LG OCF100 Bedienungsanleitung

OWNER’S MANUAL

CANVAS SPEAKER

Please read this manual carefully before operating your set and

retain it for future reference.

www.lg.com

OCF100

P/NO : MFL68001303 (1311-REV00)

Printed in Korea

ENG

ENGLISH

TABLE OF CONTENTS

WARNING

• If you ignore the warning message, you may be seriously injured or there is a possibility of accident or

death.

CAUTION

• If you ignore the caution message, you may be slightly injured or the product may be damaged.

3 SAFETY INSTRUCTIONS

5 BEFORE INSTALLATION

6 UNPACKING

7 INSTALLATION

7 Attaching the Guide Spacer on the TV

8 Attaching Set Protection Cushion

8 Checking the Spots for Fixing Screws on the Wall Using VESA Guide Sheet

9 Fixing Anchors and Screws

9 Installing the Wall Mounting Supporter

10 Assembling the Wall Mounting Supporter and the Canvas Speaker

11 Adjusting the Level of the Product

12 Organizing the Power Cord

13 Fixing the Safety Clip (Bottom)

13 Connecting the Optical Cable

14 Combined Appearance of the Canvas Speaker and TV

14 PRODUCT SPECIFICATIONS

TABLE OF CONTENTS

ENG

ENGLISH

SAFETY INSTRUCTIONS

- Make sure the professional installer read this manual before installation.

- After the installation, the professional installer should pass this user manual to the customer and ask the

customer to read the manual carefully and keep it in a safe place.

After reading the user manual, keep the manual in a readily accessible location so the users can refer to it in the

future as required.

WARNING

The product should be installed by a professional

installer designated by the retailer.

Having the product installed by a non-specialized

installer is very dangerous and can cause a personal

injury.

Do not install the product where the weight

cannot be supported.

If the location where the product is installed is not

stable and sturdy enough, it may fall causing personal

injuries.

Contact a professional installer designated by the

retailer to move or replace the product, if needed.

Installation requires special techniques and moving

or installing the product on your own can cause

serious safety issues.

When installing the wall mount-type product,

never hang the power cable or signal cable on the

rear side of the TV.

The cord can be damaged, resulting in a fire, an

electric shock or damage to the product.

After installing the product, do not hang on it or

apply severe impact to the product.

The product may fall causing personal injuries.

ENG

ENGLISH

SAFETY INSTRUCTIONS

CAUTION

Install the product according to the directions in

this user manual.

Failure to follow the directions in the user manual may

cause a serious personal injury or damage to the

product due to the improper installation.

When drilling holes in the wall, always use a drill

bit and drill in designated diameter.

If you make a hole to install the product without

following the instructions, the product may not be

installed stably, resulting in a safety issue.

Do not wipe the product with a wet towel and

make sure you do not use any heater or

humidifier under the location where the product

is installed.

If water flows into the product or moisture and heat

are applied to the product, it may cause a fire, an

electric shock or product malfunction.

Unplug the power cord from the power outlet

before installing the product.

If you install the product with the power cord plugged,

it may cause an electric shock or a fire.

Do not install the product in any place other than

the vertical wall, for example, near a sprinkler or

sensor, in a place where may be affected by

vibration or shock, or near any high voltage

power cable or power source.

Do not install the product with bare hands.

Always wear proper work gloves.

Otherwise, this may result in personal injuries.

At least two people must work together when

installing the product or adjusting the height of

the product after the installation.

Working alone may cause the product to fall, resulting

in personal injury or damage to the product.

Check the type of wall material before the

installation and use the provided anchors and

screws if the conditions comply.

If you do not use the designated anchors or screws,

they may not be able to withstand the weight of the

product and cause a safety issue.

When you do use other cables than the provided

one to connect the product, the wall or the

connector of the product may be damaged due to

the friction with the wall. Make sure to use the

cable gender provided with the product.

ENG

ENGLISH

BEFORE INSTALLATION

• Use this product only for installing the TV on the wall.

• Be cautious when installing/using the wall mounting product in order to prevent the damage to the product and

avoid safety accidents.

• If you have not fully read and understood the installation manual, do not install the product and contact an

authorised service centre.

If you have not fully understood after the inquiry, have a specialized installer install the product for you.

• Even if you are not a specialized installer but have experience in mechanical or construction field, it is

advantageous for you to fully understand this manual and install the product.

• This product is designed to be mounted to walls with standard space between the studs. LG Electronics is not

responsible for any issues occurred by installing the product on the walls where the standard space is not

applicable.

• Install the wall mounting screws to the wall so that they can be installed at the centre of the both ends of the

studs. It is recommended to use the stud finder, a separate device.

• When installing the bracket on a concrete wall or on any other walls capable of holding the strength specified in

the manual, you may remove the brackets for fixing to the wall of studs with standard space and follow the

instructions for attaching the bracket to make the installation easier.

• Install the product only on a vertical wall.

Do not install the bracket on a wall inclined at an angle, exceeding the standard range, or on the ceiling.

LG Electronics is not liable for any issues occurred due to the installation of the product on a slanted wall or

on the ceiling.

• Check the accessories provided with the product before installing. LG Electronics is not liable for any damage to

or loss of the accessories after the package has been opened.

• Keep the provided accessories out of reach of babies or children as it may cause safety issues, including

suffocation, from swallowing the parts.

• Make sure that screws are installed securely on the wall.

Applying excessive force to screws may damage the wall, impair the performance or reduce the strength of the

product, or cause it to become damaged.

• Be careful not to install a TV that exceeds the weight restrictions and not to apply external force.

• Be careful when using the tools during installation to prevent accidents or damage.

Philipsscrewdriver(manualorelectric)/8mmspanner/drill/Ф8mmdrillbitforconcretewallФ4mmdrillbitfor

wood or steel / level / stud finder / slotted screwdriver

ENG

ENGLISH

UNPACKING

VESA Guide Sheet Installation Guide Tape

4 EA

User Manual Optical Cable

Guide Spacer (Bottom)

2 EA

Guide Spacer (Top)

2 EA

Guide Spacer (Top)

Fixing Screw

2 EA, M6 X 26

Guide Spacer (Bottom)

Fixing screw

2 EA, M4 X 20

Safety Clip (Top)

2 EA

Safety Clip (Bottom)

2 EA

Safety Clip (Top/

Bottom) Fixing screw

4 EA, M4 x 12

Set Protection

Cushion (Upper)

2 EA

(thickness: 11 mm)

Set Protection

Cushion (Bottom)

2 EA

(thickness: 1.5 mm)

Wall Mounting Anchor

8 EA

Wall Mounting Screw

8 EA

Rubber

2 EA

(thickness: 12 mm)

ENG

ENGLISH

INSTALLATION

1Attaching the Guide Spacer on the TV

• If the screws cannot be fully tightened when fixing the guide spacer with them, check the fixing depth of

the screws again and refer to the technical service manual.

Guide Spacer (Bottom)

Guide Spacer (Top)

Guide Spacer (Bottom) Fixing screw

Guide Spacer (Top) Fixing Screw

1 If any screws are installed into the mounting holes, please remove the screws.

2 Fix the guide spacers and the guide spacer fixing screws in the order shown in the figure.

- Place the product facing down on a table. To prevent scratches on the screen, place the product on a

cushion or a soft clothes on a flat surface.

- Tighten the screw until the set, guide spacers and screws are joined together securely and stop tightening.

- Use a Phillips driver (manual or electric) to tighten the screws.

CAUTION

How to use the Rubber

• It is recommanded to install the bracket on a concreate wall.

• The product should be installed by a professional

installer designated by the retailer.

Attach the rubber here.

ENG

ENGLISH

INSTALLATION

2Attaching Set Protection Cushion

• Attach the set protection cushion to mitigate the impact between the TV and the Canvas Speaker in case

of bumping against each other when adjusting the angle.

• Attach the protection cushion to the four corners of the back of the set as shown in the figure.

Set Protection Cushion (Upper)

2 EA (thickness: 11 mm)

Set Protection Cushion (Bottom)

2 EA (thickness: 1.5 mm)

3Checking the Spots for Fixing Screws on the Wall Using

VESA Guide Sheet

1430 mm

840 mm

(VESA guide sheet size)

865 mm

(Actual product size)

1 Check the VESA standard for the TV.

2 Mark the wall mounting location on the wall using the VESA guide sheet provided as an accessory.

3 Remove the VESA guide sheet after checking the spots for fixing screws on the wall.

* Please note that the VESA guide sheet is shorter than actual product by 12.4 mm on the top and bottom sides

respectively, when installing the product.

ENG

ENGLISH

INSTALLATION

4Fixing Anchors and Screws

• Check the material of the wall and thickness of finishing material.

• You can use the anchors and screws provided with the TV set for the wall made with concrete,

lightweight concrete, soft fieldstone, hard fieldstone, brick or cellular block.

• Do not mount on the wall made with plaster board or medium density fibreboard (MDF). Otherwise, you must

fix the anchor screws to the retaining wall (concrete) inside the finishing material. If there is no retaining wall,

you must install a separate hanger first to fix the anchors and screws.

• When installing the product on the wall that is not specified in this manual, make sure that each fixing point

withstands an pullout load of 70 kgf (686 N) and a shearing load of 100 kgf (980 N) or more.

1 Use a Ø 8 mm drill bit to make a hole with a depth of 80-100 mm on the anchor position.

2 Clean the drilled holes.

3 Insert the provided anchor in the hole. (Use a hammer when inserting the anchor.)

4 Place the angle adjusting part to face upward. Place the angle adjusting part to face upward.

5 Align the wall mounting screws with the holes to tighten the screws. Tighten the screw using a recommended

torque of 45 kgf/cm - 60 kgf/cm or more.

• Use the Ø 8 mm drill bit for concrete wall and hammer (Impact) drill.

Wall mounting screw

Anchor

5Installing the Wall Mounting Supporter

• Tighten the four wall mounting screws.

• If the screws cannot be fixed in the designated

location, move the bracket to the left or right to fix

the screws.

• Fix the wall mounting supporter using the wall

mounting screws as shown in the figure.

• Tighten the screws until the wall, the wall mounting

bracket and the screws are joined together securely

using a (manual or electric) Phillips screwdriver or

8mm spanner. Wall mounting screw

1 2 3

ENG

ENGLISH

INSTALLATION

6Assembling the Wall Mounting Supporter and the

Canvas Speaker

1 Place the Canvas Speaker on the wall mounting attached to the wall in the direction of the arrow.

- Attach the guide tape for wall mounting above the left and right holes of the wall mounting and the left

and right VESA of the Canvas Speaker.

- Attach the guide tape for wall mounting side by side as shown in the figure and then install the product.

When the installation is complete, remove the guide tape for wall mounting.

- Check if the product is securely fixed by pulling on the top of the Canvas Speaker.

- If the product is not levelled after the installation, adjust the level by moving the Canvas Speaker left and right.

Installation Guide Tape

2 Install the wall mounting bracket using wall mounting screws.

Wall Mounting Screw

Andere Handbücher für OCF100

Inhaltsverzeichnis

Beliebte Sprecher Handbücher anderer Marken

argon audio

argon audio IE20 Bedienungsanleitung

Denon

Denon SC-N7 Bedienungsanleitung

Gemline

Gemline Ace 3952 Bedienungsanleitung

Focal

Focal ON WALL 300 Bedienungsanleitung

HEADRUSH

HEADRUSH Maximus HRSP 5024 Bedienungsanleitung

SoundLogic

SoundLogic BCCS-6/6395 Bedienungsanleitung

Peavey

Peavey DTH 218 Bedienungsanleitung

Avantree

Avantree Pluto Air Bedienungsanleitung

Morel

Morel Integra Series INTEGRA OVATION 4 Bedienungsanleitung

Oppo

Oppo SONICA Bedienungsanleitung

Bose

Bose SoundLink Wireless Music System Bedienungsanleitung

Rocksteady

Rocksteady Stadium Bedienungsanleitung

Bowers & Wilkins

Bowers & Wilkins 4 Bedienungsanleitung

Sonance

Sonance SONOS OUTDOOR Series Bedienungsanleitung

Electro-Voice

Electro-Voice EVID FM4.2 Bedienungsanleitung

Pioneer

Pioneer XW-HTD630 Bedienungsanleitung

Onn

Onn BWA16AA002 Bedienungsanleitung

HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung