LG 24BP750C Bedienungsanleitung

* LG LED Monitor applies LCD screen with LED backlights.

Please read this manual carefully before operating your set and

retain it for future reference.

24BP750C

24MP750C

OWNER’S MANUAL

LED LCD MONITOR

(LED Monitor*)

www.lg.com

ENGLISH

LICENSE

Each model has different licenses.Visit www.lg.com for more information on the license.

The terms HDMI and HDMI High-Definition Multimedia Interface,

and the HDMI Logo are trademarks or registered trademarks of

HDMI Licensing Administrator, Inc.

The SuperSpeed USB Trident logo is a registered trademark of USB

Implementers Forum, Inc.

VESA, VESA logo, DisplayPort compliance logo and DisplayPort

compliance logo for dual-mode source devices are all registered

trademarks of the Video Electronics Standards Association.

MaxxAudio and additional MAXX trademarks are trademarks and/

or registered trademarks of Waves Audio Ltd.

TABLE OF CONTENTS

LICENSE ...................................................... 2

OPEN SOURCE SOFTWARE NOTICE

INFORMATION ............................................ 3

ASSEMBLING AND PREPARING .................. 3

USING THE MONITOR................................ 12

USER SETTINGS ........................................ 15

TROUBLESHOOTING ................................. 25

PRODUCT SPECIFICATION......................... 27

ENGLISH

ASSEMBLING AND PREPARING

CAUTION

•Always use genuine LG components to ensure safety and product performance.

•The product warranty will not cover damage or injury caused by the use of unauthorized components.

•It is recommended that use the supplied components.

•If you use generic cables not certified by LG, the screen may not display or there may be image noises.

•Illustrations in this document represent typical procedures, so they may look different from the actual product.

•Do not apply foreign substances (oils, lubricants, etc.) to the screw parts when assembling the product. (Doing

so may damage the product.)

•Applying excessive force when tightening screws may cause damage to the monitor. Damage caused in this

way will not be covered by the product warranty.

•Do not carry the monitor upside down by just holding the base.This may cause the monitor to fall off the stand

and could result in personal injury.

•When lifting or moving the monitor, do not touch the monitor screen. The force applied to the monitor screen

may cause damage to it.

NOTE

•The components may look different from those illustrated here.

•Without prior notice, all product information and specifications contained in this manual are subject to change

to improve the performance of the product.

•To purchase optional accessories, visit an electronics store or an online shopping site, or contact the retailer

from which you purchased the product.

•The power cord provided may differ depending upon the region.

Supported Drivers and Software

You can download and install the latest version from the LGE website (www.lg.com).

Drivers and Software Installation Priority

Monitor Driver Recommended

OnScreen Control Recommended

ENGLISH

Product and Button Description

3 4

Front Adjust Button Functions Information

1Webcam activity status indicator 3Power Button

2Webcam 4Power Indicator

Power Indicator

Mode LED Color

Monitor On White

Monitor Sleep Blinking

Monitor Off Off

Webcam activity status indicator

Mode LED Color

Webcam enabled Green

Webcam disabled Off

ENGLISH

Button Description

(Menu) If the menu is inactive Activates the main menu.

If the menu is active Exits the OSD menu when the button is pressed.

If the menu is inactive Adjusts the volume level of the monitor.

If the menu is active Left directional key.

If the menu is inactive Adjusts the volume level of the monitor.

If the menu is active Right directional key.

If the menu is inactive Change the input signals.

If the menu is active Selects and confirms menus or options.

Down directional key.

Up directional key.

(Power button) Turn the monitor power on/off.

Moving and Lifting the Monitor

When moving or lifting the monitor, follow these instructions to prevent the monitor from being scratched or

damaged and to ensure safe transportation, regardless of its shape or size.

•Place the monitor in the original box or packing material before attempting to move it.

•Before moving or lifting the monitor, disconnect the power cord and all other cables.

•Hold the bottom and side of the monitor frame firmly. Do not hold the panel itself.

•When holding the monitor, the screen should face away from you to prevent it from being scratched.

•When transporting the monitor, do not expose the monitor to shock or excessive vibration.

•When moving the monitor, keep it upright and never turn the monitor on its side or tilt it sideways.

CAUTION

•Avoid touching the monitor screen as much as possible.

-This may result in damage to the screen or some of the pixels used to create images.

•If you use the monitor panel without the stand base, its button may cause the monitor to become unstable and

fall, resulting in damage to the monitor or human injury. In addition, this may cause the button to malfunction.

ENGLISH

Installing on a Table

•Lift the monitor and place it on the table in an upright position. Place the monitor at least 100mm (3.94

inches) away from the wall to ensure sufficient ventilation.

100 mm

(3.94 inches)

100 mm

(3.94 inches) 100 mm

(3.94 inches)

100 mm

(3.94 inches)

CAUTION

•Unplug the power cord before moving or installing the monitor. There is risk of electric shock.

•Make sure to use the power cord that is provided in the product package and connect it to a grounded power

outlet.

•If you need another power cord, please contact your local dealer or the nearest retail store.

Adjusting the Stand Height

1 Handle the monitor with both hands for safety.

2 The height can be adjusted up to 130.0 mm (5.19 inches).

WARNING

•Do not put your fingers or hand between the screen and the base (chassis) when adjusting the screen's height.

130.0 mm

(5.19 inches)

ENGLISH

Pivot Feature

The pivot feature allows the monitor to rotate 90° clockwise and -90° counter clockwise.

1 Raise the monitor to the maximum height.

2 Adjust the angle of the monitor in the direction of the arrow as shown in the figure.

Adjusting the Angle

1 Place the monitor mounted on the stand base in an upright position.

2 Adjust the angle of the screen.

The angle of the screen can be adjusted forward or backward from -5° to 35° for a comfortable viewing

experience.

35 °-5°

WARNING

•To avoid injury to the fingers when adjusting the screen, do not hold the lower part of the monitor’s frame as

illustrated below.

•Be careful not to touch or press the screen area when adjusting the angle of the monitor.

Rear Side Front Side

ENGLISH

3 Rotate the monitor 90° clockwise and -90° counter clockwise as shown in the figure.

4 Complete the installation by rotating the monitor 90° clockwise and -90° counter clockwise as shown below.

NOTE

•Auto Pivot feature of the display is not supported.

•The screen can be rotated easily using the screenpivot shortcut key provided with your Windows operating

system. Note that someWindows versions and some graphics card drivers may use different settings for the

screen pivot key or may not support the pivot key at all.

•Windows screen pivot shortcut keys

-0°: Ctrl + Alt + Up arrow key (↑)

-90°: Ctrl + Alt + Left arrow key (←)

-180°: Ctrl + Alt + Down arrow key (↓)

-270°: Ctrl + Alt + Right arrow key (→)

WARNING

•To avoid scratching the stand base, make sure that when rotating the monitor using the pivot feature, the

stand does not make contact with the monitor.

Head

Stand

ENGLISH

WARNING

•Take care when rotating the monitor if the cable is connected.

•To avoid injury when rotating the display, do not place your fingers between the display and the stand base.

Using the Kensington Lock

The connector for the Kensington security system is located at the back of the monitor.

For more information on installation and usage, refer to the Kensington lock owner’s manual or visit the website

at http://www.kensington.com.

Connect the monitor to a table using the Kensington security system cable.

NOTE

•The Kensington security system is optional. You can obtain optional accessories from most electronics stores.

ENGLISH

Installing the Wall Mount Plate

This monitor meets the specifications for the wall mount plate or other compatible devices.

NOTE

•The wall mount plate is sold separately.

•For more information on installation, refer to the wall mount plate’s installation guide.

•Be careful not to apply too much force while mounting the wall mount plate as it may cause damage to the

screen.

•Remove the stand before installing the monitor on a wall mount by performing the stand attachment in

reverse.

Installing on the Wall

Install the monitor at least 100mm (3.94 inches) away from the wall and leave about 100mm (3.94 inches)

of space at each side of the monitor to ensure sufficient ventilation. Detailed installation instructions can be

obtained from your local retail store. Alternatively, please refer to the manual for how to install and set up a

tilting wall mounting bracket.

100 mm

(3.94 inches)

100 mm

(3.94 inches)

100 mm

(3.94 inches) 100 mm

(3.94 inches)

To install the monitor to a wall, attach a wall mounting bracket (optional) to the back of the monitor.

Make sure that the wall mounting bracket is securely fixed to the monitor and to the wall.

Wall Mount (mm) 100 x 100

Standard screw M4 x L10

Number of screws 4

Wall Mount Plate (Optional) LSW 149

NOTE

•A non-VESA standard screw may damage the product and cause the monitor to fall. LG Electronics is not liable

for any accidents relating to the use of non-standard screws.

•The wall mount kit includes the installation guide and all necessary parts.

•The wall mounting bracket is optional.You can obtain optional accessories from your local dealer.

•The length of the screw may differ for each wall mounting bracket. If you use screws longer than the standard

length, it may damage the inside of the product.

•For more information, please refer to the user manual for the wall mounting bracket.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere LG Monitor Handbücher

LG 55EW5PG Bedienungsanleitung

LG 50PM1M - - 50" Plasma Panel Bedienungsanleitung

LG L226WA-WN Bedienungsanleitung

LG 27BN85U-B Bedienungsanleitung

LG 27BK55YP-B Bedienungsanleitung

LG FLATRON 568LM LM568E-CA Bedienungsanleitung

LG 27BL85U-W.AUB Bedienungsanleitung

LG L17MM Bedienungsanleitung

LG 27BK550Y-B.AAU Bedienungsanleitung

LG 27BN85UN Bedienungsanleitung

LG 42WS10 Bedienungsanleitung

LG UltraGear 24GN60R-B.BEU Bedienungsanleitung

LG FLATRON L1750S Bedienungsanleitung

LG 34WK95C-W.AUS Bedienungsanleitung

LG Flatron L3020T Bedienungsanleitung

LG M2262D-PM Bedienungsanleitung

LG 27BQ75QC Bedienungsanleitung

LG 22EA53R Bedienungsanleitung

LG 22MR410 Bedienungsanleitung

LG 42PM11 - MU - 42" Plasma Panel Bedienungsanleitung

LG 35WN75CB Bedienungsanleitung

LG 42PM1MA Bedienungsanleitung

LG 24MN430H Bedienungsanleitung

LG 25BL55WY Kurzanleitung

Beliebte Monitor Handbücher anderer Marken

Linear Acoustic

Linear Acoustic LQ-1000 Bedienungsanleitung

AOC

AOC I2579V Bedienungsanleitung

Gateway

Gateway FPD1520 Bedienungsanleitung

Furuno

Furuno Mu 120c Bedienungsanleitung

Asus

Asus VB171D - 17" LCD Monitor Bedienungsanleitung

Dell

Dell S2230MX Gebrauchsanweisung

Philips

Philips 107C64 Bedienungsanleitung

Dell

Dell S2409WFP Bedienungsanleitung

EverFocus

EverFocus EN-7517E Bedienungsanleitung

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Bedienungsanleitung

Dell

Dell Precision 7680 Bedienungsanleitung

Bosch

Bosch DDU 9 Bedienungsanleitung

Acer

Acer A231HL Bedienungsanleitung

Philips

Philips 86BDL4152T Bedienungsanleitung

NEC

NEC AccuSync LCD5V Bedienungsanleitung

Emay

Emay SleepO2 Bedienungsanleitung

IBM

IBM 6360 Montageanleitung

Sceptre

Sceptre D40 Bedienungsanleitung