LEGRAND HKRL10 Bedienungsanleitung

installation guide

Smart Switch

Room . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

HKRL10

with HomeKit Technology

table of contents

before you start..................................3

what you need ...................................4

getting to know your switch ..........6-7

installation and setup ................ 8–23

speciﬁcations.............................24-25

faqs ....................................... 25–29

regulatory information ......... 30–33

warranty.......................................34

support ........................................35

before you start

Review this guide in its entirety before beginning device installation. Consult an

electrician with any questions or if you are unsure of your abilities.

DWarning: Incorrect installation could

result in death, serious injury, and/or

damage to your home or devices.

DCaution: To reduce the risk of injury

and/or overheating and damage to other

equipment:

• For dry, indoor use only.

• Do not use to power medical equipment.

• Not suitable as a disconnecting means.

• Do not use with loads exceeding the

device load rating (see page 24).

• Connect the smart switch to a

120 VAC, 60 Hz power source ONLY.

• Always use copper wire to install the

smart switch and follow all applicable

local and national electrical codes.

• Install in a non-metallic electrical box

to protect wireless signal strength.

Visit the Legrand website at www.legrand.us/radiant/homekit.aspx to learn more about

your smart device.

what you need

REQUIRED:

Phillips-head screwdriver

Flat blade screwdriver

YOU MAY ALSO NEED:

Non-contact voltage tester, pliers, wire cutter, wire stripper, electrical tape,

ﬂashlight, radiant®screwless wallplate (included), wiring leads (included), and

wire nuts (included)

NOTE: Exercise caution when using power tools. Overtightening the screws can

damage the device.

getting to know your switch

Item Name Description

1 Paddle Switch

• Press the top of the paddle to turn the light on

and the bottom to turn the light off.

• To return the switch to factory default, press and

hold the top of the paddle for 15 seconds. Then,

remove the device from the Legrand Home app

(or Apple Home app).

2 LED Locator Light Indicates the current state of the device. Refer to

“LED Locator Light Explanations” for detail.

NOTE: For in-wall control of this switch in a three-way application, refer to the installation

instructions for the HomeKit Remote Switch (HKRL20).

LED LOCATOR LIGHT EXPLANATIONS

LED

Color State of Light Explanation

Slowly Flashing

Amber

Device is attempting to connect to

the network

Solid White Connected to Wi-Fi and turned off

No Light Device is on

Rapidly Flashing

Amber

N-Way Pairing mode: device is

ready to pair with the remote(s)

installation & setup

step one

turn off the power for your device at the

circuit breaker

Flip the existing light switch multiple times to conﬁrm the power is off.

NOTES:

• If there are multiple devices next to your existing light switch, make sure power is

off at the circuit breaker for all of those devices.

• For multi-way installations using a remote switch, follow the instructions for the

remote device (HKRL20).

OFF

installation & setup

step two

remove the existing device

Check for the following wires:

1HOT or LINE: Receives power from the circuit box. Referred to as “hot” for the

purposes of this guide. Do not touch or let “hot” wires contact other wires.

2LOAD: Directs power to your light(s).

3NEUTRAL: Creates a path to return current to the power source when the

device is off. Required for your switch installation.

4GROUND: Provides a safe path for electricity in the event of a short circuit.

NOTE: Refer to the “faqs” on page25 if you are unsure of your wiring.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere LEGRAND Schalten Handbücher

LEGRAND

LEGRAND 4128 58 Bedienungsanleitung

LEGRAND

LEGRAND In One 916 29 Bedienungsanleitung

LEGRAND

LEGRAND 300 W RF Bedienungsanleitung

LEGRAND

LEGRAND Wattstopper LMSW-632-S Bedienungsanleitung

LEGRAND

LEGRAND DPX3 250 Bedienungsanleitung

LEGRAND

LEGRAND Mosaic Bedienungsanleitung

LEGRAND

LEGRAND HS4658 Bedienungsanleitung

LEGRAND

LEGRAND 0 670 26A Bedienungsanleitung

LEGRAND

LEGRAND AlphaRex3 DY21 GPS/DCF Bedienungsanleitung

LEGRAND

LEGRAND Watt Stopper RS-100BA Bedienungsanleitung

LEGRAND

LEGRAND Mallia Senses Bedienungsanleitung

LEGRAND

LEGRAND In One 882 10 Bedienungsanleitung

LEGRAND

LEGRAND DPX3 Bedienungsanleitung

LEGRAND

LEGRAND Galion 2 824 26 Bedienungsanleitung

LEGRAND

LEGRAND Wattstopper WS-301 Bedienungsanleitung

LEGRAND

LEGRAND Wattstopper InteliSwitch AS-100 Bedienungsanleitung

LEGRAND

LEGRAND 34061 Bedienungsanleitung

LEGRAND

LEGRAND 0 488 07 Bedienungsanleitung

LEGRAND

LEGRAND C2G 4K60 Bedienungsanleitung

LEGRAND

LEGRAND 784 47 Bedienungsanleitung

LEGRAND

LEGRAND 916 30 Bedienungsanleitung

LEGRAND

LEGRAND DRD3 v2 Bedienungsanleitung

LEGRAND

LEGRAND Radiant Series Bedienungsanleitung

LEGRAND

LEGRAND 0 784 61L Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung