To install the remote display, proceed as follows:
1. Connect the green core (anode) of the flat cable to the "Green"
(+) LED connection of the battery watch.
2. Connect the white core of the flat cable to the LED connection
(-) of the battery watch.
3. Connect the brown core of the flat cable to the LED connection
"Red" (+) of the battery watch.
ðThe remote display is installed. The operating status of the bat-
tery watch is displayed.
Operating status
Display Status
LED lit green Battery voltage is above the alarm threshold
setting, device is active.
LED flashes green External switch is closed, consumers are
switched off.
LED lit orange Safety level 1: Below alarm threshold. Bat-
tery voltage will soon reach the switch-off
voltage.
1. Switch the consumers off or charge the
battery
LED flashes red Safety level 2: Below switch-off voltage.
Consumers have been disconnected from the
battery to avoid deep discharge.
2. To supply consumers again, charge the
battery to the switch-on voltage.
LED no colour Device is switched off or incorrectly installed.
Disposal
Dispose of the device in accordance with the Waste
Electrical and Electronic Equipment Regulations
(WEEE).
The system must not be disposed of with household
waste. Take it to a recycling point or return it to your
point of sale.
EU Declaration of Conformity
The Remote Display for Battery Watch (3-colour
LED) complies with the requirements of the following
directives:
– 2014/30/EU: EMC
– 2011/65/EU: RoHS
LEAB Automotive GmbH // Thorshammer 6 // 24866 Busdorf
