Lightolier PENDALYTE SERIES Gebrauchsanweisung

631

rpor

ver,

02720

COMPANY

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING LUMINAIRE

This luminaire is intended for installation in accordance with the National Electrical Code and local regulations.

To assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference. IS:404S36

INSTRUCTION SHEET NO.

B0204 Page 1

Note: This instruction sheet covers several luminaire styles.

Powerhead assembly, lamp type, and reflector style may vary

slightly from that shown, although installation is the same.

INSTRUCTION SHEET FOR ASSEMBLY AND INSTALLATION

OF 9”,12”&16” PENDALYTE™ SERIES WITH

STEM

1. Using pipe cutting tool, shorten STEM to

appropriate length. Clean all burrs and sharp

edges from cut end of Stem.

2. Position DRILL LOCATOR over cut end of

STEM (Fig. 2). Gently tap down on DRILL

LOCATOR until fully seated on end of STEM.

3. Position CENTER PUNCH into bottom SLOT

in DRILL LOCATOR and mark a small dimple

in STEM (Fig. 3).

4. Align 1/8" DRILL BIT (local hardware item)

into bottom slot of DRILL LOCATOR so tip of

DRILL BIT rests in dimple (Fig. 4).

5. Drill hole completely through STEM allowing

DRILL LOCATOR to guide DRILL BIT. Do

not force DRILL BIT. It is recommended to

hold DRILL LOCATOR securely in a vise or

other device prior to drilling hole.

Instructions for shortening stem

ATTENTION: Cut end with smaller diameter holes only. (Fig.1)

CAUTION: Eye protection should always be worn when using hand and

power tools during the assembly procedure outlined below.

1. Assemble STEM to BALL ALIGNER using SET SCREWS. SET SCREWS

should align with small holes near end of stem. Pull wires through BALL

ALIGNER leaving no less than 6” exposed. (Fig 1)

2. Strip back insulation on Black, White and Green wires 3/8” at both ends.

3. Attach MOUNT PLATE to STEM by aligning holes as shown and inserting

PIN. Secure PIN with COTTER PIN.

4. Wire POWERHEAD ASSEMBLY using WIRE NUTS (local hardware item):

black luminaire lead to hot (black) lead, white luminaire lead to neutral (white)

lead. Attach luminaire ground wire(s) (green and/or bare) to green ground

wire.

5. Attach POWERHEAD to MOUNT PLATE with 8-32 SCREWS

6. Install SWIVEL CROSSBAR onto outlet box using OUTLET BOX SCREWS.

7. Insert STEM with BALL ALIGNER through CANOPY prior to wiring.

8. Place BALL ALIGNER with STEM into CROSS BAR through side access hole.

When seated the BALL ALIGNER KEYWAY will line up with tab on

CROSSBAR. Push supply leads into outlet box.

9. Slide SAFETY STRAP into position and secure with screw.

10. Make electrical connections: black lead to hot (black) supply lead; white lead

to neutral (white) supply lead. Green lead is ground wire and must be

connected to grounding terminal or ground lead inside outlet box. Use WIRE

NUTS (local hardware item). Note: Refer to POWERHEAD instruction

sheet for detailed wiring information.

11. Place CANOPY over CROSSBAR lining up slots on CANOPY with RUBBER

CAPS on CROSSBAR turning clockwise until it locks into place.

NOTE: If custom length is required see below

STEM

8-32 SCREW

COTTER PIN

MOUNT PLATE

POWERHEAD

ASSEMBLY

BALL ALIGNER

SET SCREW

SAFETY

STRAP

W/SCREW

OUTLET

BOX

SCREW

CANOPY

SWIVEL

CROSSBAR

RUBBER

CAPS

KEYWAY

Fig 1

Inhaltsverzeichnis

Andere Lightolier Leuchte Handbücher

Lightolier

Lightolier SS 2 LAMP Bedienungsanleitung

Lightolier

Lightolier Lytecaster 1113IE Bedienungsanleitung

Lightolier

Lightolier Calculite S6132BUES Bedienungsanleitung

Lightolier

Lightolier H9S1GLR128 Bedienungsanleitung

Lightolier

Lightolier Pristine Series Bedienungsanleitung

Lightolier

Lightolier 40S20 Leitfaden

Lightolier

Lightolier Lytecaster 1004F26ES Bedienungsanleitung

Lightolier

Lightolier Calculite C6T6A-MHT6RS Bedienungsanleitung

Lightolier

Lightolier Calculite 8021WW Bedienungsanleitung

Lightolier

Lightolier G7075 Bedienungsanleitung

Lightolier

Lightolier Lytecaster 322X Bedienungsanleitung

Lightolier

Lightolier Calculite ProSpec PA3M1675 Bedienungsanleitung

Lightolier

Lightolier Calculite 7782 Bedienungsanleitung

Lightolier

Lightolier RADIANCE PENDANT FIXTURES Leitfaden

Lightolier

Lightolier Tangent FXT4P Bedienungsanleitung

Lightolier

Lightolier Calculite ProSpec PA4A1175 Bedienungsanleitung

Lightolier

Lightolier GYMLYTE GM4B4SVI232 Bedienungsanleitung

Lightolier

Lightolier 1084CD Bedienungsanleitung

Lightolier

Lightolier Helios 5410 Leitfaden

Lightolier

Lightolier ProSpec 26690 Bedienungsanleitung

Lightolier

Lightolier Lytecel LL4MF8LR254 Bedienungsanleitung

Lightolier

Lightolier 6706S2UEM Bedienungsanleitung

Lightolier

Lightolier Evolution Glasslite C4MRGA Bedienungsanleitung

Lightolier

Lightolier VP PARABOLIC VPA2G29PR232 Bedienungsanleitung

Beliebte Leuchte Handbücher anderer Marken

Emos

Emos CLASSIC ZY1431T Bedienungsanleitung

Westinghouse

Westinghouse Outdoor Lighting Fixture Bedienungsanleitung

Hedler

Hedler C 12 silent Bedienungsanleitung

Blizzard Lighting

Blizzard Lighting Puck: CSI Bedienungsanleitung

Energetic Lighting

Energetic Lighting ELYSL-5004 Series Bedienungsanleitung

Lightmaxx

Lightmaxx Shaft 5R Bedienungsanleitung

Triarch

Triarch 31083 Bedienungsanleitung

Philips

Philips 32614 Series Bedienungsanleitung

IKEA

IKEA TIVED Bedienungsanleitung

Chauvet Professional

Chauvet Professional ROGUE R1 BEAM WASH Bedienungsanleitung

Martin

Martin MAC 250 Krypton Bedienungsanleitung

Cooper Lighting

Cooper Lighting Halo L3232E Bedienungsanleitung

Stageline

Stageline ODW-2410RGBW Bedienungsanleitung

Light Sky

Light Sky Tornado Series Bedienungsanleitung

ArtFox

ArtFox Beam 15R extreme Bedienungsanleitung

GLG

GLG multispot 330 Bedienungsanleitung

Home Accents Holiday

Home Accents Holiday TY052-1924-1 Bedienungsanleitung

SELF Electronics

SELF Electronics FLEX Bedienungsanleitung