LifeShield OC810 Bedienungsanleitung
The OC810 is an outdoor camera with built-in Infrared LEDs for night vision. To use:
Camera Model OC810
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
* Wireless, or WiFi, technology allows an electronic device to exchange data wirelessly (using radio waves) over a computer network.
Plug camera into power and Ethernet, wait
for power and network LED
1
Once all cameras are found,
press OK
3
Use LifeView to edit settings,
including name and WiFi*
4
2
For support call: 877-464-7437 or visit: www.lifeshield.com/support
On Console select
Menu Cameras Add New
Must be on same router as your
LifeShield Base to setup. After setup,
plug into power where you like
Setup WiFi using Camera Settings in
LifeView, disconnect Ethernet cable,
then remove and reconnect power
Setup Alerts in LifeView to take
pictures when sensors trigger
Live video limit per session is
5 minutes
Notes
Use rubber cover
for Ethernet plug
WiFi antenna must be
installed to use WiFi
Use rubber cover for
power plug
To reset, insert
paperclip into reset
button (next to
power connector) for
at least 5 seconds,
and release
Andere LifeShield Außenkamera Handbücher
