Beforeyouswitchon
Pluginandswitchon
Temperature control
Your wine cooler shouldnot beinstalled ona
carpet, this may prevent sufficient air
circulation.
Don't locate your wine cooler near a heat
source, e.g. cooker, boiler or radiator. Avoid
placing in direct sunlight. An unheated
garage or outbuilding is also inappropriate.
Your wine cooler was not designed to
operate in an ambient temperature of less
than16°C.
When installing it is important to keep a
minimum clearance of 50mm (2”) all around
thecabinettoallowforventilation.
Removeallexternal andinternal packing.
cleanyourwinecooler
We recommend that you clean your wine
cooler before use, refer to the section
‘Cleaningyourwinecooler.’
leaveyourwinecoolerfor2hours
Before switching on leave your wine cooler
upright for 2 hours to allow the coolant fluid
timetosettle.
ensureyourwinecoolerislevel
Yourwine coolerhasfour adjustablelevelling
feet, two at the front and two at the back. A
very slight backward lean will ensure that the
doorclosesbetter.
The wine cooler runs on an electricity supply
of220-240V 50Hzand mustbe earthed.
Plug inthe winecoolerandswitch iton atthe
socket.
To turn your wine cooler off,switch off at the
socket.
doorlock
Yourwinecooleris fittedwitha doorlockthat
does not lock the door until the key is
removed.
goingonholiday
If you’re going on holiday you may wish to
leave your wine cooler running, alternatively,
switch off, empty, clean and dry your wine
cooler and leave the door propped open to
allowthefree movementof air.
1
electronic temperature controller
The internal temperature of your wine cooler
is controlled by an electronic temperature
controllersituatedinthefrontpanel.
When you first switch the wine cooler
on, wait for 30 minutes before altering
the setting to let the wine cooler
stabilise. During this time the ‘Red’ wine
light may stay on.
The wine cooler is preset from the
factory to automatically accommodate
temperature requirements for red or
white wines. If you store mostly white
wines, press the ‘White’ button and the
wine cooler will maintain an average
temperature between 7 and 10°C.
Pressing the ‘Red’ button will yield an
average temperature between 13 and
16°C.
The wine cooler can be set to any
temperature required. To set the
temperature, press both the ‘Red’ and
‘White’ buttons simultaneously and
hold for approximately 3 seconds. You
are now in the ‘Temperature Set’ mode.
Decrease the temperature by pressing
the ‘White’ button and increase the
temperature by pressing the ‘Red’
button. When the temperature is set,
press the ‘Light’ button to return to
normal operating mode, the
temperature display will revert to
displaying the current internal
temperature.
There is up to a+/-3degree variance
between the temperature set and the
temperature indicated on the LED
readout. This is because of the cyclical
way that the cooler operates. There may
be up to 10°C variation between the top
and bottom shelves of the wine cooler.
therefore, if you have set the wine
cooler to 10°C and have a mix of red and
white wines, you may want to put the
white wine on the bottom shelf where
the temperature will be approximately
7°C and the red wine on the top shelf
where the temperature will be
approximately 13°C.
The temperatures achieved by the wine
cooler, between approximately 7°C and
16°C, are specifically designed for the
storage of wine and are not suitable for
the storage of food.
2
10
