LG LSC27931 Series Bedienungsanleitung

REFRIGERATOR

LSC27931**

Owner´s Manual

Manuel d’utilisation

Care and Maintenance

Dispenser will

not dispense

ice.

Ice dispenser

is jammed.

Occurrence

Water has an

odd taste

and/or odor.

Dispenser will

not dispense

water.

Possible cause

Water has been in the tank for too long.

Unit not properly connected to cold

water line.

This sound is normally made when automatically made ice is dropped into ice storage

bin. Volume may vary according to refrigerator’s location.

This sound is normally made when ice maker is supplied with water after dropping

the automatically made ice.

Please thoroughly read Automatic icemaker and dispenser in this manual.

Ice cubes are frozen together.

Ice has melted and frozen around auger

due to infrequent use, temperature

uctuations and/or power outages.

Ice cubes are jammed between the ice

maker arm and back of the bin.

Ice cubes that have been purchased or

made in some other way have been

used in the dispenser.

Household water line valve is not open.

See problem Icemaker is not making

any ice .

Refrigerator or freezer door is not closed.

Solution

Be sure both doors are closed.

Draw and discard 7 glasses of water

to freshen the supply. Draw and discard

an additional 7 glasses to completely rinse

out tank.

Connect unit to cold water line which

supplies water to kitchen faucet.

Open household water line valve.

Use the dispenser often so that cubes do

not freeze together.

Only the ice cubes made by the ice maker

should be used with the dispenser.

Remove the ice cubes that are jamming

the dispenser.

Remove ice storage bin, and thaw and

the contents. Clean bin, wipe dry and

replace in proper position.

When new ice is made, dispenser should

operate.

Sound of ice

dropping.

Sound of water

supply.

Other.

Entry

Important Safety Instruction

Identification of Parts

Where to Install

Move Refrigerator

Door Replacement

Water Pipe Installation

Water Connection Instruction Guide

Operation Instruction Guide

Height Adjustment

Starting

Adjusting the Temperatures and functions

(Dispenser/Automatic Icemaker)

Shelf

Location of Foods

Storing Foods

How to Dismantle Parts

General Information

Cleaning

Troubleshooting

Table of Contents

Introduction

Installation

Operation

Suggestion on

Food Storage

Care and

Maintenance

Introduction

the

NOTE:

If you are getting rid of your old refrigerator, please follow

the instructions at right to help prevent accidents.

Read all instructions before using this appliance.

Use this appliance only for its intended purpose as described in this use and care guide.

Introduction

IdentiﬁcationofParts

•

If you nd some parts missing from your unit,

they may be parts only used in other models.

Where to install

Unstable installation may cause vibration and

noise. If the oor to install the refrigerator on

is not even, make the refrigerator level by

rotating the height adjusting screw. Carpet

or oor covering on which a refrigerator is

installed may be discolored by heat from the

bottom of the refrigerator.

If our refrigerator causes this kind of

damage, there is something wrong with it.

Customers will not stand for this.

Strong

and even ﬂoor

A proper

distance from

adjacent items

Please keep the refrigerator at a proper

distance from other things. Too small a

distance from adjacent items may result in

lowered freezing capability and increased

electricity consumption charges.

1”(2.54 cm )

Installation

Where water

supply can be

easily connected

in a dry place

Where it is free

from heat

Select a place where a water supply can be

easily connected between the automatic ice

maker and dispenser.

Installing the refrigerator in a wet or damp

area may cause rust and may be an electrical

hazard.

If this refrigerator is installed where the

ambient temperature is high, the freezing

capacity is deteriorated and the cost of

electricity used increases.

•

Install the refrigerator at a place where the ambient temperature is 5˚C ~ 43˚C

(41˚F~110˚F).

Ambient temperature outside this range may cause product malfunction. Also, the

tube between the dispenser and automatic ice maker may freeze.

NOTE

Bottom Pad

Tools Required

Remove the

Freezer

Compartment

Door

Remove the

Refrigerator

Door

Installation

1) Remove the hinge cover by loosening the

screws. Disconnect all connections except

the ground line.

2) Remove the keeper by rotating it counter

clockwise and then lifting the upper

hinge up

3) Remove the freezer compartment door by

lifting it upward. This time, the door should

be lifted enough for the water feed tube to

be completely pulled out.

1) Loosen the hinge cover screws and remove

the cover. Remove connection wire.

2) Remove keeper by rotating it clockwise

and then remove the upper hinge by lifting

it up .

3) Remove the refrigerator compartment door

by lifting it up.

•

If a tube end is deformed or abraded, trim the part away.

Disconnecting the tube under the door causes about 1.5 litters water to out. Please

put a large container at end of tube to prevent water from draining on to the .

NOTE

•

When removing the upper hinge, be careful that the door does not fall forward.

NOTE

•

After removing the door, take it into the kitchen where you are installing the

refrigerator. Lay it down on a blanket and be careful to avoid damaging the water

feed tube.

NOTE

Lower hinge

Lower Hinge

Keeper

Connection

Wires

Connection

Wires

Hinge

Cover

Upper Hinge

Keeper Upper Hinge

Failure to do so could result in death or serious injury.

If your entrance door is too narrow for the refrigerator

to pass through, remove the

refrigerator door and pass

the refrigerator laterally.

Push the refrigerator sideways

through the entrace door as shown in the rigth picture.

Electric Shock Hazard

Disconnect electrical supply to refrigerator before installing.

Pull up the water feed tube while pressing

area shown in the gure to the right.

Water Feed Tube

Remove Water

Feed Tube

WARNING

Move the

Refrigerator

Water pipe installation

Automatic icemaker operation needs water pressure of 21.3~121psi (lb/inch2) (That

is, a 7oz. paper cup will be lled within 3 sec.).

If water pressure does not reach the rated 21.3psi (lb/inch2) or below, it is necessary

to purchase a separate pressure pump for normal automatic icemaking and cool

water feed.

Keep the total length of the water feed tube within 40 feet and be careful not to

bend or kink the tube. If the tube is longer than 40 feet, the icemaker and water

dispenser will not operate properly.

Install the water feed tube at a place free from heat.

Connect to potable water supply only.

Refer to instructions with water lter kit for installation.

Before

Installation

WARNING

Installation

Water Connection Instruction Guide

Read all directions carefully before you begin.

Connecting

the Refrigerator

to a Water Source

•

If operating the refrigerator before installing the water connection, turn icemaker

to theOFF position to prevent operation without water.

•

All installations must be in accordance with local plumbing code requirements.

•

Use copper tubing and check for leaks.

•

Install copper tubing only in areas where temperatures will remain above freezing.

•

It may take up to 24 hours for your icemaker to begin producing ice.

IMPORTANT

Standard screwdriver.

7/16-inch and 1/2-inch open-end wrenches or two adjustable wrenches.

1/4-inch nut driver.

1/4-inch drill bit.

Hand drill or electric drill (properly grounded).

Tools Required

•

Your refrigerator dealer has a kit available with a 1/4-inch saddle-type shut-o valve,

a union, and copper tubing. Before purchasing, make sure a saddle-type valve

complies with your local plumbing codes. Do not use a piercing-type or 3/16-inch

saddle valve which reduces water ow and clogs more easily.

NOTE

Screwdriver

Adjustable wrenches

Electric drill

NOTE:

Check the direction of the level hinge.

Correct Incorrect

Screw

Hole

Door replacement

Mount the doors in the reverse order of removal after the refrigerator is brought to the

installation area.

Install the base grille using a driver screw Phillip’s,

put one screw in each hole of base grille.

Base grille

installation

Andere Handbücher für LSC27931 Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere LG Kühlschrank Handbücher

LG GR-V292SC Bedienungsanleitung

LG SXS Refrigerator Bedienungsanleitung

LG GRX-274DPB Bedienungsanleitung

LG GS-B680PL Bedienungsanleitung

LG GC-X247CKBV Bedienungsanleitung

LG MFL37432224 Bedienungsanleitung

LG GWL6004PS Bedienungsanleitung

LG GCB-267VDL Bedienungsanleitung

LG GB3133WBGW Bedienungsanleitung

LG LFXS28566 Series Bedienungsanleitung

LG GR-V192SL Bedienungsanleitung

LG GR-K222BVWQ Bedienungsanleitung

LG LFX25974 Series Bedienungsanleitung

LG G 372 Series Bedienungsanleitung

LG LSC23924 Series Bedienungsanleitung

LG LBNC15231V.APZCNA0 Bedienungsanleitung

LG LFC20786 Series Bedienungsanleitung

LG LFX25971 Series Bedienungsanleitung

LG GR-M562GSH Bedienungsanleitung

LG GM-F208J NP Series Bedienungsanleitung

LG BOTTOM FREEZER REFRIGERATOR Bedienungsanleitung

LG G -M602H M Series Bedienungsanleitung

LG GL Series Bedienungsanleitung

LG GM-B24*QTB Bedienungsanleitung

Beliebte Kühlschrank Handbücher anderer Marken

Bonnet Neve

Bonnet Neve SKYVIEW PLUS Bedienungsanleitung

Zanussi Electrolux

Zanussi Electrolux ZERB 8441 Bedienungsanleitung

Sharp

Sharp SJ-BA31IEXW2-EU Bedienungsanleitung

CORBERO

CORBERO CC2300MCW Bedienungsanleitung

KitchenAid

KitchenAid 2205264 Bedienungsanleitung

NEFF

NEFF KI181 Series Bedienungsanleitung

Hoshizaki

Hoshizaki Reach-In Bedienungsanleitung

Amana

Amana ASD2524VES00 Bedienungsanleitung

BOMANN

BOMANN KGC 213 Bedienungsanleitung

Danby

Danby DAR044A1SLDD Montageanleitung

Beko

Beko CSA31022 Bedienungsanleitung

IKEA

IKEA FROSTIG C 185 E Bedienungsanleitung

Electrolux

Electrolux ER 6821 D Bedienungsanleitung

True

True TS-28 Bedienungsanleitung

Frigidaire

Frigidaire FSC23R5DW9 Bedienungsanleitung

Beko

Beko LSP4579W Bedienungsanleitung

Teledyne

Teledyne 6712FR and Betriebsanleitung

Matsui

Matsui MTT50W12E Bedienungsanleitung