Linde AGA AQVIA Bedienungsanleitung
Steel
Exclusive
사용자 설명서/Bedienungsanleitung/Manual del usuario/Manuel de l’utilisateur
AQVIA®sparkling water maker user manual
GB
SE
DK
NO
FI
MyAGA.me
BEST
IN
TEST
FR
GE
ES
UK
한국
112238 -14 0513 - 1.3 HL ® AQVIA is a registered trademark of The Linde Group.
English 4
한국어 12
German 20
Spanish 28
France 36
Content • 목차 • Inhalt • Índice • Table des matières
4
Introduction
Congratulations on your new AQVIA® sparkling water maker. Now you can make delicious,
refreshing carbonated water at home, and even avour it with fruit or natural concentrates
available from our retailers. One AGA carbon dioxide cylinder is enough for about 60 litres
of carbonated water.
Before using the machine for the rst time, you should read through the usage and safety
instructions provided in this manual.
Please note that the guarantee for your sparkling water maker is only valid on condition
that it has been treated with care and in compliance with these safety instructions.
General safety instructions
• Never transport the sparkling water maker with the gas cylinder attached
to the machine. Always make sure that the gas cylinder has been fully
detached before transportation.
• Keep the sparkling water maker out of the reach of children.
• Never place the sparkling water maker close to a source of heat, such as a
hob or a radiator, and keep it out of direct sunlight.
• Only use 425 g gas cylinders and PET bottles that are approved for the
carbonator. Other bottles may seem to t but could reduce the function,
damage the machine or cause a safety risk.
• Never press the gas button before attaching a water bottle.
• Never inject gas into an empty water bottle.
• Never ll a water bottle above the maximum volume mark.
• Never try to use your sparkling water maker when it is broken or damaged,
as doing so can be dangerous.
• If your sparkling water maker breaks or malfunctions, do not try to repair
or open the machine yourself. Contact AGA’s customer service on:
Sweden +46 8 731 15 00
Denmark +45 328 366 00
Norway +47 220 277 60
Finland +358 102 429 002
5
Safety instructions for the gas cylinder
• Never transport the gas cylinder when attached to the sparkling water
maker. Always make sure that the gas cylinder has been fully detached
before transportation.
• Do not store the cylinder close to a source of heat, such as a hob or a
radiator, and keep it out of direct sunlight.
• Keep the cylinder out of the reach of children.
• The gas cylinder must only be used when at room temperature. After
transportation and frequent use, the cylinder can become cold and less
efcient. Avoid touching the cylinder if it is covered in ice.
• We recommend that you only use 425 g gas cylinders from AGA.
• Do not tamper with or otherwise alter the design or shape of the gas cylinder.
• If the gas cylinder breaks or becomes damaged, contact AGA’s customer
service on:
Sweden +46 8 731 15 00
Denmark +45 328 366 00
Norway +47 220 277 60
Finland +358 102 429 002
Safety instructions for the water bottle
• Never ll water bottles with anything other than pure drinking water, and
never carbonate any other uids than water. If other uids are carbonated,
there is a serious danger that the uid will leak into the machine, and that
additives such as sugar will cause the pressure relief valves to stick. If the
relief valves stop working, the machine will not be safe to use.
• Never ll the bottle above the maximum volume mark; if you do, water can
enter the machine and spurt out through the pressure relief valves.
• The water bottles can withstand water temperatures up to 40oC. The bottles
must therefore be washed only in warm water and never in a dishwasher.
• Never freeze the water bottles.
• Never use water bottles that have exceeded their use-by date, as this poses
a safety hazard. Use-by dates are printed on the bottles.
• Never use discoloured, deformed or cracked water bottles.
• To avoid the buildup of bacteria in the bottle, always make sure to rinse it
thoroughly before use.
• Never drink straight from the bottle.
• Only use AQVIA® water bottles.
GB
6
Using the sparkling water maker
Your new sparkling water maker enables you to carbonate your own water, which you
can then avour with concentrates from AQVIA®. To carbonate your own water, you need
the AGA 425 g carbon dioxide gas cylinder. When the cylinder is empty, a replacement
can be bought from the store where you made your original purchase and the old bottle
returned for deposit.
Inserting the gas cylinder
Remove the seal and the protective cap from the cylinder. Keep the cap in a safe place as
it will be needed when you replace the cylinder when empty. Place the sparkling water
maker on a at surface and remove the back section by pressing the button on the back
and pushing the back section rst up and then out.
Screw the cylinder into the machine as far as
it will go (see illustration), at which point the
sparkling water maker will have returned to
its original resting position. Make sure that
the cylinder is rmly in place.
Slide the back section back into its guide
grooves and push it down until the locking
mechanism clicks back into place.
Tilt the sparkling water maker forwards and insert the gas cylinder through the opening
in the bottom of the machine so that the cylinder is standing on the work surface. Gently
tilt the sparkling water maker back so that the upper part of the machine rests against the
threaded neck of the cylinder.
7
Removing the gas cylinder
Place the sparkling water maker on a at surface and remove the back section by pressing
the button on the back and then pushing the back section rst up and then out. Unscrew
the cylinder, at which point the sparkling water maker will tip forwards slightly. Tilt the
sparkling water maker a little further forwards and lift out the cylinder.
Filling the water bottle
Clean the bottle before use. Do not use water
hotter than 40oC. Fill the bottle with cold water
up to the maximum volume mark. If the bottle is
overlled, water can enter the machine and leak
out. For best results, use cold water; the colder
the water, the greater the volume of gas that
can be dissolved. It is therefore a good idea to
store an extra bottle of water in the fridge. Make
sure, however, not to keep the water for too
long in the bottle as it might become stale.
Important! Never carbonate anything other than pure drinking water, as sugar
or other additives might cause the pressure relief valves to stick, rendering the
machine unsafe to use.
GB
8
Attaching the water bottle
Carbonating water
Important! Never carbonate anything other than pure drinking water, as sugar
or other additives might cause the pressure relief valves to stick, rendering the
machine unsafe to use.
The degree of carbonation is a matter of
personal taste, so for the rst few times
you use the machine, you will have to
experiment until you nd the degree
of carbonation that is right for you.
To carbonate the water, press the button
and keep it pressed for 3-4 seconds or
until you hear a hiss as the pressure relief
valve opens. Depending on the water
temperature, this will give you a normal
degree of carbonation.
You can add more gas as desired by
pressing the button again briey once or twice. Release the button and wait until you hear
another hiss as any excess pressure is discharged and the water bottle is vented.
Unscrew the water bottle and enjoy your carbonated water. Store the water in a cool place
with the lid tightly screwed on to prevent the water going at.
Remove the lid from the water bottle. Position
the bottle so that the gas tube protrudes into the
water and then push the bottle up as far as it will
go. Turn the bottle as shown in the illustration
until you feel it engage. Make sure that the water
bottle is rmly in place before use.
9
Removing the water bottle
Grasp the water bottle and turn it as
shown until you feel it disengage.
The bottle has a bayonet tting and
should click slightly as it does so.
Flavour your carbonated water
Flavour your carbonated water with fruit or AQVIA® essences, ciders or sodas.
Please carefully read the instructions on the bottles and pour the right amount
of essence in a glass or a pitcher, and then add the carbonated water.
Emptying the spill tray
Push the back of the strainer down gently so
that it tilts upwards and is easier to remove.
Lift it out and place it to one side. Hold the
spill tray by the handle and bring it diagonally
forwards to remove it. Empty the tray.
Maintenance and cleaning
• To clean your sparkling water maker, wipe it with a damp cloth.
A mild cleaning agent may also be used.
• Clean water bottles in warm water with a mild detergent and rinse well.
Store empty bottles with their lids off.
• Never wash water bottles in a dishwasher. Water bottles can only withstand
a maximum water temperature of 40oC.
• Never use solvents or powerful cleaning agents.
GB
10
Contact AGA
AGA’s customer service: Sweden +46 8 731 15 00
Denmark +45 328 366 00
Norway +47 220 277 60
Finland +358 102 429 002
MyAGA.me
Troubleshooting
Problem Possible cause Remedy
The amount of gas in the
water gradually drops
The gas cylinder is empty Replace the cylinder
The gas cylinder is too
cold
Wait until the cylinder
warms up
The spill tray quickly fills
with water
The water bottle is
overfull
Do not fill bottles above
the maximum volume
mark
The amount of gas in the
water is low but your gas
consumption is high
The washer on the
cylinder holder is missing
or leaking
Change the washer. New
washers can be ordered
from AGA’s customer
service
Inhaltsverzeichnis
Sprachen:
