LevelOne FSW-1650 Bedienungsanleitung

FSW-1650

FSW-2450

User Manual

16/24-Port 10/100 Rackmount Switch

V2.0.0.0812

Specifications are subject to change without notice. LevelOne is a registered

trademark of Digital Data Communications Asia Co., Ltd. Other brands and

product names are trademarks or registered trademarks of their respective

holders.

No part of the specifications may be reproduced in any form or by any means or

used to make any derivative such as translation, transformation, or adaptation

without permission from Digital Data Communications Asia Co., Ltd. All rights

reserved.

FCC STATEMENT

The Switch has been tested and found to comply with the limits for a class A

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation.

This equipment generates, uses and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

¾Reorient or relocate the receiving antenna.

¾Increase the separation between the equipment and receiver.

¾Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

¾Consult the dealer or an experienced radio/TV technician for help.

EC DECLARATION OF CONFORMITY (EUROPE)

In compliance with the EMC Directive 89/336/EEC, Low Voltage Directive 73/23/

EEC, this product meets the requirements of the following standards:

¾EN55022

¾EN55024

¾EN60950

SAFETY NOTICES

Caution:

Do not use this product near water, for example, in a wet basement or near a

swimming pool.

Avoid using this product during an electrical storm. There may be a remote risk

of electric shock from lightning.

Package Contents:

The following contents should be found in your box:

¾One FSW-1650 / FSW-2450 Switch

¾One power cord

¾This User's Guide

¾Mounting screws and two “L” planks

)Note:

Make sure that the package contains the above items. If any of the

listed items are damaged or missing, please contact with your

distributor.

CONTENTS

Chapter 1 Introduction of the Product ...........................................1

1.1 Overview of the product ..................................................................1

1.2 Features..........................................................................................1

Chapter 2 Installation.......................................................................1

2.1 Mounting the Switch on a Desk....................................................... 1

2.2 Mounting the Switch in a Rack........................................................ 2

2.3 Power on......................................................................................... 3

Chapter 3 Identifying External Components..................................3

3.1 Front Panel......................................................................................3

3.2 Rear Panel......................................................................................3

Appendix A: Specifications.............................................................5

Appendix B: Troubleshooting.........................................................6

FSW-1650/FSW-2450 10/100 Rackmount Switch User's Guid

Chapter 1 Introduction of the Product

This chapter describes the features of the model of FSW-1650/FSW-2450

16/24- port 10/100 Rackmount Switch. FSW-1650 and FSW-2450 just

differ in the number of LED indicators and ports, all figures in this guide

are of FSW-2450.

1.1 Overview of the product

FSW-1650/FSW-2450 16/24-port 10/100 Rackmount Switch provides

16/24 10/100Mbps Auto-Negotiation RJ45 ports. Each port of the FSW-

1650/FSW-2450 supports auto MDI/MDI-X function, eliminating the need

for crossover cables or Uplink ports. The Switch is Plug- and-Play and

any port can be simply plugged into a server, a hub or a switch, using

straight cable or crossover cable.

The LevelOne FSW-1650/FSW-2450 16/24-port 10/100 Rackmount

switch provides you with a low-cost, easy-to-use, high-performance,

seamless and standard upgrade to improve your old network to a

100Mbps network. It will boost your network performance up to full duplex

data transfer.

1.2 Features

¾Complies with IEEE802.3, IEEE802.3u standards

¾16/24-Port 10/100M Auto-NegotiationRJ45portssupporting Auto-

MDI/MDIX

¾Supports IEEE802.3X flow control for full-duplex mode and

backpressure for half-duplex mode

¾LED indicators for monitoring power, link, activity, speed

¾Standard 19” rack-mountable steel case

¾Internal power supply

Chapter 2 Installation

2.1 Mounting the Switch on a Desk

Before placing the Switch on a desk, attach four rubber feet to the flutes

on the Switch bottom, then lay the Switch on the desktop,

FSW-1650/FSW-2450 10/100 Rackmount Switch User's Guid

where it is able to withstand 5kg of weight.

)Note:

Make sure there is a grounded AC outlet within 1.5 meters, and

working well. Make sure there is free space for radiating heat

and air.

Make sure not to place anything to heavy on top of the switch.

2.2 Mounting the Switch in a Rack

The dimension of FSW-1650 / FSW-2450 is designed according to the

standard 19” rack-mountable steel case of Electronic Industries

Association.

Powers off all the equipment connected to the Switch before mounting it

in the rack, then rivet the two “L” brackets onto each side of the Switch,

and fasten it with screws in the rack.

Figure 2-1 Rivet the ‘L’brackets onto the Switch

Figure 2-2 Fasten the Switch in the rack

FSW-1650/FSW-2450 10/100 Rackmount Switch User's Guid

2.3 Power on.3 Power on

The FSW-1650/FSW-2450 16/24-port 10/100 Rackmount switch is

by power cord. Powering on the Switch, it will be automatically initialized

and the LED indicators should respond as follows:

The FSW-1650/FSW-2450 16/24-port 10/100 Rackmount switch is

by power cord. Powering on the Switch, it will be automatically initialized

and the LED indicators should respond as follows:

1) All of the LED indicators will flash momentarily for one second,

which represent a resetting of the system.

1) All of the LED indicators will flash momentarily for one second,

which represent a resetting of the system.

2) The Power LED indicator will light up.2) The Power LED indicator will light up.

Chapter 3 Identifying External ComponentsChapter 3 Identifying External Components

This Chapter describes the front panel, rear panel and LED indicators of

the Switch.

This Chapter describes the front panel, rear panel and LED indicators of

the Switch.

3.1 Front Panel3.1 Front Panel

The front panel of FSW-2450 consists of switch model, switch LED

indicators, and 24 10/100Mbps RJ-45 ports.

The front panel of FSW-2450 consists of switch model, switch LED

indicators, and 24 10/100Mbps RJ-45 ports.

Figure 3-1 FSW-2450 Switch Front Panel sketch

3.2 Rear Panel

The rear panel of FSW-2450 only features an electrical outlet, which is an

AC electrical outlet. Connect the female of the power cord head here, and

the male head to the AC power.

Figure 3-2 FSW-2450 Switch Rear Panel sketch

LED indicators

The LED indicators include Power, Link/Act LED indicators, which are

used for monitoring and pre-troubleshooting of the Switch. The following

FSW-1650/FSW-2450 10/100 Rackmount Switch User's Guid

section shows the LED indicators of the Switch along with an explanation

of each indicator.

Figure 3-3 FSW-2450 Switch LEDs sketch

¾Power LED: This indicator will light solid red when the Switch

powers up. If the LED is not lit, please check the power supply and

connection.

¾LINK/ACT LED: The LED indicates Link/Active status. The

corresponding LED indicator will light solid green when connected to

a network device. It flashes green when data is being transmitted or

received on the working connection.

¾100Mbps: The corresponding gigabit port LED indicator will light

solid green when it's working on 100Mbps speed, not lit when

working on 10Mbps speed.

FSW-1650/FSW-2450 10/100 Rackmount Switch User's Guid

Appendix A: Specifications

General

Standards IEEE802.3 10Base-T IEEE802.3u 100Base-TX

Topology Star

Protocol CSMA/CD

Data Transfer Rate Ethernet: 10Mbps (Half Duplex), 20Mbps (FullDuplex)

Fast Ethernet: 100Mbps (Half Duplex), 200Mbps (Full

Duplex)

Number of Ports 16/24 10/100Mbps Auto-Negotiation RJ-45 ports

Safety & Emissions FCC, CE

Environmental and Physical

Operating Temperature 0°C ~40°C

Storage Temperature -40°C ~70°C

Operating Humidity 10%~90% non-condensing

Storage Humidity 5%~95% non-condensing

Andere Handbücher für FSW-1650

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere LevelOne Schalten Handbücher

LevelOne

LevelOne HDSpider Series Bedienungsanleitung

LevelOne

LevelOne FSW-1609TFX Bedienungsanleitung

LevelOne

LevelOne ProCon GSW-1291 Bedienungsanleitung

LevelOne

LevelOne FSW-0512 Bedienungsanleitung

LevelOne

LevelOne GES-2105P Programmierhandbuch

LevelOne

LevelOne FSW-0508TX Bedienungsanleitung

LevelOne

LevelOne OfficeCon GSW-0841 Bedienungsanleitung

LevelOne

LevelOne GSW-5150 Bedienungsanleitung

LevelOne

LevelOne ProCon GSW-4896 Bedienungsanleitung

LevelOne

LevelOne IFP-0504 Bedienungsanleitung

LevelOne

LevelOne GSW-2600TXM Bedienungsanleitung

LevelOne

LevelOne FSW-1650 Bedienungsanleitung

LevelOne

LevelOne GES-1650 Bedienungsanleitung

LevelOne

LevelOne GSW-5270 Bedienungsanleitung

LevelOne

LevelOne FEP-1601 Bedienungsanleitung

LevelOne

LevelOne FEP-0311 Bedienungsanleitung

LevelOne

LevelOne KVM-0290 Bedienungsanleitung

LevelOne

LevelOne GEP-0823 Bedienungsanleitung

LevelOne

LevelOne FSW-1610TX Bedienungsanleitung

LevelOne

LevelOne GEP-0523 Bedienungsanleitung

LevelOne

LevelOne GSW-1641 Bedienungsanleitung

LevelOne

LevelOne Infinity IES-1081 Bedienungsanleitung

LevelOne

LevelOne KVM-0260 Bedienungsanleitung

LevelOne

LevelOne Infinity IES-1080 Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung