Lava Aire Aviator X2 Bedienungsanleitung

@2012.11-V1.0 WT-4C Page 2 of 13

Contents

Instruction............................................................................ .... ...2

Outline Drawing....................................................................... ...2

Wiring Diagram...................................... ................................. ...2

Installation Instructions............................................................3-6

Checking after Installation...........................................................7

Trial Operation........................................................................ .....8

Attentions…………………………………..…….……..…...9-10

Common Malfunction Analysis and Maintenance………...11-12

PICTURES ARE ONLY FOR INFORMATION, TAKE MATERIAL OBJECT AS STANDARD

@2012.11-V1.0 WT-4C Page 3 of 13

■Instruction

Misting Air Coolers adopt user-friendly design and colorful appearance. The mist

particles (diameter of 10-25 microns) emitted by misting device will take away the heat

through evaporation, which travel to target area when the fan blows. In the effective area,

it can decrease temperature by 3-8℃and help increase relative humidity, reduce dust and

purify air, which makes a comfortable living & working space.

The internal structure uses independent control devices and human-intelligent

warning protection system, which separates electricity from water so as to eliminate safety

risk. Featured by non-clogged misting system, low energy consumption, low pollution,

low noise, low heat & low carbon, our products are widely used in various public places,

such as open square, playgrounds, stadiums, airports, walk streets, bus stations, outdoor

restaurant and villa gardens; they are also used in industrial workshops of textiles,

porcelain, casting factories & etc.

■Outline Drawing

■Electrical Schematic Diagram (WT-4C)

Fan head

Elbow

Water tank

Lower cover

Upper cover

1.3

#!#

Picture 1

Screws: 4x M8*80

1.35 m from ground

Elbow

Picture 2

Picture 3

Outlet pipe: orange;

Inlet pipe: blue.

4 x M6*16

Leads: 6pin/4pin/3pin

5 13

 8

 6

Picture 4

Screws: 4xM8*80

Picture 5

4 x M6*16

Water tank

Picture 6

4xST4*20

Leads of the

fan head

Leads of the lower part

6 13

Regulating Valve Submersible pump Floater

Picture 7

Outlet pipe: orange;

Inlet pipe: blue—connect submersible pump

Picture 8

Joint of the inlet pipe

Power cord

2 x ST4*16

Upper cover

@2012.11-V1.0 WT-4C Page 7 of 13

Checking after Installation

1. Install the product according to the Instructions, check whether all the parts

are firmly connected.

2. Twirl the impeller with insulating material, like batten. Check the normal

rotation and isolation between the blades and casing.

3. Before using, check whether the voltage and frequency on the nameplate

match those in use. Then add water into the tank (manual inflowing or

automatic inflowing). Check whether there is any leakage of the water tank.

4. Power on the product to see its operation. Switch on each speed, check

whether it sounds abnormal, vibrates obviously. Press the button "MIST", 10

seconds later, rotate the "Mist regulating Switch" from “Min" to "Max", and

check whether mist is normal. Power off the product immediately once there

are some abnormalities.

8 13

Swaying Switch

Misting Switch

Blowing Switch

@2012.11-V1.0 WT-4C Page 9 of 13

regulating switch” from “Min” to “Max”.

■ Attentions:

Please carefully read the following items:

Caution:The product MUST be connected to the power with leakage protection device.

Make sure firmly plugged Be sure not to take off the

plug while operating.