damaged.
If the power cord is damaged, you must have it replaced at a service centre with qualified
persons in order to avoid a hazard.
Do not use the heated towel rail with a timer or separate remote control system. Do not
use the heated towel rail with an extension lead, power board or double adaptor.
Plug the cord directly into an appropriate power point. To provide continued protection
against risk of electric shock, connect it to properly grounded power points only.
Do not connect the plug into a power point which is exposed to splashing
The heated towel rail must not be located immediately below a power point.
Ensure that the heated towel rail is located at least 0.6 m from basins, bathtubs and
showers.
The heated towel rail is to be installed so that switches and other controls cannot be
touched by a person in the bath or shower.
Do not use the power cord under floor mats or carpet to avoid the danger of trip hazard.
Arrange the power cord away from traffic areas so that it will not be tripped over by
anyone.
Do not place any objects inserted into vents and exhaust ports, as it may cause an electric
shock, fire and damage the product.
Do not use the appliance in areas where gasoline, paints, or flammable liquids are used
or stored.
Use this product strictly as description in this manual to avoid the cause of fire, electric
shock, or injury to persons.
Unplug the heated towel rail while it is not in use or before cleaning.
Do not wrap the heated towel rail with towels, quilts when in use. Just lay the towels and
quilts on the unit.
This appliance is intended only for drying textiles washed in water.
FOOT INSTALLATION:
Align the bottom feet with the holes under the towel
rack, and tighten the screws with a screwdriver (not
included).
OPERATING INSTRUCTIONS
1. Plug the power cord into a power point.
2. Press the power switch to the (l) position, the power
indicator will light up and the heated towel rail will start to work.
3.Press the power switch to the [o] position, the power indicator light will be off and the
heated towel rail will stop working.
CLEANING
1. Before cleaning, turn the heated towel rail off and disconnect it from the power point.
Allow it to cool down.
2. Do not put the product, power cord and plug into the water. Keep the cord dry.
3. Never clean the product with alcohol or solvent-based cleansers.
4. Clean the surface with a soft damp cloth first and then dry it with a soft cloth. NOTE:
Do not use a scourer or a rough cloth to wipe the towel rail, it will scratch the surface of
the product.
5. Do not us alcohol or solvents on plastic components, it will cause the cracking and
ageing of these parts.
SPECIFICATION
Power Source: 220-240 V AC, 50Hz, Class I
Rating Power Input :100W
IP rating: IPX4
Unit Size: 90 x 52 x 36.5 (H x W x D) cm
