspray, and debris during usage will ensure the

maximum life and luminosity of the light.

TROUBLESHOOTING

Refer to the guide below or contact the manufacturer if the fixture does not function properly.

Is the correct line voltage being supplied to the fixture?

Is the fixture properly grounded?

Make sure installed power switch is functioning properly (if applicable).

These instructions may not cover all details or variations of this product for your equipment or installation

requirements. Should further information not covered by these instructions be required, please contact Larson

Electronics at 1-800-369-6671 for further assistance.

Please visit LarsonElectronics.com for Warranty and Return information.

Inhaltsverzeichnis

Andere Larson Electronics Leuchte Handbücher

Larson Electronics

Larson Electronics Golight Bedienungsanleitung

Larson Electronics

Larson Electronics ATEX-EPL-TL-3X10W-C Bedienungsanleitung

Larson Electronics

Larson Electronics LED25WRE-LENSCOVER Bedienungsanleitung

Larson Electronics

Larson Electronics EPLC2-LB-40LED-RT-CM Bedienungsanleitung

Larson Electronics

Larson Electronics HALD-24-1X100LED-DIMM Bedienungsanleitung

Larson Electronics

Larson Electronics EPLC2-BS-70LED-100 Handbuch

Larson Electronics

Larson Electronics HAL-RSLED-240W Bedienungsanleitung

Larson Electronics

Larson Electronics HALP-48-2L-LED-DNMS Bedienungsanleitung

Larson Electronics

Larson Electronics GAU-WP-500LTL-LED-WG-DNMS Bedienungsanleitung

Larson Electronics

Larson Electronics IND-HR-UVC-EXS-R1-24-3L-120V-2X Bedienungsanleitung

Larson Electronics

Larson Electronics EPLC2-WPLED-100W-RT Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-LP-48W-LED Handbuch

Larson Electronics

Larson Electronics EPL-AMB-150LED-200 Bedienungsanleitung

Larson Electronics

Larson Electronics HAL-PT-LED-CPR-C-100 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-16BS-1X150LED-X24I-C1D1-200 Handbuch

Larson Electronics

Larson Electronics IND-AHF-BX-UVC-R2-120V-15C Bedienungsanleitung

Larson Electronics

Larson Electronics EPLC2-LB-45LED-RT-WLM Bedienungsanleitung

Larson Electronics

Larson Electronics EPLC2-LB-25LED-RT Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-HB-100LED-RT-JB2-6-EPP Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-WPLED-100W-RT Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-HB-3X150LED-RT Bedienungsanleitung

Larson Electronics

Larson Electronics GVP-48-2L-LED-G3 Bedienungsanleitung

Larson Electronics

Larson Electronics GL-3 Series Bedienungsanleitung

Larson Electronics

Larson Electronics LEDWL-STRB-RED-1227 Bedienungsanleitung

Beliebte Leuchte Handbücher anderer Marken

Emos

Emos CLASSIC ZY1431T Bedienungsanleitung

Westinghouse

Westinghouse Outdoor Lighting Fixture Bedienungsanleitung

Hedler

Hedler C 12 silent Bedienungsanleitung

Blizzard Lighting

Blizzard Lighting Puck: CSI Bedienungsanleitung

Energetic Lighting

Energetic Lighting ELYSL-5004 Series Bedienungsanleitung

Lightmaxx

Lightmaxx Shaft 5R Bedienungsanleitung

Triarch

Triarch 31083 Bedienungsanleitung

Philips

Philips 32614 Series Bedienungsanleitung

IKEA

IKEA TIVED Bedienungsanleitung

Lightolier

Lightolier LP200 Bedienungsanleitung

Chauvet Professional

Chauvet Professional ROGUE R1 BEAM WASH Bedienungsanleitung

Martin

Martin MAC 250 Krypton Bedienungsanleitung

Cooper Lighting

Cooper Lighting Halo L3232E Bedienungsanleitung

Stageline

Stageline ODW-2410RGBW Bedienungsanleitung

Light Sky

Light Sky Tornado Series Bedienungsanleitung

Lightolier

Lightolier Paralyte 2424 PLA2G9LS26U Bedienungsanleitung

Lightolier

Lightolier Lytespan 83ED17S Bedienungsanleitung

Lightolier

Lightolier Calculite CS8226 Bedienungsanleitung