Your Trident I was shipped with these parts:
1 - Upper Pole Assembly
Fully assembled, including upper pole system with handle grip,
padded arm bracket, and control housing.
1 - Middle Pole Assembly with Pole Lock
1 - Nylon Lower Pole Assembly
Fully assembled, complete with two friction washers, mounting
screw, and thumb nut.
1 - 9x8 Monolithic Searchcoil with 3’cable and scuff cover
1 - 9 Volt Alkaline Battery
1 - Operator Instruction Manual
If any of these items are missing, immediately contact the Laser
Dealer where you purchased your detector.
Assembling the Trident I is simple and requires no special tools. Just
install the battery, mount the searchcoil on the lower pole assembly, con-
nect the pole assemblies together, wrap the excess cable around the pole,
and plug the cable into the control housing. Finally, adjust the pole length
and searchcoil angle and you’re ready!
Keep cables properly wound around the pole stems and protect them
during use. Floppy, pinched, or cables that become snagged during
use may short, causing erratic noises or unnecessary replacement of
the searchcoil.
Sweep the searchcoil carefully, especially when using it around rocks
and building foundations. Avoid hitting the searchcoil against hard,
solid objects and surfaces.
Keep your searchcoil slightly off of the ground during the sweep. es-
pecially when using in gravel or hard rocky dirt.
Always use a properly designed protective scuff cover on the search
coil.
Remove and clean out scuff covers periodically to avoid buildup of
mineralized dirt particles which will affect performance.
The searchcoil is waterproof and can be submerged in either fresh or
salt water. After the searchcoil is used in salt water, rinse it and the
lower stem assembly well with fresh water to prevent corrosion of the
metal parts.
The searchcoil is waterproof but the electronics are not, so always
prevent any moisture or water from entering the control housing and
never allow the cable connectors to become submerged in water.
If working in or near water, or if there is a possibility of rain, use a pro-
tective weather resistant pouch or plastic bag to cover the control
housing. Make sure it can “breathe” in order to ensure against con-
densation buildup inside.
After each use, clean the detector with a soft cloth to remove dust,
moisture, or other contaminants.
When transporting the detector in a car during hot weather, store it on
the floor of the passenger compartment if possible. Using a carry bag
gives additional protection. In any case, never allow the detector to
roll around unprotected in the boot or back of a pickup truck.
Protect your detector from dust, moisture, and extreme temperatures
during storage.
When shipping, use the original factory carton or similar heavy-duty
container and provide a minimum one inch of padding around all
parts.
Treat your detector as you would any sensitive electronic instrument.
Though ruggedly constructed and designed to withstand the demands
of normal treasure hunting, proper care is essential.
GETTING STARTED
UNPACKING THE BOX
20 TRIDENT I OPERATIOR INSTRUCTION MANUAL GETTING STARTED 1
