1. The product shall be installed and serviced by a qualified person.
2. The product is non-waterproof. Please avoid the sun and rain.
3. Good heat dissipation will prolong the working life of the controller. Please ensure good ventilation.
4. Please check if the output voltage of any power supplies used comply with the working voltage of the
product.
5. Ensure all wire connections and polarities are correct and secure before applying power to avoid any
damages to the LED lights.
6. If a fault occurs please return the product to your supplier. Do not attempt to fix this product by yourself.
Safety information
Malfunctions analysis & troubleshooting
Malfunctions
Causes Troubleshooting
Uneven intensity
between front and
rear,with voltage drop
1. Output cable is too long.
2. Wire diameter is too small.
3. Overload beyond power supply capability.
4. Overload beyond controller capability.
1. Reduce cable or loop supply.
2. Change wider wire.
3. Replace higher power supply.
4. Add power repeater.
No response
from the remote
1. The battery has no power.
2. Beyond controllable distance.
3. The controller did not match the remote.
1. Replace batter y.
2. Reduce remote distance.
3. Re-match the remote.
1. No power.
2. Wrong connection or insecure.
1. Check the power.
2. Check the connection.
No light
Wiring diagram
User Manual Ver 1.0.2 Page 2
V1-W+ RM1 Single Color LED Controller Kit
Dimming remote
+
-
Power Supply
12-24VDC
Constant Voltage
AC100-240V
5m single color LED strip
+
V1 -W L ED R F Di mm er
Uin :12-2 4VDC
Iou t: Max. 3A
Outp ut
V+
V-
Inpu t
Match:
Switch off the power, then switch on power again, immediately short press on/off key 3 times on the remote.
The light blinks 3 times means match is successful.
Delete:
Switch off the power, then switch on power again, immediately short press on/off key 5 times on the remote.
The light blinks 5 times means all matched remotes were deleted.
Match guide
