LCSI BESP-7616W Bedienungsanleitung
Web Smart Switch Configure
Please follow the steps to configure this Web Smart switch.
Step 1: Use a twisted pair cable to connect this switch to your PC.
Step 2: Set your PC’s IP to 192.168.2.xx.
Step 3: Open the web browser (like IE…), and go to 192.168.2.1
Then you will see the login screen.
ID and the password: admin
Step 4: After the authentication procedure, the home page shows up.
Select one of the configurations by clicking the icon.
- Administrator
- Port Management
- VLAN Setting
- Per Port Counter
- Trunk Setting
- QoS Setting
- Security Filter
- Configuration Backup/Recovery
- Miscellaneous
- Logout
Administrator: Authentication Configuration
1. Change the user name and the password.
2. Click “Update” to confirm the new change.
3. Turn off the power and reset this switch.
4. After resetting, turn on the switch for the new change.
Now, you can use the new user name and the password.
Administrator: System IP Configuration
1. Change the IP address: type the new IP address or select
DHCP IP configuration.
2. Click “Update” to confirm the new change.
“Setting Process OK!!” will be shown on the screen.
3. Turn off the power and reset this switch.
4. After resetting, turn on the switch for the new change.
Now, the setting of “System IP Configuration” is finished.
Administrator: System Status
MAC address and system version will be shown on the screen.
1. Change the new comment of this switch by typing the new
comment.
2. Click “Update” to confirm the new change.
Now, the setting of “System Status” is finished.
Administrator: Load Default Setting
1. Click “Load” to back to the factory default setting.
2. Turn off the power and reset this switch.
3. After resetting, turn on the switch for the new change.
Now, the default is loaded.
Administrator: Firmware Update
Follow the instruction on the screen to update the new firmware.
Please contact with your sales agents to get the latest firmware
information.
Administrator: Reboot Device
1. Click “Confirm” to reboot the device.
Now, the setting of “Reboot Device” is finished.
Port Management: Port Configuration
Select the “Port No.” - configure the mode below:
1. “Auto-Negotiation” - enable/disable this function of the port.
2. “Speed” - select the 10M or 100M mode of the port.
3. “Duplex” - select the port is full or half-duplex mode.
4. “Pause” - enable/disable the port.
5. “Backpressure” - enable/disable the backpressure of the port.
6. “Tx Capability” - enable/disable TX capability of the port.
7. “Addr. Learning” - enable/disable this function of the port.
Inhaltsverzeichnis
Andere LCSI Schalten Handbücher
