Larson Electronics GAU-EMG-2X2W-8H Bedienungsanleitung

GAU-EMG-2X2W-8H

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 3

2W Emergency Dual LED Bugeye System

240 Lumens - 3.6V Battery Backup for 90 Mins - Damp Locations

Instruction Manual

Thank you for your purchase of the Larson Electronics GAU-EMG-2X2W-8H light system. Please follow the

steps below in order to operate and maintain this product.

IMPORTANT SAFEGUARDS

WARNING: RISK OF ELECTRIC SHOCK- NEVER CONNECT TO, DISCONNECT FROM, OR SERVICE

WHILE EQUIPMENT IS ENERGIZED.

WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH,

SERIOUS INJURY OR SIGNIFICANT PROPERTY DAMAGE - For your protection read and follow these

warnings and instructions carefully before installing or maintaining this equipment. These instructions do not

attempt to cover all installation and maintenance situations.

WARNING: RISK OF FIRE - Lamps are hot. Keep combustible material away from hot parts. Observe lamp

manufacture's warnings, recommendations and restrictions on lamp operation and maintenance. Make sure

lamps are correctly installed.

•All service shall be performed by qualified service personnel. This product must be installed and

maintained in accordance with the applicable installation codes by a person familiar with the construction

operation of the product and the hazards involved.

•This product must be installed in accordance with the applicable installation codes and ordinances.

•Before wiring to power supply, turn off electricity at fuse or circuit breaker.

•Disconnect A.C. power and unplug battery before servicing.

•Consult your local building code for approved wiring and installation.

•May be used outdoors under cover. (20°C-50°C)

•Do not let power supply cord touch hot surfaces.

•Do not mount near gas or electric heater.

•Equipment should be mounted in locations and at heights where it will not readily be subjected to

tampering by unauthorized personnel.

•The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.

•Do not use this equipment for other than intended use.

•The AC voltage rating of this equipment is specified on the product label. Do not connect equipment to any

other voltage.

SAVE THESE INSTRUCTIONS

This GAU-EMG-2X2W-8H from Larson Electronics is an Emergency LED

Bug eye System that is suitable for indoor/outdoor work sites and damp

locations. This heavy-duty emergency light features two, LED lamp heads

and a 90-minute battery backup system. Designed to operate on 120V AC or

277V AC, the fixture comes with a push-to-test switch for streamlined

inspection and maintenance. The GAU-EMG-2X2W-8H can run for 8+ hours

without installing remote heads.

GAU-EMG-2X2W-8H

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

2of 3

INSTALLATION:

1. Remove the front cover. When required, remove battery to access J-box mounting holes.

2. Mount the equipment securely in place on the wall. Two additional ‘Key Hole’ mounting holes are located at

the top of the unit housing in addition to the ‘J-Box’ mounting holes. These ‘2’ additional mounting slot

holes must be used when the unit is mounted to the wall. Additional chain support may be required by local

codes.

3. Extend 24hr AC supply of rated voltage to the equipment, which is furnished with a dual voltage

(120/277V) field selectable input. Connect unit to utility power using an approved connector. For 120V

supply connect the line wire to the Black lead and for 277V supply connect the line wire to the Orange lead.

Connect neutral wire to the White lead. The Ground wire (green lead) needs to be connected in

accordance with the local codes. DO NOT energize the circuit at this time.

CAUTION: insulate the unused Black or Orange wire. Failure to do so may cause an unsafe condition.

4. Install and connect the battery. Refer to the Illustration. Connect the Red (+) lead from the PC board

assembly to the positive (+) terminal on the battery and the Black(-) lead from the PC board assembly to

the negative (-) battery terminal.

CAUTION: Observe polarity. Failure to connect the battery properly will result in equipment failure and an

unsafe condition. NOTE: The Emergency lights will NOT come ON at this time.

5. Energize the unit with AC supply. The charge indicator will illuminate.

6. Replace the unit cover.

7. Adjust and focus the lighting heads as required.

OPERATION:

1. To test the equipment, depress the TEST switch and the emergency lights will illuminate.

2. Once you release the TEST switch the emergency lights will turn OFF.

3. The automatic charger will return into action, charging the battery and trying to maintain it in a fully charged

state.

NOTE: Allow the battery to charge for a minimum of 24 hrs. after installation or after a power failure before

conducting a 90-minute test (see TESTING section). CAUTION: This equipment is furnished with a

sophisticated solid state transfer switch which will automatically disconnect the emergency lights from the

battery if the battery has been discharged to the end of its useful output.

WARNING: UNUSED WIRES MUST BE CAPPED USING ENCLOSED WIRE NUTS.

GAU-EMG-2X2W-8H

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

3of 3

MAINTENANCE

CAUTION: Always turn OFF AC power to the equipment before servicing. Servicing should be performed only

by a qualified service technician. Only manufacturer SUPPLIED or APPROVED replacement parts must be

used.

1. BATTERY: The battery supplied with this unit requires ZERO maintenance. However it should be tested

periodically (see TESTING section) and replaced when it no longer operates the connected fixtures for the

complete duration of a 30-second or 90-minute test. It has a life expectancy of 5-7 yrs when used in a

normal ambient temperature of 72°F.

2. OTHER: Clean lenses and replace lamps as, and when, required.

NFPA 101 (Life Safety Code) requires that all emergency lighting equipment be functionally tested every 30

days for a minimum of 30 seconds and tested annually for full 90-minute duration. Written records of the

testing are to be kept for examination by the authority having jurisdiction.

TROUBLESHOOTING

1. The emergency lights DO NOT operate and:

a. If the charge indicator light is OFF — Check that the circuit breaker for AC supply is ON.

b. If the charge indicator light is ON:

Check that the battery is properly connected.

If remote lamps are connected to the equipment, then turn OFF the AC supply and disconnect the

remote circuit wires from the equipment. Turn ON the AC supply and depress the test switch. If the

local lamps (mounted on the equipment itself) come ON, then check the remote circuit for short or

overload condition and correct as required. Reconnect the circuit wires and restore AC power.

If the local lamps don't turn ON after disconnecting the remote circuit wires, then replace battery.

2. Emergency lights are dim — implies battery might not be fully charged. Allow battery to recharge for 24

hours and then re-test.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER

INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT SALES@LARSONELECTRONICS.COM OR BY PHONE AT

1-800-369-6671 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Inhaltsverzeichnis

Andere Larson Electronics Beleuchtungsausrüstung Handbücher

Larson Electronics

Larson Electronics PTB-1-75FT Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-SBDL-150RT-48 Bedienungsanleitung

Larson Electronics

Larson Electronics IND-HVAC-ACS-R1-DP-24-2L-XB Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-480V-IBSC Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-QC-16C-1X150LED-RT-100-EPP Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-EMG-CM-42W Bedienungsanleitung

Larson Electronics

Larson Electronics GAU-EMG-2X5W-LED-WP Bedienungsanleitung

Larson Electronics

Larson Electronics EPLC2-LED-50W-RT Bedienungsanleitung

Larson Electronics

Larson Electronics EPEXC-1C-10.3-GFI-50C-BCE Bedienungsanleitung

Larson Electronics

Larson Electronics EPLC2-EMG-HB-150LED-RT Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-BS-70-100 Handbuch

Larson Electronics

Larson Electronics LEDLB-12E-F-M-1227 Bedienungsanleitung

Larson Electronics

Larson Electronics IND-DHA-FUVC-EX-36-3L-V2 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-LED-150W-RT-140DB-480V Bedienungsanleitung

Larson Electronics

Larson Electronics HL-85-LED-CPR-30-TRP Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-FL1524-25-1523 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-140DB-JB3 Bedienungsanleitung

Larson Electronics

Larson Electronics GL-29000GB Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-TL-1X10W-C-DF-PA Bedienungsanleitung

Larson Electronics

Larson Electronics HID-35-RC-W Bedienungsanleitung

Larson Electronics

Larson Electronics GAU-HB-160LED Bedienungsanleitung

Larson Electronics

Larson Electronics EPLX-SL-PT-3X80W.RD2-TRC-20X-100C Bedienungsanleitung

Larson Electronics

Larson Electronics HAL-48-33W-LED-1227-70C Bedienungsanleitung

Larson Electronics

Larson Electronics EMGBALL-LED3 Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung