SRC Quick Setup Guide 7
SRC_QSG_0A_3.5.10_E 255-80-0063-00 RoHS
You can connect only one or both inlets to proper power
sources.
1. Connect each SRC to an appropriately rated branch
circuit. Refer to the label or nameplate affixed to your SRC
for appropriate input ratings or range of ratings.
2. When a SRC powers up, it proceeds with the power-on self
test and software loading for a few moments.
3. When the software has completed loading, the front panel
display illuminates.
QSRu le
Connecting SRC to Your Network
SRC can be connected to a wired or wireless network.
To make a wired connection:
1. Connect a standard network patch cable to either or both
Ethernet ports on the SRC.
2. Connect the other end of the cable to your LAN.
Note: The "green" Ethernet port labeled "ETH 10/100/1000"
supports up to 1000 Mbps so it is highly recommended for
network connection. If connecting both ports to the LAN, you
must connect them to two "different" subnets. If you are not
sure whether the device is connected to the same or different
subnets, contact your IT department.
To make a wireless connection:
1. Connect an appropriate USB wireless LAN adapter to SRC.
2. Make sure the wireless LAN configuration is supported by
your SRC. See
Appendix B: Wireless LAN Information
(on page 8).
QSRu le
Using a Web Browser
Initial configuration using a web browser involves these two
steps.
Step 1: Retrieve the IP Address
(on page 7)
Step 2: Log in to the SRC Web Interface
(on page 7)
Step 1: Retrieve the IP Address
After connecting to a DHCP IPv4 network, an IPv4 address is
automatically assigned to your SRC. You can operate the front
panel display to retrieve the IPv4 address. See
Using the
Front Panel Display
(on page 7).
Tip: You can also retrieve the IPv4 address by connecting an
iOS or Android mobile device to SRC. See
Appendix A:
Configuration via a Mobile Device or PDView
(on page 8).
Using the Front Panel Display
The SRC front panel display is similar to the diagram below.
To retrieve the IP address:
1. Press or to show the "Main Menu."
2. Press or to select "Device Info," and press
.
3. Press or until the device's IP address is
displayed.
Step 2: Log in to the SRC Web Interface
The SRC supports common web browsers, including Microsoft
Internet Explorer®, Mozilla Firefox®, and Google®Chrome.
To access the SRC web interface:
1. Open a web browser and type the IP address of SRC.
2. Accept any security warnings that may appear.
3. Type the default user credentials and click Login.
User name: admin
Password: raritan
4. When prompted to change the password, change or ignore
it.
To change it, type the new password and click Ok.
To ignore it for this time only, click Not Now.
To ignore it permanently, select "Do not ask again" and
click Not Now.
It is highly recommended to change the default password.
Make sure the new password is noted down and kept in a
secure place.
Step 3: Configure SRC
After logging in to the SRC web interface, you can navigate the
left menu and then:
Choose Asset Strips for configuring connected asset
strips.
Choose Peripherals for configuring connected
environmental sensor packages.
Choose SmartLock for configuring connected door
handles or SmartLock kit.
