Subject to modifications
User Manual
LMC 1
9.3EN-98001-A07
LINCOLNGmbH•Postfach1263•D-69183Walldorf•Tel+49(6227)33-0•Fax+49(6227)33-259
Page 5 of 36
Safety instructions
Intended use
- Use the LMC 1 multi controller solely for controlling or
monitoring Lincoln centralized lubrication-systems in
stationary industrial plants.
Improper use
Any kind of use of the LMC 1 not explicitly denoted in this
user information as intended use is considered improper use.
If the LMC 1 is used or operated in deviation from the
intended use, all claims for compensation and all liability
cease to exist.
6001a02
NOTE
Misappropriate use, e.g. through
disregard of the safety instructions or
through improper installation of the LMC 1
invalidates all legal claims against Lincoln
GmbH for any personal injury or damage
to materials.
Exclusion of liability
The manufacturer of the LMC 1 is not liable for damage
caused by
- non-environmentally compatible disposal
- unauthorized modifications to the system parts
- use of spare parts not authorized by Lincoln
- commissioning and start-up in defective condition
- erroneous program selection by the user
General safety instructions
The multi controller LMC 1
- is designed based on state of the art technology
- can be assembled safe-to-operate
Improper use can lead to damage due to under- or
overlubrication of bearings and bearing points.
Independent alterations or modifications to an installed
system may only be carried out after prior consultation
with the manufacturer or its contract partner.
4273a00
WARNING!
Dangerous residual voltages!
Even during a standstill the motor or valve
may be applied with voltage.
Accident prevention rules
Comply with the rules applicable in the country of use.
Do not operate
- using non-authorized spare parts
- with power supplies (VAC/VDC) that do not comply with
the electrical design of the LMC 1
Operation, maintenance and repair
LMC 1 safety devices:
- do not modify them or make them inoperative
- do not remove them from the lubrication system
- reattach them before commissioning or start-up
Mount the LMC 1 between 0.4 and 2.0 m above the
access level with cable glants towards bottom (wall-
mounting).
Keep the LMC 1 multi controller away from heat sources.
Comply with the operating temperature.
Replace a defective LMC 1 in its entirety (see “Spare
parts“ chapter, page 9).
4273a00
CAUTION!
The LMC 1 may only be installed by
qualified personnel that are familiar with
its operating instructions. The connection
(N/L/PE) to the power supply must be
carried out according to VDE 0100 and
VDE 0160. Install a safety device and
interrupt facility to disconnect the LMC 1.
Disconnect the mains connection before
starting installation and service work.
Make sure to provide a safeguard to
prevent unintentional reclosing of the
disconnecting device.
fter completion of wiring, individual cores
must be secured against dislocation.
4273a00
WARNING!
Non-compliance with the safety
instructions, such as contact with
electrically conducting parts with an open
LMC 1 or improper handling the same can
endanger life. The device could overheat
if the technical data specified in the
technical data sheet are exceeded. This
can destroy the LMC 1 and can impair the
electrical safety.
Disposal
Dispose of the LMC 1 in an environmentally friendly way,
according to the relevant and legal regulations.
