Headgear
The headgear is controlled by Velcro and can easily be adjusted."It also comes
with multiple fitting points for the cable from the lamp case and its plug, and for
the cable from the main battery that is threaded through a loop before it con-
nects to the lamp case. At the back of the headgear there is a Dual Lock™
Velcro to attach the backup battery.
Put on the headgear like this:!
Release the lower headband and elastic on the back of the headgear."Let the
upper elastic attach about half way on the
Velcro.
Put on the headgear, pull it down as far as
possible or until it sits comfortably. Adjust the
length of the upper band until comfortable.
Adjust the lower band so it fits tightly in the
neck.
Then adjust the clasp at the top band.
!
At-
tach the cables to the main battery and the backup battery according to the
pictures.
The lamp case
!
Connect the battery to the lamp case. Be careful to fit the white markings on
the contacts to each other; if they are incorrectly fitted and forced together the
contact pins might break.
Right Wrong
The switch is placed at the bottom of the lamp case. Light the lamp by
pressing the switch until the lamp turns on (1-3s). The lamp starts on the lo-
west effect, default at 6%, use short clicks to up the effect. Turn it off by
pressing the switch until it turns off.
The lamp has a heat protection; if the lamp becomes warmer than 75 ° C it
slowly decreases the amount of light in small steps. When the temperature
drops it automatically increases the light again. If you use the lamp indoors it
will adjust the light after the lamp temperature. For outdoor use, the light
needs to be in motion to give 100%. There is an emergency built-in, if the lamp
has been covered or for any other reason reached 95 ° C, the lamp turns off
completely.
The lamp case can easily be removed from the headgear by lightly press the
top part of the attachment plate and simultaneously pull the lamp upwards.
The lamp is water resistant, but should not be used underwater.!
!
Batteries
The main battery is a Li-Ion battery; these are characterized by a high capaci-
ty and low self-discharge."It is carried conveniently in a rear harness, waist or
in a pocket."It is water resistant but should not be immersed in water."At delive-
ry, the battery is partly charged, it must therefore be charged before using the
lamp."Make sure you use the correct charger when charging the battery.!
The back up-battery (option) is a Li-Pol battery with high capacity and low
self-discharge."It is placed in the battery holder on the back of the head
gear."The back-up battery is completely waterproof. It gives light for about 80
min with 6 % power."The lamp recognizes that the back-up battery is connec-
ted and you cannot up the effect.!
