5
A STEELFORT PRODUCT
• Ensure you wear safety goggles, non-slip
shoes, and gloves, and rmly grip the tools.
• Wear protective gloves, keep your hands away
from the switch and the tools powered off
when replacing the blade to avoid injury.
• Operate the tool in the correct way to avoid
personal injury due to improper operation.
• Use original accessories or accessories
provided by the original factory.
• Recycle and reuse damaged machines,
Accessories and waste packaging in
accordance with local laws and in an
environmentally friendly way.
BATTERY PACKS
• Disconnect the switch and remove the battery
pack before performing any work, such as
changing tools, inspection, maintenance,
transportation, storage, etc.
• Ensure that the battery pack is properly
installed before using the tool.
• It’s a normal phenomenon that the battery pack
will become slightly hot during charging.
• Do not charge a damaged battery pack.
• After charging, please cut off the power supply
and then unplug the battery pack from the
charger. Do not put the battery pack in the
charging body for a long time.
• Do not insert the charged battery pack into the
charger when the tool is not in use
• Do not attempt to disassemble the battery
privately, its maintenance or repair shall be
handed over to professional maintenance
personnel to avoid danger of electric shock or
re due to incorrect assembly.
• Do not short circuit the battery pack
• Don’t burn the battery pack, it will explode in
the re.
• Do not drop, vibrate or impact the battery pack.
• Do not use the battery pack as a hammer.
Knocking on the battery pack may cause
accidental short circuit, re or explosion.
• The battery pack must be kept away from
high temperature or ame! Do not place it on
the heater or expose it to strong sunlight for
a long time. High temperature brings a risk of
explosion.
• Please keep workplace well ventilated. The
toxic gas emitted by the damaged battery
pack or that is not used in accordance with the
specied requirements may cause personal
injury.
• If the battery pack is overused or overheats,
it may leak. Clean or replace contaminated
parts as needed. The affected parts and the
leaking battery should not be used. If leakage
contacts the skin, wash with soap, followed by
lemon juice or vinegar. If it comes into contact
with the eyes, rinse with clean water and seek
immediate medical attention. Battery pack
leakage can cause corrosion or burns.
• If the service time of the battery pack is
signicantly shortened after each charging,
please replace it with a new battery pack or go
to the maintenance point for inspection.
• The battery pack shall be moisture-proof and
mildew proof. Please keep it away form water
and rain.
• Please store the battery pack after fully
charged.
• The storage ambient temperature range
of battery pack is 0-45° Too high or low
temperature would affect its capacity.
• Keep the battery pack away from metal objects
like paperclips, coins, keys, nails, screws, or
other small metal parts, as they can create a
connection with the battery pack contacts.
Short-circuiting the battery pack contacts can
result in sparks, burns, or res.
• Do not discard the scrapped battery pack in
general household waste, ame or water.
• Collect the damaged battery packs and send
them to the recycling center for disposal or
dispose of them in an environmentally friendly
way.
• Do not charge the battery pack when the room
temperature is lower than 10°or higher than 50°
When the room temperature is lower than 0°, it
may not be charged.
• If the lithium hand saws are not used for a long
time, it is necessary to fully charge the battery
and charge it once every three months for
preservation.
Before using this tool, familiarise yourself with its
functions and operating instructions. Stay alert at
all times to prevent injury.
